We demonstrate high baud-rate DQPSK modulation with full-ETDM technique using a novel high-speed optical IQ modulator consisting of a ridge-type optical waveguide structure on a thin LiNbO3 substrate. Our fabrication technique achieves a drastic extension of the modulator's bandwidth and a reduction of half-wave voltage. Demonstration of 90-Gbaud NRZ-DP-DQPSK signal generation with the modulator successfully achieved a bit rate of 360-Gb/s under full-ETDM configuration.

In view of the frequent and complex changes of GNSS visible satellite constellation in attitude determination system, an improved attitude signal simulation algorithm for high dynamic satellite signal simulator is proposed. Based on Software Radio architecture, elevation calculation in the antenna coordinate system and channel state control logic under the condition of carrier attitude changes are introduced into the algorithm to implement synchronous scheduling of visible satellite constellation and attitude signal simulation. This work guarantees the simulator to run constantly and stably for a long time with the advantages of high precision and low complexity. Compared with synchronous positioning results from the receiver, the simulation results show that not only can the output signals of the simulator accurately reflect the carrier's attitude characteristics, but also no step error is generated and the positioning precision is not influenced when visible satellite constellation changes.

We propose an active noise control (ANC) system for reducing periodic noise generated in a high magnetic field such as noise generated from magnetic resonance imaging (MRI) devices (MR noise). The proposed ANC system utilizes optical microphones and piezoelectric loudspeakers, because specific acoustic equipment is required to overcome the high-field problem, and consists of a head-mounted structure to control noise near the user's ears and to compensate for the low output of the piezoelectric loudspeaker. Moreover, internal model control (IMC)-based feedback ANC is employed because the MR noise includes some periodic components and is predictable. Our experimental results demonstrate that the proposed ANC system (head-mounted structure) can significantly reduce MR noise by approximately 30 dB in a high field in an actual MRI room even if the imaging mode changes frequently.

A translucent wavelength switched optical network (WSON) is a cost-efficient infrastructure between opaque networks and transparent optical networks, which aims at seeking a graceful balance between network cost and service provisioning performance. In this paper, we experimentally present a resilient translucent WSON with the control of an enhanced path computation element (PCE) and extended generalized multi-protocol label switching (GMPLS) controllers. An adaptive routing and wavelength assignment scheme with the consideration of accumulated physical impairments, wavelength availabilities and regenerator allocation is experimentally demonstrated and evaluated for dynamic provisioning of lightpaths. By using two different network scenarios, we experimentally verify the feasibility of the proposed solutions in support of translucent WSON, and quantitatively evaluate the path computation latency, network blocking probability and service disruption time during end-to-end lightpath restoration. We also deeply analyze the experimental results and discuss the synchronization between the PCE and the network status. To the best of our knowledge, the most significant progress and contribution of this paper is that, for the first time, all the proposed methodologies in support of PCE/GMPLS controlled translucent WSON, including protocol extensions and related algorithms, are implemented in a network testbed and experimentally evaluated in detail, which allows verifying their feasibility and effectiveness when being potentially deployed into real translucent WSON.

The tag collection algorithm in ISO/IEC 18000-7 has difficulty in collecting data from massive numbers of active RFID tags in a timely manner, so it should be improved to allow successful application in a wide variety of industrial fields. We propose two novel methods, a reduced-message method to improve the performance of data-tag collection and an efficient-sleep method to improve the performance of ID-tag collection. The reduced-message method decreases the slot size for a tag response by reducing the response size from the tag and reduces the number of commands issued from the reader. The efficient-sleep method utilizes redundant empty slots within the frame period to transmit sleep commands to the tags collected previously. We evaluated the performance improvement of tag collection by the proposed methods experimentally using an active RFID reader and 60 tags that we prepared for this study. The experimental results showed that the reduced-message method and the efficient-sleep method decreased the average tag collection time by 16.7% for data-tag collection and 9.3% for ID-tag collection compared with the standard tag collection. We also developed a simulation model for the active RFID system, reflecting the capture effect in wireless communication, and performed simulations to evaluate the proposed methods with a massive number of tags. The simulation results with up to 300 tags confirmed that the proposed methods could improve the tag collection performance, confirming the experimental results, even with larger numbers of tags.

Several task forces have been working on how to design the future Internet in a clean slate manner and mobility management is one of the key issues to be considered. However, mobility management in the future Internet is still being designed in an “all-in-one” way where all management functions are tightly kept at a single location and this results in cost inefficiency that can be an obstruction to constructing flexible systems. In this paper, we propose a new function-distributed mobility management architecture that can enable more flexible future Internet construction. Furthermore, we show the effectiveness of our proposed system via a cost analysis and computer simulation with a random walk mobility model.

To reduce the huge search space when customizing accelerators for the application specific instruction-set processor (ASIP), this paper proposes an automated customization method based on the data flow graph exploration. This method integrates the instruction identification and selection using an iterative improvement strategy, which uses a seed-growth algorithm to select the valid patterns that can bring higher performance enhancement. The search space is reduced by considering the performance factors during the identification stage. The experimental results indicate that the proposed method is feasible enough compared to the previous exhaustive algorithms.

