In this paper, some misconceptions about "multipath propagation" are discussed for those propagation engineers, who are not familiar with the close relationship between multipath propagation and a communication system in a mobile/portable radio communication environment. It is shown that believed facts about multipath propagation are not always true. Namely, it is well-known that multipath propagation is undesirable if a conventional sample-and-decision receiver is assumed. It is not well-recognized that it can be a desirable phenomenon if a sophisticated communication system uses adaptive equalization, anti-multipath modulation, or spread spectrum communication, for example. On the other hand, it is widely accepted that root mean square (rms) multipath delay spread is a good measure of bit-error-rate performance, i.e., as rms delay spread gets larger, bit-error-rate generally gets worse. However, it is pointed out that this is not always true, especially in propagation conditions with very long-delayed multipath signals. In short, it is the purpose of this paper to show examples that the facts believed to be true sometimes turn out to be false, unless we pay attention to both aspects of propagation and system design in the field of mobile/portable radio communications. In fact, for highly efficient communication systems design, propagation, antenna and system factors should be taken into account simultaneously.

In this paper, we study the performance of convolutional coding using an error-and-erasure correction Viterbi decoder for π/4-shift QDPSK mobile radio transmission. The receiver uses received signal envelope as channel state information to erase unreliable symbols instead of making explicit decision before decoding. The performance study is carried out over frequency-selective fading channel with additive white Gaussian noise, co-channel interference and propagation delay spread. The results show that decoding with symbol erasure can significantly improve the system transmission performance compared to decoding without symbol erasure.

We propose a direct-sequence spread-spectrum multi-access (DS/SSMA) receiver that incorporates multipath diversity combining and multistage co-channel interference (CCI) cancellation. This receiver structure which is more resistant to the near/far problem essentially removes more and more of the CCI with each successive cancellation stage. With the assumption that perfect channel estimates have been obtained, we analyze the bit error rate (BER) performance of this system when received powers are unequal. Results show that the BER can approach that of a single-user case as the number of CCI cancellation stages increases.

An optimal algorithm for decomposing a special type of the Hasse diagram into a minimum set of disjoint paths is described. It is useful for testing the consistency of functional dependencies.

This letter describes the concepts that the learnability of multilayer neural networks exists in a constrained hypersurface in learning space which is formed by input and output subspace of multilayer neural networks, and that a priori information, providing constraints on the learning space, is required for generalization.

This paper discusses the conversion of spatial resolution (pixel density) and amplitude resolution (levels of brightness) for multilevel images. A source image is sampled by an image scanner or a video camera, and a converted image is printed by a printer with the capability of higher spatial but lower amplitude resolution than the image input device. In the proposed method, the impulse response of the scanner sensor is modeled to obtain pixel values from the convolution of the impulse and the image signal. Discontinuous areas (edge) of the original image are detected locally according to the impulse model and neighbouring pixel values. The edge route is estimated which gives the pixel values for the output resolutions. Comparison of the proposed method with two conventional methods, reciprocal distance weight interpolation and pixel replication, shows higher edge quality for the proposed method.

The robust finite settling time stabilization problem is considered for a multivariable discrete time plant with structured uncertainties. Finite settling time (FST) stability of a feedback system is a notion introduced recently for discrete time systems as a generalization of the dead-beat response. The uncertain plant treated in this paper is described by (E0+ΣKi=1qiEi)x(t+1)(A0+ΣKi=1qiAi)x(t)+(B0+ΣKi=1qiBi)u(t), and y(t)=(C0+ΣKi=1qiCi)x(t) where Ei, Ai, Bi and Ci (0iK) are prescribed real matrices and qi (1iK) are uncertain parameters restricted to prescribed intervals [qi, i]. It is shown in this paper that a controller robustly FST stabilizes such an uncertain plant, if, the uncertain plant satisfies some conditions, and the controller simultaneously FST stabilizes a finite set of plants. The result leads to a testable necessary and sufficient condition of the existence of a solution to the robust FST stabilization problem, and a systematic method of designing a robust FST stable feedback system, in the case where the plant contains only one uncertain parameter.

This paper reviews the application of optical technologies to phased array antennas. The performance of the fibre transmission medium and of sources and detectors is reviewed, leading to simple expressions for transmission loss and noise performance. Both coherent and non-coherent beam forming techniques are considered. Future trends, including the use of optical amplifiers and coherent signal generation, will also be discussed.

Theoretical and experimental evaluations of the horizontal rotating and tilting of the base station antenna beam show that these techniques are effective in reducing delay spread. Result show good agreement between predicted and measured values.

Reduction in the illumination wavelength for exposure leads to higher resolution while keeping the depth of focus. Thus, KrF excimer laser lithography has been positioned as the next generation lithography tool behind g/i-line optical lithography, and many studies have been investigated. In the early days, the excimer laser lithography had many inherent problems, such as inadequate reliability, difficult maintainability, high operating cost, and low resolution and sensitivity of resist materials. However, the performance of the excimer laser stepper has been improved and chemical amplification resists have been developed for the past decade. At present, KrF excimer lithography has reached the level of trial manufacturing of lower submicron ULSI devices beyond 64 Mbit DRAMs.

