We newly propose the first lateral mode selective active multimode interferometer laser diode. The design principle is to arrange identical propagation path of different lateral mode. Thanks to multimode waveguide structure, 0th mode and 1st order mode has individual propagation path within one device. Individual lasing of fundamental mode as well as first mode was confirmed successfully.

In this paper, we propose a design method of compact multi-way Wilkinson power divider with a multiband operation for size reduction and band broadening. The proposed divider consists of multisection LC-ladder circuits in the division arms and isolation circuits between the output ports. To validate design procedures, we fabricated a trial divider at VHF band. The circuit layout of the trial divider was decided by using an electromagnetic simulator (Sonnet EM). Because the proposed divider consists of lumped element circuits, we can realize great miniaturization of a circuit area compared to that of the conventional Wilkinson power divider. The circuit size of the trial divider is 35 mm square. The measurement results for the trial divider by using a vector network analyzer indicates a relative bandwidth of about 60% under -17 dB reflection, flat power division within ±0.1 dB, and very low phase imbalances under 1.0 degree over the wide frequency range.

This paper presents an application of low-coherence interferometry for measurement of mode field diameters (MFDs) of a few-mode fiber and shows its performance compared with another method using a mode multiplexer. We found that the presented method could measure MFDs in a few-mode fiber even without any special mode multiplexers.

Research efforts initiated by the EXAT Initiative are described to realize Exabit/s optical communications, utilizing the 3M technologies, i.e. multi-core fiber, multi-mode control and multi-level modulation.

The IEEE 802.11 wireless local area network (WLAN) is the most widely deployed communication standard in the world. Currently, the IEEE 802.11ax draft standard is one of the most advanced and promising among future wireless network standards. However, the suggested uplink-OFDMA (UL-OFDMA) random access method, based on trigger frame-random access (TF-R) from task group ax (TGax), does not yet show satisfying system performance. To enhance the UL-OFDMA capability of the IEEE 802.11ax draft standard, we propose a centralized contention-based MAC (CC-MAC) and describe its detailed operation. In this paper, we analyze the performance of CC-MAC by solving the Markov chain model and evaluating BSS throughput compared to other methods, such as DCF and TF-R, by computer simulation. Our results show that CC-MAC is a scalable and efficient scheme for improving the system performance in a UL-OFDMA random access situation in IEEE 802.11ax.

To drastically increase the splitting ratio of extended-reach (40km span) time- and wavelength-division multiplexed passive optical networks (WDM/TDM-PONs), we modify the gain control scheme of our automatic gain controlled semiconductor optical amplifiers (AGC-SOAs) that were developed to support upstream transmission in long-reach systems. While the original AGC-SOAs are located outside the central office (CO) as repeaters, the new AGC-SOAs are located inside the CO and connected to each branch of an optical splitter in the CO. This arrangement has the potential to greatly reduce the costs of CO-sited equipment as they are shared by many more users if the new gain control scheme works properly even when the input optical powers are low. We develop a prototype and experimentally confirm its effectiveness in increasing the splitting ratio of extended-reach systems to 512.

In OFDM systems, link performance depends heavily on the estimation of symbol-timing and frequency offsets. Performance sensitivity to these estimates is a major drawback of OFDM systems. Timing errors destroy the orthogonality of OFDM signals and lead to inter-symbol interference (ISI) and inter-carrier interference (ICI). The interference due to timing errors can be exploited as a metric for symbol-timing synchronization. In this paper, we propose a novel method to extract interference components using a DFT of the upsampled OFDM signals. Mathematical analysis and formulation are given for the dependence of interference on timing errors. From a numerical analysis, the proposed interference estimation shows robustness against channel dispersion.

This letter proposes a class of polyphase zero correlation zone (ZCZ) sequence sets with low inter-set cross-correlation property. The proposed ZCZ sequence sets are constructed from DFT matrices and r-coincidence sequences. Each ZCZ sequence set is optimal, and the absolute value of the cross-correlation function of sequences from different sets is less than or equal to $rsqrt{N}$, where N denotes the length of each sequence. These ZCZ sequence sets are suitable for multiuser environments.

