In this paper, we propose a file replication method to achieve load balancing in terms of write access to storage device ("write storage access load balancing" for short) in unstructured peer-to-peer (P2P) file-sharing networks in which the popularity trend of queried files varies dynamically. The proposed method uses a write storage access ratio as a load balance index value in order to stabilize dynamic P2P file-sharing environments adaptively. In the proposed method, each peer autonomously controls the file replication ratio, which is defined as a probability to create the replica of the file in order to uniform write storage access loads in the similar way to thermal diffusion phenomena. Theoretical analysis results show that the behavior of the proposed method actually has an analogy to a thermal diffusion equation. In addition, simulation results reveal that the proposed method has an ability to realize write storage access load balancing in the dynamic P2P file-sharing environments.

The proportionate normalized least mean square algorithm (PNLMS) greatly improves the convergence of the sparse impulse response. It exploits the shape of the impulse response to decide the proportionate step gain for each coefficient. This is not always suitable. Actually, the proportionate step gain should be determined according to the difference between the current estimate of the coefficient and its optimal value. Based on this idea, an approach is proposed to determine the proportionate step gain. The proposed approach can improve the convergence of proportionate adaptive algorithms after a fast initial period. It even behaves well for the non-sparse impulse response. Simulations verify the effectiveness of the proposed approach.

With the process scaling, the leakage current reduction has been the primary design concerns in a nanometer-era VLSI circuit. In this paper, we propose a new lithography process-aware edge effects correction method to reduce the leakage current in the shallow trench isolation (STI). We construct the various test structures to model Ileakage and Ileakage_fringe which represent the leakage currents at the center and edge of the transistor, respectively. The layout near the active edge is modified using the look-up table generated by the calibrated analytic model. On average, the proposed edge effects correction method reduces the leakage current by 18% with the negligible decrease of the drive current at sub-40nm DRAM device.

Owing to their ultra-wideband characteristics, tapered slot antennas (TSAs) are used as element antennas in wideband phased arrays. However, when the size of a TSA is reduced in order to prevent the generation of a grating lobe during wide-angle beam scanning, the original ultra-wideband characteristics are degraded because of increased reflections from the ends of the tapered slot aperture. To overcome this difficulty, we propose a new antenna structure in which parallel-plate waveguides are added to the TSA. The advantage of this new structure is that the reflection characteristics of individual antenna elements are not degraded even if the width of the antenna aperture is very small, i.e., approximately one-half the wavelength of the highest operating frequency. In this study, we propose a procedure for designing the new antenna through numerical simulations by using the FDTD method. In addition, we verify the performance of the antenna array by experiments.

This paper is in response to the report of Ahn, Mun, Kim, Oh, and Han published in IEICE Trans. INF. & SYST., Vol.E91-D, No.4, 2008, 1215-1217. They tried to extend their previous paper that published on IEICE Trans. INF. & SYST., Vol.E86-D, No.12, 2003, 2790-2793. However, we will point out that their extension is based on the detailed data of knowing the frequency of three types. Their new occurrence information based on intuitionistic fuzzy set for medical diagnosis of headache becomes redundant. We advise researchers to directly use the detailed data to decide the diagnosis of headache.

Chiba et al. (2006) proposed a framework of program transformation of term rewriting systems by developed templates. Contrast to the previous framework of program transformation by templates based on lambda calculus, this framework provides a method to verify the correctness of transformation automatically. Tupling (Bird, 1980) is a well-known technique to eliminate redundant recursive calls for improving efficiency of programs. In Chiba et al.'s framework, however, one can not use tuple symbols to construct developed templates. Thus their framework is not capable of tupling transformations. In this paper, we propose a more flexible notion of templates so that a wider variety of transformations, including tupling transformations, can be handled.

Silicon-quantum-dots (Si-QDs) with an areal density as high as 1012 cm - 2 were self-assembled on thermally-grown SiO2 by low pressure CVD using Si2H6, in which OH-terminated SiO2 surface prior to the Si CVD was exposed to GeH4 to create nucleation sites uniformly. After thermal oxidation of Si-QDs surface, two-dimensional electronic transport through the Si-QDs array was measured with co-planar Al electrodes evaporated on the array surface. Random telegraph signals were clearly observed at constant applied bias conditions in dark condition and under light irradiation at room temperature. The result indicates the charging and discharging of a dot adjacent to the percolation current path in the dots array.

In a society preoccupied with gradual erosion of electronic privacy, loss of privacy in the current Domain Name System is an important issue worth considering. In this paper, we first review the DNS and some security & privacy threats to make average users begin to concern about the significance of privacy preservation in DNS protocols. Then, by an careful survey of four noise query generation based existing privacy protection approaches, we analyze some benefits and limitations of these proposals in terms of both related performance evaluation results and theoretic proofs. Finally, we point out some problems that still exist for research community's continuing efforts in the future.