In 1990, Menezes, Okamoto and Vanstone proposed a method that reduces EDLP to DLP, which gave an impact on the security of cryptosystems based on EDLP. But this reducing is valid only when Weil pairing can be defined over the m-torsion group which includes the base point of EDLP. If an elliptic curve is ordinary, there exists EDLP to which we cannot apply the reducing. In this paper, we investigate the condition for which this reducing is invalid.

This paper describes the linguistic procedure of our speech dialogue system. The procedure is composed of two processes, syntactic analysis using a finite state network, and discourse analysis using a plan recognition model. The finite state network is compiled from regular grammar. The regular grammar is described in order to accept sentences with various styles, for example ellipsis and inversion. The regular grammar is automatically generated from the skeleton of the grammar. The discourse analysis module understands the utterance, generates the next question for users and also predicts words which will be in the next utterance. For an extension number guidance task, we obtained correct recognition results for 93% of input sentences without word prediction and for 98% if prediction results include proper words.

Optical fiber transmission systems have advanced rapidly with the advent of highly advanced electronic and optical devices. This paper introduces several IC technologies required for ultra-high-speed optical transmission and overviews current IC technologies used for the existing and developing optical fiber trunk transmission systems. Future trends in device technologies are also discussed.

This paper presents a new concept in cryptography called the sibling intractable function family (SIFF) which has the property that given a set of initial strings colliding with one another, it is computationally infeasible to find another string that would collide with the initial strings. The various concepts behind SIFF are presented together with a construction of SIFF from any one-way function. Applications of SIFF to many practical problems are also discussed. These include the hierarchical access control problem which is a long-standing open problem induced by a paper of Akl and Taylor about ten years ago, the shared mail box problem, access control in distributed systems and the multiple message authentication problem.

In this paper, we investigate the round complexity of zero-knowledge interactive proof systems of possession of knowledge, and mainly show that if a relation R has a three move blackbox simulation zero-knowledge interactive proof system of possession of knowledge, then there exists a probabilistic polynomial time algorithm that on input x{0,1}*, outputs y such that (x,y)R with overwhelming probability if xdom R, and outputs "" with probability 1 if x dom R. The result above can not be generalized to zero-knowledge interactive proof systems of possession of knowledge with more than four moves, because it is known that there exists a "four" move blackbox simulation perfect zero-knowledge interactive proof system of possession of knowledge for a nontrivial relation R.

Fabrication of 0.2 to 0.3 µm features is vital for future ultralarge scale integration devices. An area of particular concern is whether optical lithography can delineate such feature sizes, i.e., less than the exposure wavelength. The use of a phase shift mask is one of the most effective means of improving resolution in optical lithography. This technology basically makes use of the interference between light transmitting through adjacent apertures of the mask. Various types of phase shift masks and their imaging characteristics are discussed and compared with conventional normal transmission masks. To apply these masks effectively to practical patterns, a phase shifter pattern design tool and mask repair method must be established. The phase shifting technology offers a potential to fabricate 0.3 µm features by using the current i-line stepper, and 0.2 µm features by using excimer laser stepper.

Breakdown fields and the charges to breakdown (QBD) of oxides increased after UV/Cl2 pre-oxidation cleaning. This is due to decreased residual metal contaminants on silicon surfaces in the bottom of the LOCOS region after wet cleaning. Treatment in NH4OH, H2O2 and H2O prior to UV/Cl2 cleaning suppressed increases in surface roughness and kept leakage currents through the oxides after UV/Cl2 cleaning as low as those after wet cleaning alone. The large junction leakage currents--caused by metal contaminants introduced during dry etching--decreased after UV/Cl2 cleaning which removes the contaminated layer.

A new direct projection patterning technique of aluminum using synchrotron radiation (SR) is proposed. It is based on the thermal reaction control effect of SR excitation. In the case of the Si surface, pure thermal growth is possible at 200, however, this growth is suppressed perfectly by SR irradiation. On the other hand, Al growth on the SiO2 surface is impossible at the same temperature thermally, however, SR has an effect to initiate thermal reaction. Both new effects of SR, suppression and initiation, are clarified to be caused by atomic order level thin layers formed from CVD gases by SR excitation on the surfaces. By using these effects, the direct inverse and normal projection patterning of Al are successfully demonstrated.

Theoretical and actual experimental investigations are made on a Loop Antenna System (LAS) consisting of N-gap loop antennas. A general formula for the LAS response to an external EM field is derived by using both the method of moments and techniques for transmission-line analysis. Numerical evaluation verifies that the LAS has favorable characteristics, such as invariable response within a wide frequency range. In addition, differences between the LAS method and the present open-field method in the results of measurement are evaluated. It should be noted that the LAS gives a much lower output for an electrical source than for a magnetic source, even if both sources produce the same value with the open-field method. It is concluded that conversion factors for the results from the LAS method to the open-field method strongly depend on the orientation of the source as well as its characteristics. Consequently, new conversion factors are proposed to obtain practical EMI measurements.

We propose two types of key management systems that use complementary exponential calculation, in which users in the system divide into groups, and the different modulus numbers are assigned to each group and edges between groups. Key generation information over the modulus numbers is issued to a user by a trusted center. The user who receives the information can generate shared encryption keys between users in the system without using key exchange protocol. In our proposed system, the number of primes is one of the parameters for generating key generation information. The number decreases in inverse proportion to the square of the number of groups compared to the original method. Our proposed technique enabled us to extend the number of users in the system to more than one million, which is not possible with the original method.