High Efficiency Video Coding is a new video coding standard after H.264/AVC. By introducing a flexible coding unit, which can be recursively divided from 64×64 to 8×8 blocks in a Quadtree-Structure, HEVC achieves significantly higher coding efficiency than the previous standards. With the flexible CU structure, HEVC can effectively adapt to highly varying contents with a smaller CU or to flat contents with a larger CU, making it suitable for applications from mobile video to super high definition television. On the other hand, CU division does incur high computational cost for HEVC. In this paper, we propose a simple and fast CU division algorithm by using only a subset of pixels to determine when CU division happens. Experiment results show that our algorithm can achieve prediction quality close to HEVC Test Model with much lower computational cost.

Improvement of conventional networks with an incremental approach is an important design method for the development of the future internet. For this approach, we are developing a future aggregation network based on passive optical network (PON) technology to achieve both cost-effectiveness and high reliability. In this paper, we propose a timeslot (TS) synchronization method for sharing a TS from an optical burst mode transceiver between any route of arbitrary fiber length by changing both the route of the TS transmission and the TS control timing on the optical burst mode transceiver. We show the effectiveness of the proposed method for exchanging TSs in bidirectional bufferless wavelength division multiplexing (WDM) and time division multiplexing (TDM) multi-ring networks under the condition of the occurrence of a link failure through prototype systems. Also, we evaluate the reduction of the required number of optical interfaces in a multi-ring network by applying the proposed method.

This paper studies a novel iterative detection algorithm for data detection in orthogonal frequency division multiplexing systems in the presence of phase noise (PHN) and channel estimation errors. By simplifying the maximum a posteriori algorithm based on the theory of variational inference, an optimization problem over variational free energy is formulated. After that, the estimation of data, PHN and channel state information is obtained jointly and iteratively. The simulations indicate the validity of this algorithm and show a better performance compared with the traditional schemes.

This paper proposes a dynamic spectrum controlled (DSTC) channel allocation algorithm to increase the total throughput of satellite communication (SATCOM) systems. To effectively use satellite resources such as the satellite's maximum transponder bandwidth and maximum transmission power and to handle the propagation gain variation at all earth stations, the DSTC algorithm uses two new transmission techniques: spectrum compression and spectrum division. The algorithm controls various transmission parameters, such as the spectrum compression ratio, number of spectrum divisions, combination of modulation method and FEC coding rate (MODCOD), transmission power, and spectrum bandwidth to ensure a constant transmission bit rate under variable propagation conditions. Simulation results show that the DSTC algorithm achieves up to 1.6 times higher throughput than a simple MODCOD-based algorithm.

In this paper, we present the channel estimation (CE) problem in the orthogonal frequency division multiplexing system with offset quadrature amplitude modulation (OFDM/OQAM). Most CE methods rely on the assumption of a low frequency selective channel to tackle the problem in a way similar to OFDM. However, these methods would result in a severe performance degradation of the channel estimation when the assumption is not quite inaccurate. Instead, we focus on estimating the channel impulse response (CIR) itself which makes no assumption on the degree of frequency selectivity of the channels. After describing the main idea of this technique, we present an iterative CE method that does not require zero-value guard symbols in the preamble and consequently improves the spectral efficiency. This is done by the iterative estimation of the unknown transmitted data adjacent to the preamble. Analysis and simulation results validate the efficacy of the proposed method in multipath fading channels.

This paper presents a weighted diversity combining technique for the cyclostationarity detection based spectrum sensing of orthogonal frequency division multiplexing signals in cognitive radio. In cognitive radio systems, secondary users must detect the desired signal in an extremely low signal-to-noise ratio (SNR) environment. In such an environment, multiple antenna techniques (space diversity) such as maximum ratio combining are not effective because the energy of the target signal is also extremely weak, and it is difficult to synchronize some received signals. The cyclic autocorrelation function (CAF) is used for traditional cyclostationarity detection based spectrum sensing. In the presented technique, the CAFs of the received signals are combined, while the received signals themselves are combined with general space diversity techniques. In this paper, the value of the CAF at peak and non-peak cyclic frequencies are computed, and we attempt to improve the sensing performance by using different weights for each CAF value. The results were compared with those from conventional methods and showed that the presented technique can improve the spectrum sensing performance.