We propose a character size optimization technique to reduce the number of EB shots of multi-column-cell (MCC) lithographic systems in which transistor patterns are projected with multiple column cells in parallel. Each and every column cell is capable of projecting patterns with character projection (CP) and variable shaped beam (VSB) methods. Seeking the optimal character size of characters contributes to minimizing the number of EB shots and reducing the fabrication cost for ICs. Experimental results show that the character size optimization achieved 70.6% less EB shots in the best case with an available electron beam (EB) size. Our technique also achieved 40.6% less EB shots in the best case than a conventional character sizing technique.

We have studied transmission property of electron in vertical MOSFET (V-MOSFET) from the viewpoint of quantum electro-dynamics. To obtain the intuitive picture of electron transmission property through channel of the V-MOSFET, we solve the time-dependent Schrodinger equation in real space by employing the split operator method. We injected an electron wave packet into the body of the V-MOSFET from the source, and traced the time-development of electron-wave function in the body and drain region. We successfully showed that the electron wave function propagates through the resonant states of the body potential. Our suggested approaches open the quantative and intuitive discussion for the carrier dynamics in the V-MOSFET on quantum limit.

Nowadays, the number of web-browser targeted attacks that lead users to adversaries' web sites and exploit web browser vulnerabilities is increasing, and a clarification of their methods and countermeasures is urgently needed. In this paper, we introduce the design and implementation of a new client honeypot for drive-by-download attacks that has the capacity to detect and investigate a variety of malicious web sites. On the basis of the problems of existing client honeypots, we enumerate the requirements of a client honeypot: 1) detection accuracy and variety, 2) collection variety, 3) performance efficiency, and 4) safety and stability. We improve our system with regard to these requirements. The key features of our developed system are stepwise detection focusing on exploit phases, multiple crawler processing, tracking of malware distribution networks, and malware infection prevention. Our evaluation of our developed system in a laboratory experiment and field experiment indicated that its detection variety and crawling performance are higher than those of existing client honeypots. In addition, our system is able to collect information for countermeasures and is secure and stable for continuous operation. We conclude that our system can investigate malicious web sites comprehensively and support countermeasures.

Mobile devices, such as cellular phones and car navigation systems, are essential to daily life. People acquire necessary information and preferred content over communication networks anywhere, anytime. However, usability issues arise from the simplicity of user interfaces themselves. Thus, a recommendation of content that is adapted to a user's preference and situation will help the user select content. In this paper, we describe a method to realize such a system using Bayesian networks. This user-adapted mobile system is based on a user model that provides recommendation of content (i.e., restaurants, shops, and music that are suitable to the user and situation) and that learns incrementally based on accumulated usage history data. However, sufficient samples are not always guaranteed, since a user model would require combined dependency among users, situations, and contents. Therefore, we propose the LK method for modeling, which complements incomplete and insufficient samples using knowledge data, and CPT incremental learning for adaptation based on a small number of samples. In order to evaluate the methods proposed, we applied them to restaurant recommendations made on car navigation systems. The evaluation results confirmed that our model based on the LK method can be expected to provide better generalization performance than that of the conventional method. Furthermore, our system would require much less operation than current car navigation systems from the beginning of use. Our evaluation results also indicate that learning a user's individual preference through CPT incremental learning would be beneficial to many users, even with only a few samples. As a result, we have developed the technology of a system that becomes more adapted to a user the more it is used.

Esterel is an imperative synchronous language for control-dominant reactive systems. Regardless of imperative features of Esterel, combination of parallel execution and preemption makes it difficult to build control flow graphs (CFGs) of Esterel programs. Simple and convenient CFGs can help to analyze Esterel programs. However, previous researches are not suitable for flow analyses of imperative languages. In this work, we present a method to construct over-approximated CFGs for Pure Esterel. Generated CFGs expose invisible interferences among threads and show program structures explicitly so that they are useful for program analyses based on graph theory or control-/data- flows.

Object detection and tracking is one of the most important research topics in pattern recognition and the basis of many computer vision systems. Many accomplishments in this field have been achieved recently. Some specific objects, such as human face and vehicles, can already be detected in various applications. However, tracking objects with large variances in color, texture and local shape (such as pedestrians) is still a challenging topic in this field. To solve this problem, a pedestrian tracking scheme is proposed in this paper, including online training for pedestrian-detector. Simulation and analysis of the results shows that, the proposal method could deal with illumination change, pose change and occlusion problem and any combination thereof.

