In this article we propose a new framework to support QoS and 4G enabled mobility management. The key feature of this framework is twofold; the Policy based Handover control, and the adaptive handover mechanisms. On one hand, the adaptive handover mechanism will allow the selection of different handover schemes based on the user service level specification in order to differentiate the handover quality provided for the required service level, thus optimizing the network resources usage and providing the agreed service level to users. On the other hand, the proposed handover control mechanism considers resource availability and other constraints during the handover decision in order to provide support for QoS aware mobility on the contrary of the classical naïve mobility management that considers only signal strength fading. This decision mechanism will provide mainly the interaction between the mobility and QoS management frameworks but also a 4G handover control. In addition, the QoS aware handover will provide the knowledge necessary to achieve a proactive handover's procedures control.

In order to achieve a transponder antenna for intersection collision avoidance systems in Intelligent Transport Systems, a lens horn antenna that generates a cosecant squared beam is developed. This paper clarifies the method for designing the antenna to achieve accurate radiation pattern synthesis. A H-plane sectral horn is selected. The ray tracing method is employed in the design of the lens shape. The aperture of the horn is determined to be seven wavelengths based on a comparison of calculated radiation patterns and the desired cosecant squared beam shape. Accurate electrical performance, such as radiation patterns and electrical fields in the horn, is calculated using Finite Difference Time Domain software. Electrical field disturbances caused by reflected waves at the lens surfaces expanded widely inside the small horn. As a result, sidelobe levels of the radiation patterns are increased. In order to eliminate these disturbances, matching layers are attached to the shaped lens surface. Then, electrical field distributions in the horn are recovered and disturbances disappear. Measured radiation patterns become almost the same as that designed using the ray tracing method. The results show that application of the ray tracing method to radiation pattern synthesis of a small lens horn antenna is effective. We clarify the electrical field disturbances caused by reflections at the lens surfaces and show that eliminating the reflection at the lens surface by attaching matching layers is very important to achieving radiation pattern synthesis.

A high permittivity LSE-NRD guide was applied to a planar antenna at 60 GHz. Emphasis was placed on compatibility between the high permittivity LSE-NRD guide and the conventionally used low permittivity LSM-NRD guide. Performance of the transition between two such types of NRD guides was optimized by using an electromagnetic simulator and the validity was experimentally demonstrated. A simple radiator, consisting of a tapered high permittivity LSE-NRD guide was fabricated and evaluated as to radiation characteristics. Since the radiator has a broad radiation pattern, it was employed in a primary radiator of a two-dimensional parabolic reflector to develop a new type of folded planar antenna at 60 GHz. This planar antenna has a double-layered structure. In the upper layer, a metalized dielectric substrate with a slotted array is excited by a rectangular-shaped oversized waveguide, and in the lower layer, an offset parabolic reflector is fed by the radiator. Measurement showed the half-power beam width of the fabricated antenna to be 2.5 degrees in the E and H planes, respectively, and the gain to be 35.3 dBi, thus indicating that a good pencil beam antenna was successfully developed in this manner.

An empirical formula of resonant frequency of bow-tie microstrip antennas is presented, which is based on the cavity model of microstrip patch antennas. A procedure to design a bow-tie antenna using genetic algorithm (GA) in which we take the formula as a fitness function is also given. An optimized bow-tie antenna by genetic algorithm was constructed and measured. Numerical and experimental results are used to validate the formula and GA. The results are in good agreement.

We present mutually pulse-coupled two relaxation oscillators having refractoriness. The system can be implemented by a simple electrical circuit, and various periodic synchronization phenomena can be observed experimentally. The phenomena are characterized by a ratio of phase locking. Using a return map having a trapping window, the ratio can be analyzed in a parameter subspace rigorously. We then clarify effects of the refractoriness on the pulse coding ability of the system.

Intensity-noise characteristics of stable multi-mode Fabry-Perot semiconductor lasers are analyzed experimentally and theoretically. Mode-partition noise caused by optical filtering and propagation through optical fibers is investigated by evaluating the relative intensity noise and signal-to-noise ratio. The experimental results indicate that the simplified two-mode analysis provides a good approximation. Suppression of the mode-partition noise by nonlinear gain is experimentally confirmed.

A digital/analog hybrid system is presented which implements the cardinal polynomial spline interpolation of arbitrary degree. Based on the fact that the (m-1)st derivative of a spline of degree m-1 is a staircase function, this system generates a cardinal spline of degree m-1 by m-1 cascaded integrators with a staircase function input. A given sequence of sampled values are transformed by a digital filter into coefficients for the B-spline representation of the spline interpolating the sampled values. The values of its (m-1)st derivative with respect to time are computed by the recurrence formula interpreting differentiation of the spline as difference of the coefficients. Then a digital-to-analog converter generates a staircase function representing the (m-1)st derivative, which is integrated by a cascade of m-1 analog integrators to make the expected spline. In order to cope with the offset errors involved in the integrators, a dynamical sampled-data control is attached. An analog-to-digital converter is employed to sample the output of the cascaded integrators. Target state of the cascaded integrators at each sampling instance is computed from the coefficients for the B-spline representation. The state error between the target and the estimated is compensated by feeding back a weighted sum of the state error to the staircase input.