This paper newly proposes and theoretically analyzes the performance of multi-hop free-space optical (FSO) systems employing optical amplify-and-forward (OAF) relaying technique and wavelength division multiplexing (WDM). The proposed system can provide a low cost, low latency, high flexibility, and large bandwidth access network for multiple users in areas where installation of optical fiber is unfavorable. In WDM/FSO systems, WDM channels suffer from the interchannel crosstalk while FSO channels can be severely affected by the atmospheric turbulence. These impairments together with the accumulation of background and amplifying noises over multiple relays significantly degrade the overall system performance. To deal with this problem, the use of the M-ary pulse position modulation (M-PPM) together with the OAF relaying technique is advocated as a powerful remedy to mitigate the effects of atmospheric turbulence. For the performance analysis, we use a realistic model of Gaussian pulse propagation to investigate major atmospheric effects, including signal turbulence and pulse broadening. We qualitatively discuss the impact of various system parameters, including the required average transmitted powers per information bit corresponding to specific values of bit error rate (BER), transmission distance, number of relays, and turbulence strength. Our numerical results are also thoroughly validated by Monte-Carlo (M-C) simulations.

Based on a perfect Gaussian integer sequence, shift and combination operations are performed to construct Gaussian integer sequences with zero correlation zone (ZCZ). The resultant sequence sets are optimal or almost optimal with respect to the Tang-Fan-Matsufuji bound. Furthermore, the ZCZ Gaussian integer sequence sets can be provided for quasi-synchronous code-division multiple-access systems to increase transmission data rate and reduce interference.

A method for increasing alignment tolerance in simple multiple-stream transmission is described. Its use of π-shifted antenna directivity phase enables it to cancel interference even when antenna placement deviations occur. The interference cancellation by using π-shifted directivities provides higher alignment tolerance than that with conventional fixed weight methods. It also provides smaller channel gain variation than can be obtained using fixed weights even when antenna displacement occurs. An objective function is described that is determined by the alignment tolerance. The function is defined to maximize the alignment tolerance. The method's validity is confirmed by an experimental analysis of two-stream transmission in which the alignment tolerance of the proposed method is compared to that of conventional fixed weight methods.

Controlling the peak-to-mean envelope power ratio (PMEPR) of orthogonal frequency-division multiplexed (OFDM) transmissions is a significant obstacle in many low-cost applications of OFDM. An coding approach proposed by H.R. Sadjadpour presents non-square M-QAM symbols as a combination of QPSK and BPSK signals when M=22n+1, and then uses QPSK and BPSK Golay (or Golay-like) sequences with a constant PMEPR to generate M-QAM sequences. This paper proposes a new scheme in which M-QAM sequences are generated by QPSK and BPSK sequences with variable PMEPRs. In other words, this new scheme is a general case of the existing approach. As a result, the code rate of the new sequence is significantly improved, while the upper bound of its PMEPR remains at a comparative level.

A connector model expressed as an inductance is proposed for use in a previously reported common-mode antenna model. The common-mode antenna model is an equivalent model for estimating only common-mode radiation from a printed circuit board (PCB) more quickly and with less computational resources than a calculation method that fully divides the entire structure of the PCB into elemental cells, such as narrow signal traces and thin dielectric layers. Although the common-mode antenna model can estimate the amount of radiation on the basis of the pin configuration of the connector between two PCBs, the calculation results do not show the peak frequency shift in the radiation spectrum when there is a change in the pin configuration. A previous study suggested that the frequency shift depends on the total inductance of the connector, which led to the development of the connector model reported here, which takes into account the effective inductance of the connector. The common-mode antenna model with the developed connector model accurately simulates the peak frequency shift caused by a change in the connector pin configuration. The results agree well with measured spectra (error of 3 dB).

Many selected mapping (SLM) schemes have been proposed to reduce the peak-to-average power ratio (PAPR) of orthogonal frequency division multiplexing (OFDM) signal sequences. In this paper, an efficient selection (ES) method of the OFDM signal sequence with minimum PAPR among many alternative OFDM signal sequences is proposed; it supports various SLM schemes. Utilizing the fact that OFDM signal components can be sequentially generated in many SLM schemes, the generation and PAPR observation of the OFDM signal sequence are processed concurrently. While the u-th alternative OFDM signal components are being generated, by applying the proposed ES method, the generation of that alternative OFDM signal components can be interrupted (or stopped) according to the selection criteria of the best OFDM signal sequence in the considered SLM scheme. Such interruption substantially reduces the average computational complexity of SLM schemes without degradation of PAPR reduction performance, which is confirmed by analytical and numerical results. Note that the proposed method is not an isolated SLM scheme but a subsidiary method which can be easily adopted in many SLM schemes in order to further reduce the computational complexity of considered SLM schemes.