In this paper, we propose a robust room inverse filtering algorithm for speech dereverberation based on a kurtosis maximization. The proposed algorithm utilizes a new normalized kurtosis function that nonlinearly maps the input kurtosis onto a finite range from zero to one, which results in a kurtosis warping. Due to the kurtosis warping, the proposed algorithm provides more stable convergence and, in turn, better performance than the conventional algorithm. Experimental results are presented to confirm the robustness of the proposed algorithm.

The downscaling of CMOS technology has resulted in strong improvement in RF performance of bulk and SOI MOSFETs. In order to realize a low-noise RF circuit, a deeper understanding of the noise performance for MOSFETs is required. Thermal noise is the main noise source of the CMOS device for high frequency performance, and is dominated by the drain channel noise, induced gate noise, and their correlation noise. In this work, we measured the RF noise parameter (Fmin, Rn, Γ opt) of 45 nm node MOSFETs from 5 to 15 GHz and extracted noise sources and noise coefficients P, R, and C by using an extended van der Ziel's model. We found, for the first time, that correlation coefficient C decreases from positive to negative values when the gate length is reduced continuously with the gate length of sub-100 nm. We confirmed that Pucel's noise figure model, using noise coefficients P, R, and C, can be considered a good approximation even for sub-50 nm MOSFETs. We also discussed a scaling effect of the noise coefficients, especially the correlation noise coefficient C on the minimum noise figure.

Hierarchical constellations offer a different property of robustness to the multiple bits that construct a symbol according to channel errors. We apply the characteristics of hierarchical constellations to a multi-user cellular system that has limited modulation levels, in order to improve cell capacity. We propose an adaptive resource allocation scheme based on the hierarchical constellation in which a symbol is shared by multiple users and each bit in a symbol is allocated adaptively according to the channel condition of each user. The numerical results show that the proposed resource allocation scheme provides mobile users with higher modulation levels so that the cell capacity is improved.

An on-chip Charged Device Model (CDM) ESD protection method for RF ICs is proposed in a 0.13 µm RF process and evaluated by using very fast Transmission Line Pulse (vf-TLP) system. Key design parameters such as triggering voltage (Vt1) and the oxide breakdown voltage from the vf-TLP measurement are used to design input ESD protection circuits for a RF test chip. The characterization and the behavior of a Low Voltage Triggered Silicon Controlled Rectifier (SCR) which used for ESD protection clamp under vf-TLP measurements are also reported. The results measured by vf-TLP system showed that the triggering voltage decreased and the second breakdown current increased in comparison with the results measured by a standard 100 ns TLP system. From the HBM/ CDM testing, the RF test chip successfully met the requested RF ESD withstand level, HBM 1 kV, MM 100 V and CDM 500 V.

ISO/IEC 18000-7 Active RFID standard, a single channel system operating at 433 MHz, faces technical difficulties in supporting some recently introduced application demands because of its low transmission rates and vulnerability to radio interference between the readers. We propose a new multi-channel active RFID system operating at the 2.4 GHz band. The special feature of the proposed system is that a reader makes use of multiple interfaces to improve its performance. However, if only a small part of the interfaces is actually used, the performance improvement would not meet expectations. To overcome this problem, a multi-channel multi-interface active RFID protocol that balances the loads among all available interfaces is necessary. Three protocols, "Aggregated," "LP-Combined" and "AP-Balanced" are proposed in this paper. We carry out simulations to compare them under various conditions by changing numbers of tags, numbers of interfaces and tag data size. The AP-Balanced shows the best and the most stable performance and its performance increases almost linearly in proportion to the number of interfaces, which meets our expectation.

A dependency structure interprets modification relationships between words or phrases and is recognized as an important element in semantic information analysis. With the conventional approaches for extracting this dependency structure, it is assumed that the complete sentence is known before the analysis starts. For spontaneous speech data, however, this assumption is not necessarily correct since sentence boundaries are not marked in the data. Although sentence boundaries can be detected before dependency analysis, this cascaded implementation is not suitable for online processing since it delays the responses of the application. To solve these problems, we proposed a sequential dependency analysis (SDA) method for online spontaneous speech processing, which enabled us to analyze incomplete sentences sequentially and detect sentence boundaries simultaneously. In this paper, we propose an improved SDA integrating a labeling-based sentence boundary detection (SntBD) technique based on Conditional Random Fields (CRFs). In the new method, we use CRF for soft decision of sentence boundaries and combine it with SDA to retain its online framework. Since CRF-based SntBD yields better estimates of sentence boundaries, SDA can provide better results in which the dependency structure and sentence boundaries are consistent. Experimental results using spontaneous lecture speech from the Corpus of Spontaneous Japanese show that our improved SDA outperforms the original SDA with SntBD accuracy providing better dependency analysis results.