This paper proposes two types of network architectures using UMTS Release 5 architecture and wireless LAN suitable for context-aware information delivery and personal communication services, and it reports on preliminary evaluations of their performance. The first type of network architecture is the NCA (network-centric architecture) and the second is the ECA (end-user-centric architecture). The two architectures are modeled with a queuing network and their response times are compared through theoretical analysis and simulation. The results indicate that with low-performance servers, the response times of the ECA are generally shorter or almost the same as those of the NCA. However with high-performance servers, the response times of the NCA are generally shorter except during high server utilization.

We propose a new end-to-end transport protocol called Multi-path Transmission Control Protocol (M/TCP) and its two robust acknowledgement (ACK) schemes. Our protocol is designed as an alternative TCP option to improve reliability and performance of the Internet. The M/TCP sender simultaneously transmits data via multiple controlled paths to the receiver. Our protocol requires no modification in IP layer. Two M/TCP endpoints establish multiple paths between them by subscribing to multiple ISPs. The two robust ACK schemes proposed in this paper aim at improving M/TCP performance over the Internet with high packet loss in ACK channels. Performances between our protocol and TCP Reno are compared in terms of throughput and fairness by using ns2 simulator. Simulation results indicate that M/TCP achieves higher throughput than TCP Reno in situation of random drop and burst traffic with small buffer size. When there is network congestion on reverse path, M/TCP with the proposed robust ACK schemes performs better than M/TCP with the conventional immediate ACK scheme.

The single path routing protocol, known as the Ad Hoc On-demand Distance Vector, has been widely studied for use in mobile ad hoc networks. AODV requires a new route discovery whenever a path breaks. Such frequent route discoveries cause a delay due to route discovery latency. To avoid such inefficiency, a multipath routing protocol has been proposed that attempts to find link-disjoint paths in a route discovery. However, when there are two or more common intermediate nodes on the path, the protocol can not find a pair of link-disjoint paths even if the paths actually exist. To reduce this route discovery latency, it is necessary to increase the opportunities for finding a pair of link-disjoint paths. In this paper, we focus on AODV and propose an AODV-based new multipath routing protocol for mobile ad hoc networks. The proposed routing protocol uses a new method to find a pair of link-disjoint paths by selecting a route having a small number of common intermediate nodes on its path. Using simulation models, we evaluate the proposed routing protocol and compare it with AODV and the existing multipath routing protocol. Results show that the proposed routing protocol achieves better performance in terms of delay than other protocols because it increases the number of cases where a pair of link-disjoint paths can be established.

In this paper, we propose a new method which makes transient simulation faster for the circuit including both nonlinear and linear elements. First, the method for generating the projection matrix with Krylov-subspace technique is described. The order of the circuit equation is reduced by congruence transformation with the projection matrix. Next, we suggest a method which can calculate the reduced Jacobian matrix directly in each Newton-Raphson iteration. Since this technique does not need to calculate the original size of Jacobian matrix, the calculation cost is reduced drastically. Therefore, efficient circuit simulation can be achieved. Finally, our method is applied to some example circuits and the validity of the nonlinear circuit reduction technique is verified.

An output load VSWR (voltage standing wave ratio) protection circuit for SiGe power amplifiers (PA) is presented by using the relatively low collector-emitter avalanche breakdown characteristic of SiGe HBT. Unlike the conventional diode-type switch, the new protection circuit completely eliminates the undesirable dc leakage current during the normal operation of the PA. Simulations and measurements show the proposed protection circuit enhances the ruggedness of the PA at harsh operating condition while it imposes only minor performance degradation at normal operating condition.

The hardware implementation of a neural network model using stochastic logic has been able to integrate numerous neuron units on a chip. However, the limitation of applications occurred since the stochastic neurosystem could execute only discrete-time dynamics. We have contrived a neuron model with continuous-time dynamics by using stochastic calculations. In this paper, we propose the circuit design of a new neuron circuit, and show the fabricated neurochip comprising 64 neurons with experimental results. Furthermore, a new asynchronous updating method and a new activation function circuit are proposed. These improvements enhance the performance of the neurochip greatly.