A 10-Gbit/s-class ac-coupled average-detection-type burst-mode receiver (B-Rx) with an ultra fast response and a high tolerance to the long consecutive identical digits has been developed. Key features of the circuit design are the baseline-wander common-mode rejection technique and the inverted distortion technique adopted in the limiting amplifier to cope with both the fast response and the high tolerance. Our B-Rx with newly developed limiting amplifier IC achieved a settling time of less than 150 ns, a sensitivity of -29.8 dBm, and a dynamic range of 23.8 dB with a 231-1 pseudo random bit sequences. Moreover, we also describe several potential B-Rx applications. We achieved better performance by applying the proposed systems to our B-Rx.

This paper firstly analysis the coherent correlation, non-coherent accumulation detector used in weak satellite signal detection mathematically and statistically, and derives its single threshold based on the CFAR (constant false alarm rate). And then the paper improved the detector under the situation of more than one satellite existing with different signal power. Based on this new type of detector, a threshold calculation method is introduced considering the effect of near-far problem in the weak signal detection. Finally the method is verified and compared to the traditional single threshold with simulated data and collected intermediate frequency real data. The results show that this new threshold method can detect signal efficiently with lower false alarm possibility and larger detection possibility.

An optimal selection criterion of the modulation and coding scheme (MCS) for maximizing spectral efficiency is proposed in consideration of the signaling overhead of mobile WiMAX systems with a hybrid automatic repeat request mechanism. A base station informs users about the resource assignments in each frame, and the allocation process generates a substantial signaling overhead, which influences the system throughput. However, the signaling overhead was ignored in previous MCS selection criteria. In this letter, the spectral efficiency is estimated on the basis of the signaling overhead and the number of transmissions. The performance of the proposed MCS selection criterion is evaluated in terms of the spectral efficiency in the mobile WiMAX system, with and without persistent allocation.

In this letter we present efficient iterative frequency domain equalization for single-carrier (SC) transmission systems with insufficient cyclic prefix (CP). Based on minimum mean square error (MMSE) criteria, iterative decision feedback frequency domain equalization (IDF-FDE) combined with cyclic prefix reconstruction (CPR) is derived to mitigate inter-symbol interference (ISI) and inter-carrier interference (ICI). Computer simulation results reveal that the proposed scheme significantly improves the performance of SC systems with insufficient CP compared with previous schemes.

We develop an effective algorithm, based on the filtered backprojection (FBP) approach, for the imaging of vegetation. Under the FBP scheme, the reconstruction amounts at a non-trivial Fourier inversion, since the data are Fourier samples arranged on a non-Cartesian grid. The computational issue is efficiently tackled by Non-Uniform Fast Fourier Transforms (NUFFTs), whose complexity grows asymptotically as that of a standard FFT. Furthermore, significant speed-ups, as compared to fast CPU implementations, are obtained by a parallel versions of the NUFFT algorithm, purposely designed to be run on Graphic Processing Units (GPUs) by using the CUDA language. The performance of the parallel algorithm has been assessed in comparison to a CPU-multicore accelerated, Matlab implementation of the same routine, to other CPU-multicore accelerated implementations based on standard FFT and employing linear, cubic, spline and sinc interpolations and to a different, parallel algorithm exploiting a parallel linear interpolation stage. The proposed approach has resulted the most computationally convenient. Furthermore, an indoor, polarimetric experimental setup is developed, capable to isolate and introduce, one at a time, different non-idealities of a real acquisition, as the sources (wind, rain) of temporal decorrelation. Experimental far-field polarimetric measurements on a thuja plicata (western redcedar) tree point out the performance of the set up algorithm, its robustness against data truncation and temporal decorrelation as well as the possibility of discriminating scatterers with different features within the investigated scene.

Trapping sets have been identified as one of the main factors causing error floors of low-density parity-check (LDPC) codes at high SNR values. By adding several new rows to the original parity-check matrix, a novel method is proposed to eliminate small trapping sets in the LDPC code's Tanner graph. Based on this parity-check matrix extension, we design new codes with low error floors from the original irregular LDPC codes. Simulation results show that the proposed method can lower the error floors of irregular LDPC codes significantly at high SNR values over AWGN channels.

This letter investigates the performance of amplify-and-forward relaying systems using maximum ratio transmission at the source. A closed-form expression for the outage probability and a closed-form lower bound for the average bit error probability of the system are derived. Also, the approximate expressions for the outage probability and average bit error probability in the high signal-to-noise ratio regime are given, based on which the optimal power allocation strategies to minimize the outage probability and average bit error probability are developed. Furthermore, numerical results illustrate that optimizing the allocation of power can improve the system performance, especially in the high signal-to-noise ratio regime.

