This paper proposes a design method of a Doherty amplifier, which can determine the most efficient backed-off point of the amplifier by adjusting a load modulation parameter. The parameter is defined through the design of output transmission line of a carrier and a peak amplifier using a virtual open stub technique. This paper describes the design results using the technique to optimize efficiency of a Doherty amplifier for an orthogonal frequency division multiplexing (OFDM) signal, and parameter adjustment for a linearized Doherty amplifier using an adaptive digital predistortion (ADPD). Applying this method, the developed 250 W ADPD Doherty amplifier has achieved drain efficiency of 43.4% and intermodulation (IM) distortion of -48.3 dBc with output power of 44.1 dBm (10.1 dB output backed-off) at 563 MHz using an OFDM signal for integrated services digital broadcasting-terrestrial (ISDB-T).

China has experienced fast growth in mobile communications. Now, China is the world largest mobile communication country with about 500 million users. Wide applications of mobile communications are giving strong pull to the research and development on the broadband wireless communication technology to meet the fast growing demand for high speed access into the information infrastructure. This makes the R&D on wireless technology play great role in the Chinese High-Tech program. This paper will review the key project--FuTURE (Future Technology for Universal Radio Environment)--development of the 863 program, which represents the Chinese efforts towards IMT-advance. Taking some works done in the Tsinghua National Laboratory for Information Science and Technology as examples, the paper will show what has been made in China on the broadband wireless technology, including the trial network in Shanghai.

In Optical Burst Switched (OBS) networks, packets are assembled into bursts at ingress edge routers and disassembled at egress edge routers. This letter presents an analytical model to quantify the burstification latency in the OBS networks. To the authors' best knowledge, this letter is the first one to address the latency issue in OBS in a comprehensive manner analytically. The results allow us to quantitatively understand how OBS network parameters such as maximum burst length and maximum timeout affect the packet latency in the OBS networks. We show that the burstification latency in the OBS network is bounded and can be tuned by setting the system parameters under latency constraints.

We propose an effective subcarrier allocation scheme for multiuser orthogonal frequency division multiple access (OFDMA) system in the downlink transmission with low computational complexity. In the proposed scheme, by taking multiple attributes of a user's channel, such as carrier gain decrease rate and variation from the mean channel gain of the system, to determine a rank for the user, subcarriers are then allocated depending on the individual user's rank. Different channel characteristics are used to better understand a user's need for subcarriers and hence determine a priority for the user. We also adopt an attribute weighing scheme to enhance the performance of the proposed scheme. The scheme is computationally efficient, since it avoids using iterations for the algorithm convergence and also common water-filling calculations that become more complex with increasing system parameters. Low complexity is achieved by allocating subcarriers to users depending on their determined rank. Our proposed scheme is simulated in comparison with other mathematically efficient subcarrier allocation schemes as well as with a conventional greedy allocation scheme. It is shown that the proposed method demonstrates competitive results with the simulated schemes.

We propose an N-channel power-compensated reconfigurable optical add/drop multiplexer (ROADM) based on using fiber Bragg gratings (FBGs). Both tunable FBGs and wavelength-fixed FBGs are used in this ROADM. By using the dual-pass amplification scheme with two pieces of erbium doped fibers, an 8.0 dB optical net gain has been achieved with a gain variation less than 0.5 dB for each add/drop/pass-through channel. System performance was studied for a four-WDM-channel 10 Gb/s100-km lightwave transmission trial network and bit error rate of 10-9 is observed for the 50 km added signal, 100 km pass-through signal and 50 km dropped signal at -18.3, -19.4 and -18.9 dBm received power, respectively. Only 1.1 dB of power penalty was observed compared to the back-to-back transmission.

The conventional successive adaptive loading algorithm, represented by Hughes-Hartogs algorithm, can be used to reduce the transmit power of orthogonal frequency division multiplexing (OFDM) system. However, two major disadvantages exist for this kind of algorithm: One is the long loading time delay caused by the bit-to-bit loading, i.e., only one bit is loaded in every iteration; the other is that there is no flexibility in freely pre-defining the candidate modulation set before the loading is finished. In order to solve these problems, we propose the low-loading-delay parallel adaptive loading algorithms aiming at reducing the transmit power under the condition that the data throughput and error rate are maintained to target values. Two improvements are achieved by the new algorithm. One is that it divides the successive adaptive loading into several independent small-scale loading (SS-Loading) procedures. "SS-Loading" can be performed in parallel mode. To support this, we propose two subband division methods (successive and sorted subband divisions). The simulation results show that for a large range of subband number (1-128), the loading time delay can be remarkably decreased (especially for the parallel adaptive loading based on sorted subband division, i.e., SRT parallel adaptive loading algorithm) with neglectable power efficiency loss, compared with Hughes-Hartogs algorithm. The second improvement is that the new algorithm allows us to pre-define the candidate modulation set, which provide flexibility for the system design, e.g. we can exclude those rarely used modulation modes. We also reveal that Hughes-Hartogs algorithm is actually a special case of the newly proposed algorithm.