Let us introduce n ( 2) nonlinear mappings fi (i = 1,2,,n) defined on complete linear metric spaces (Xi-1,ρ) (i = 1,2,,n), respectively, and let fi:Xi-1 Xi be completely continuous on bounded convex closed subsets Xi-1, (i = 1,2,,n 0), such that fi() . Moreover, let us introduce n fuzzy-set-valued nonlinear mappings Fi:Xi-1Xi {a family of all non-empty closed compact fuzzy subsets of Xi}. Here, by introducing arbitrary constant βi (0,1], for every integer i (i = 1,2,,n 0), separately, we have a fixed point theorem on the recurrent system of βi -level fuzzy-set-valued mapping equations: xi Fiβi(xi-1, fi(xi-1)), (i = 1,2,,n 0), where the fuzzy set Fi is characterized by a membership function µFi(xi):Xi [0,1], and the βi -level set Fiβi of the fuzzy set Fi is defined as Fiβi {ξi Xi |µFi (ξi) βi}, for any constant βi (0,1]. This theorem can be applied immediately to discussion for characteristics of ring nonlinear network systems disturbed by undesirable uncertain fluctuations and to extremely fine estimation of available behaviors of those disturbed systems. In this paper, its mathematical situation and proof are discussed, in detail.

In this letter, we show the effects of the chip waveform selection on the detection performance of the energy detector in DS/SS communications. Three chip waveforms such as rectangular, half-sine and raised-cosine are examined as the DS/SS chip waveform. It is demonstrated that the partial-band detection can enhance the detection performance of the energy detector approximately 50-70% compared with the full-band detection. When the chip rate is identical, the raised-cosine waveform shows lower detection probability due to its wider spreading bandwidth. However, when the spreading bandwidth is identical, the rectangular waveform shows lower detection probability due to its lower partial-band energy factor.

This study investigates nonlinear reliable output tracking control issues. Both passive and active reliable control laws are proposed using Variable Structure Control technique. These reliable laws need not the solution of Hamilton-Jacobi (HJ) equation or inequality, which are essential for optimal approaches such as LQR and H reliable designs. As a matter of fact, this approach is able to relax the computational burden for solving the HJ equation. The proposed reliable designs are also applied to a bank-to-turn missile system to illustrate their benefits.

An image NRD guide-fed dielectric rod antenna, which is suitable for use at millimeter-wave frequencies, is presented in this paper. The antenna is composed of a linearly tapered dielectric rod connected to the image NRD guide. First, radiation characteristics of the dielectric rod antenna directly protruded from the end of the image NRD guide are investigated by FDTD analysis and measurements at 30 GHz band. For this case, the degradation of the radiation pattern and the decrease of the gain, which are due to the strong radiation from the guide-to-antenna discontinuity, are observed. In order to minimize this radiation and to realize reasonable radiation characteristics, a transition from the image NRD guide-to-rod antenna is proposed. A simple procedure to determine the optimum dimensions of the transition is described. This procedure is based on parametric study of the transition's dimensions, and is performed using FDTD analysis. Based on the results, the dielectric rod antenna having a length of 10 λ0 is designed, and its performance is analyzed and measured. The results show that radiation patterns with the half power beamwidth of 22, sidelobe level of -21 dB and reasonable gain of 18.5 dBi can be realized by employing the transition having the optimum dimensions.

This paper discusses stability boundaries in an electric power system with dc transmission based on a differential-algebraic equation (DAE) system. The DAE system is derived to analyze transient stability of the ac/dc power system: the differential equation represents the dynamics of the generator and the dc transmission, and the algebraic equation the active and reactive power relationship between the ac system and the dc transmission. In this paper complete characterization of stability boundaries of stable equilibrium points in the DAE system is derived based on an energy function for the associated singularly perturbed (SP) system. The obtained result completely describes global structures of the stability boundaries in solution space of the DAE system. In addition the characterization is confirmed via several numerical results with a stability boundary.

Since most process systems have nonlinearities, it is necessary to consider the design of schemes to deal with such systems. In this paper, a new design scheme of PID controllers is proposed. This scheme is designed based on the internal model control (IMC) which is a kind of the model driven controllers. The internal model consists of the design-oriented model and the full model. The full model is designed by using the neural network. The primary PID control system is firstly constructed for the augmented system which is composed of the controlled object and the internal model, and this control system is designed by the pole-assignment method. Furthermore, the secondary PID controller is designed in order to remove the steady state error. Finally, the effectiveness of the newly proposed control scheme is numerically evaluated on a simulation example.

The transformation of a data set using a second-order polynomial mapping to find statistically independent components is considered (quadratic independent component analysis or ICA). Based on overdetermined linear ICA, an algorithm together with separability conditions are given via linearization reduction. The linearization is achieved using a higher dimensional embedding defined by the linear parametrization of the monomials, which can also be applied for higher-order polynomials. The paper finishes with simulations for artificial data and natural images.