In an undirected graph, the feedback vertex set (FVS for short) problem is to find a set of vertices of minimum cardinality whose removal makes the graph acyclic. The FVS has applications to several areas such that combinatorial circuit design, synchronous systems, computer systems, VLSI circuits and so on. The FVS problem is known to be NP-hard on general graphs but interesting polynomial solutions have been found for some special classes of graphs. In this paper, we present an O(n2.68 + γn) time algorithm for solving the FVS problem on trapezoid graphs, where γ is the total number of factors included in all maximal cliques.

Orthogonal frequency division multiplexing has emerged as a promising air interface scheme for wireless broadband communications. For OFDM systems, frame synchronization has received much attention in the literature, though simple correlators are still widely used in real systems. In this letter, we present the analytical expression of the optimal frame synchronizer for OFDM systems. Frame synchronization is posed as a maximum a posteriori probability estimation. We show that the resulting frame synchronizer consists of a correlation term and a correction term. The correction term accounts for the random data surrounding a synchronization word. Numerical results show the performance gain of the proposed frame synchronizer over a correlation scheme.

The delay/disruption tolerant network (DTN) has been researched actively in the last years because of its high applicability to ubiquitous network services such as sensor networks and intelligent transport system (ITS) networks. An efficient data forwarding method for those network services is one of the key components in DTN due to the limitation of wireless network resources. This paper proposes a new DTN scheme for vehicle network systems by introducing the parameter, “approach ratio”, which represents node movement history. The proposal utilizes passive copy strategy, where nodes within one hop area of packet forwarders receive, copy and store packets (namely, passive copies) for future forwarding, in order to obtain higher delivery rate and lower delivery delay whilst suppressing the network resource consumption. Depending on its approach ratio, a node with passive copy decides whether it forwards the passive copy or not by referring to the approach ratio threshold. The approach ratio allows our proposal to adjust the property of both single-copy type scheme, that can lower network resource consumption, and multi-copy type scheme, that can enhance the performance of delivery rate and delay time. In simulation evaluation, the proposal is compared with three typical existing schemes with respect to network consumption, delivery rate and delivery delay. Our proposal shows the superior performance regarding the targeted purpose. It is shown that the approach ratio plays the significant role to obtain the higher delivery rate and lower delay time, while keeping network resource consumption lower.

An area efficiency hybrid decoupling scheme is proposed to suppress the charge pump noise during F-N tunneling program in non-volatile memory (NVM). The proposed scheme is focused on suppressing the average noise power in frequency domain aspect, which is more suitable for the program error reduction in NVMs. The concept of active capacitor is utilized. Feed forward effect of the amplifier is firstly considered in the impedance analysis, and a trade-off relation between in-band and out-band frequency noise decoupling performance is shown. A fast optimization based on average noise power is made to achieve minimum error in the F-N tunneling program. Simulation results show very stable output voltage in different load conditions, the average ripple voltage is 17 mV with up to 20 dB noise-suppression-ratio (NSR), and the F-N tunneling program error is less than 5 mV for a 800 µs program pulse. A test chip is also fabricated in 0.18 µm technology. The area overhead of the proposed scheme is 2%. The measurement results show 24.4 mV average ripple voltage compared to 72.3 mV of the conventional one with the same decoupling capacitance size, while the noise power suppression achieves 15.4 dB.

In this paper, we propose a simple but effective way of improving the performance of channel estimation (CE) for pilot cyclic prefixed single carrier (PCP-SC) system. The proposed method utilizes the property that the shifting signal of the PCP pilot signal can also be utilized to estimate the channel information. The receiver can continuously estimate the channel information by just shifting the received pilot signal. Regardless of the signal-to-noise ratio (SNR) and the pilot type, the proposed method can achieve about a 1.72 dB performance gain in terms of the mean squared error (MSE) of channel estimation with a slight increase in computational complexity. The BER performance with the proposed CE improvement are evaluated in a multipath fading channel using a zero-forcing (ZF) equalizer and an minmum mean squared error (MMSE) equalizer by computer simulation. It is shown that the proposed CE improvment method using an MMSE equalizer which has an unbiased vlaue of noise variance (NV) estimator gives a promising BER performance. The proposed method also benefits the estimation of the SNR for the single carrier system.

In optical packet switches, the overhead of reconfiguring a switch fabric is not negligible with respect to the packet transmission time and can adversely affect switch performance. The overhead increases the average waiting time of packets and worsens throughput performance. Therefore, scheduling packets requires additional considerations on the reconfiguration frequency. This work intends to analytically find the optimal reconfiguration frequency that minimizes the average waiting time of packets. It proposes an analytical model to facilitate our analysis on reconfiguration optimization for input-buffered optical packet switches with the reconfiguration overhead. The analytical model is based on a Markovian analysis and is used to study the effects of various network parameters on the average waiting time of packets. Of particular interest is the derivation of closed-form equations that quantify the effects of the reconfiguration frequency on the average waiting time of packets. Quantitative examples are given to show that properly balancing the reconfiguration frequency can significantly reduce the average waiting time of packets. In the case of heavy traffic, the basic round-robin scheduling scheme with the optimal reconfiguration frequency can achieve as much as 30% reduction in the average waiting time of packets, when compared with the basic round-robin scheduling scheme with a fixed reconfiguration frequency.