The traffic with asymmetry between uplink and downlink has recently been getting remarkable on mobile communication systems providing multimedia communication services. In the future mobile communications, the accommodation of asymmetric traffic is essential to realize efficient multimedia mobile communication systems. This paper discusses asymmetric traffic accommodation in CDMA/FDD cellular packet communication systems and proposes its efficient scheme using an adaptive cell sizing technique. In the proposed scheme, each base station autonomously controls its coverage area so that almost the same communication quality can be achieved across the service area under the asymmetric traffic conditions. We present some numerical examples to demonstrate the effectiveness of the proposed scheme by using computer simulation. The simulation results show that, under asymmetric traffic conditions, the proposed scheme can provide fair communication quality across the service area in both links and can improve total transmission capacity in the uplink.

In orthogonal frequency-division multiplex access (OFDMA) uplink, the carrier-frequency offsets (CFOs) between the multiple transmitters and the receiver introduce inter-carrier interference (ICI) and severely degrade the performance. In this paper, based on the perfect estimation of each user's CFO, we propose two low-complexity iterative algorithms to cancel ICI due to CFOs, which are denoted as the basic algorithm and the improved algorithm with decision-feedback equalization (DFE), respectively. For the basic one, two theorems are proposed that yield a sufficient condition for the convergence of iterations. Moreover, the interference-power-evolution (IPE) charts are proposed to evaluate the convergence behavior of this interference cancellation algorithm. Motivated by the IPE chart, the procedure of DFE is introduced into the iterations, which is the basic idea of the improved algorithm. For this improved algorithm, the error-propagation effect are analyzed and suppressed by an efficient stopping criterion. From IPE charts and simulation results, it can be easily observed that the basic algorithm has the same capability of ICI cancellation as the linear optimal minimum mean square error (MMSE) method, but offers lower complexity, while the improved algorithm with DFE outperforms the MMSE method in terms of the bit-error rate (BER) performance.

MIMO systems using a space division multiplexing (SDM) technique in which each transmit antenna sends an independent signal substream have been studied as one of the successful applications to increase data rates in wireless communications. The throughput of a MIMO channel can be maximized by using an eigenbeam-SDM (E-SDM) technique, and this paper investigates the practical performance of 22 and 44 MIMO E-SDM based on indoor measurements. The channel capacity and bit error rate obtained in various uniform linear array configurations are evaluated and are compared with the corresponding values for conventional SDM. Analysis results show that the bit error rate performance of E-SDM is better than that of SDM and that E-SDM gives better performance in line-of-sight (LOS) conditions than in non-LOS ones. They also show that the performance of E-SDM in LOS conditions depends very much on the array configuration.

A carrier frequency synchronization scheme is proposed for orthogonal frequency-division multiplexing (OFDM) systems in the presence of phase noise (PHN). In the proposed scheme, carrier frequency synchronization is performed based on the maximum-likelihood (ML) algorithm using an OFDM preamble symbol. The proposed scheme is compared with conventional methods. Simulation results are presented to illustrate the effectiveness of the proposed scheme in the presence of PHN.

A simple, yet effective geometric method is presented to construct the signature sequences for multicarrier code-division multiple access (MC-CDMA) systems. By minimizing the correlation of the effective signature vectors, the signature sequences are recursively determined via projection onto a properly constructed subspace. Conducted simulations verify the effectiveness of the method.

This paper proposes the most effective deployment scenario of the passive double-star (PON) system to provide multiple broadband services, such as high speed Internet access and broadcast services. The deployment costs of the two major PON technologies, wavelength division multiplexing (WDM) and 10 Gbps time division multiplexing (TDM), are analyzed using the latest cost trend and the most popular access network architecture. These two technologies are compared using the cost analysis results to identify the cost-effective scenarios of PON system deployment. Based on the comparison, this paper reveals that the WDM network becomes cost effective when the service penetration and the shift ratio becomes high.

One approach to accommodating IP traffic on a wavelength division multiplexing (WDM) network is to construct a logical topology, establishing a set of lightpaths between nodes. The lightpaths carry IP traffic but do not require any electronic packet processing at intermediate nodes, thereby reducing the load on those nodes. When the IP and WDM networks have independent routing functions, however, the lightpaths in the WDM network may not be fully utilized by the IP router. It is therefore necessary to integrate the two routing mechanisms in order to utilize resources efficiently and adapt to changes in traffic. In this paper, we propose an integrated routing mechanism for IP over WDM networks. The key idea is to first prepare a set of virtual-links representing the lightpaths that can be established by the WDM network, then calculate the minimum cost route on an IP network including those links. Our simulation results show that when traffic patterns do not change, the throughput of our method is almost the same as that of a logical topology optimally designed for a given traffic demand. When traffic patterns change, the throughput of our method is about 50% higher than that of the logical topology.

Monolithically integrated four-channel distributed feedback (DFB) laser array has been fabricated by metal organic vapor phase epitaxy (MOVPE) selective area growth for 1.55 µm coarse-wavelength division multiplexing (CWDM) systems. Wide-stripe MOVPE selective area growth and electron-beam lithography are used to obtain wide CWDM channel spacing of 20 nm. Compared to hybrid integration of discrete lasers, monolithic integration of laser array on a single substrate greatly simplifies device alignment and packaging process.

For an integer d > 0, a d-queue layout of a graph consists of a total order of the vertices, and a partition of the edges into d sets of non-nested edges with respect to the vertex ordering. Recently V. Dujmovi and D. R. Wood showed that for every integer d ≥ 2, every graph G has a d-queue layout of a subdivision of G with 2logd qn(G)+1 division vertices per edge, where qn(G) is the queue number of G. This paper improves the result for the case of a bipartite graph, and shows that for every integer d ≥ 2, every bipartite graph Gm,n has a d-queue layout of a subdivision of Gm,n with logd n-1 division vertices per edge, where m and n are numbers of vertices of the partite sets of Gm,n (m ≥ n).

In this letter, the effects of transmit beamforming on downlink performance in DS-CDMA communication systems are examined. We present a simple-to-use expression for the conditional instantaneous SINR after Rake combining. Assuming BPSK modulation, the performance of average bit error rate is evaluated. We compare the average BER performance obtained by different beamforming methods under frequency selective multipath fading channels.

Time-frequency-selective, equivalently time-variant multipath, fading channels in orthogonal frequency division multiplexing (OFDM) systems introduce intercarrier interference (ICI), resulting in severe performance degradation. To suppress the effect of ICI, several symbol detection methods have been proposed, all of which are based on the observation that most of the ICI's power is distributed near the desired subcarrier. However, these methods usually ignore the channel variation in a OFDM symbol block by fixing the number of considered ICI terms. Therefore, we propose a novel frequency-domain symbol detection method with moderate complexity, which adaptively determines the number of ICI terms within each OFDM symbol block.

This paper proposes new resource management schemes for multiple data streams in an orthogonal frequency and space division multiplex access (OFSDMA) system using Radio-on-Fiber (RoF) ubiquitous antennas. The proposed schemes classify the services into some classes in which the number of sub-carriers is dynamically assigned according to the requested data size. The computer simulation results show that the proposed schemes improve the number of users satisfying the required bit error rate (BER) level as well as the average throughput and also show that the RoF ubiquitous antennas can improve system capacity.

This paper presents an admission control technique for multi-carrier systems with an FRF(frequency reuse factor) of 1. The FRF of 1 is very attrative for more improved channel throughput but the forward link capacity is rapidly decreased at the cell boundary region due to the increase in the ICI(InterCell Interference). By measuring a region-based channel capacity and deriving a closed form of blocking probability, a QoS(Quality of Service) maintenance technique and mobility model can be acquired. In the simulation, the proposed scheme demonstrates a blocking probability reduction of up to 40% compared to the cell-based link capacity scheme.

We introduce an adaptive subchannel, bit, and power allocation (ASBPA) algorithm to maximize the bandwidth efficiency of the mobile communication system that use orthogonal frequency division multiplexing (OFDM). We propose a suboptimal rate adaptive ASBPA algorithm that guarantees fairness in resource allocation and overcomes inherent co-channel interference (CCI) in the cellular system. Furthermore, we evaluate the maximum possible bandwidth efficiency of the cellular OFDM system achieved by the ASBPA algorithm which is practical to implement. Our simulation results show that the proposed algorithm outperforms the existing ones and achieves the cellular bandwidth efficiency of up to 5 b/s/Hz/cell. We also investigate some of the conditions that govern the bandwidth efficiency of the cellular OFDM system using the proposed ASBPA algorithm.