We show the equivalence between the conventional frame synchronization in single-carrier systems and integer part estimation of frequency offset in OFDM systems and propose an efficient synchronization scheme. The proposed scheme achieves both OFDM symbol/frame timing and frequency offset estimation with only one well-designed OFDM training symbol, while previous synchronization algorithms need two OFDM training symbols at least. Numerical analysis shows that the proposed frequency estimator nearly achieves the Cramér-Rao lower bound for the variance of the frequency offset estimate, despite the reduction in the training sequence length.

A new scheme for reducing optical beat interference noise in a reflective semiconductor optical amplifier based wavelength division multiplexed/subcarrier multiplexing -- passive optical network is proposed. This method uses an Fabry Perot laser locked by modulated lights from optical network units in a central office. As an experimental verification, it is reported that carrier to noise ratio is enhanced by 10 dB and power penalty is improved by 16 dB.

This paper presents media processor architectures for automotive applications. Media processing applications with their requirements for LSI implementations are first described for vision based driver assistance as well as graphical user interface for car navigation using 3D graphics. Then, parallel processing architectures for vision and graphics in these applications are reviewed with their performance and cost. After that, future trends of automotive media processing such as integration of vision and 3D graphics functions are shown with their applications and the required performance. Moreover, parallel processing architectures are discussed for the integration of vision and graphics. Finally, an prospect of a next-generation media processing LSI for automotives is provided.

We achieved the first 10 Gb/s WDM transmission at 1064 and 1550 nm over 24 km of photonic crystal fiber (PCF). We confirmed an improvement in the bit error rate (BER) performance after the transmission, namely "negative power penalties" of -0.5 and -0.3 dB at 1064 and 1550 nm, respectively. Our experimental result and theoretical estimation revealed that the signal degradation induced by the chromatic dispersion can be effectively suppressed by employing the pre-chirp technique with a conventional Z-cut lithium niobate (LN) modulator. We also show theoretically that we can expect to realize 10 Gb/s transmission over a 24 km PCF with negligible BER degradation in the 1060 to 1600 nm wavelength range by using the pre-chirp technique.

This paper presents interference suppression using a subband adaptive array (SBAA) for uplink space-time block coding (STBC) code division multiple access (CDMA) under a frequency selective fading (FSF) channel. The proposed scheme utilizes CDMA with STBC and a receive array antenna with SBAA processing at the receiver. The received signal is converted into the frequency domain before despreading and adaptive processing is performed for each subband. A novel SBAA construction is introduced to process CDMA signals based on STBC. To improve the performance of the proposed scheme, we evaluate STBC-SBAA using spreading codes cyclic prefix (CP). Simulation results demonstrate an improved performance of the proposed system for single and multiuser environments compared to competing related techniques.

Although the line-of-sight (LoS) is expected to be useful as input methodology for computer systems, the application area of the conventional LoS detection system composed of video camera and image processor is restricted in the specialized area, such as academic research, due to its large size and high cost. There is a rapid eye motion, so called 'saccade' in our eye motion, which is expected to be useful for various applications. Because of the saccade's very high speed, it is impossible to track the saccade without using high speed camera. The authors have been proposing the high speed vision chip for LoS detection including saccade based on the pixel parallel processing architecture, however, its resolution is very low for the large size of its pixel. In this paper, we propose and discuss an architecture of the vision chip for LoS detection including saccade based on column-parallel processing manner for increasing the resolution with keeping high processing speed.

China has experienced fast growth in mobile communications. Now, China is the world largest mobile communication country with about 500 million users. Wide applications of mobile communications are giving strong pull to the research and development on the broadband wireless communication technology to meet the fast growing demand for high speed access into the information infrastructure. This makes the R&D on wireless technology play great role in the Chinese High-Tech program. This paper will review the key project--FuTURE (Future Technology for Universal Radio Environment)--development of the 863 program, which represents the Chinese efforts towards IMT-advance. Taking some works done in the Tsinghua National Laboratory for Information Science and Technology as examples, the paper will show what has been made in China on the broadband wireless technology, including the trial network in Shanghai.

In Optical Burst Switched (OBS) networks, packets are assembled into bursts at ingress edge routers and disassembled at egress edge routers. This letter presents an analytical model to quantify the burstification latency in the OBS networks. To the authors' best knowledge, this letter is the first one to address the latency issue in OBS in a comprehensive manner analytically. The results allow us to quantitatively understand how OBS network parameters such as maximum burst length and maximum timeout affect the packet latency in the OBS networks. We show that the burstification latency in the OBS network is bounded and can be tuned by setting the system parameters under latency constraints.

This paper proposes a design method of a Doherty amplifier, which can determine the most efficient backed-off point of the amplifier by adjusting a load modulation parameter. The parameter is defined through the design of output transmission line of a carrier and a peak amplifier using a virtual open stub technique. This paper describes the design results using the technique to optimize efficiency of a Doherty amplifier for an orthogonal frequency division multiplexing (OFDM) signal, and parameter adjustment for a linearized Doherty amplifier using an adaptive digital predistortion (ADPD). Applying this method, the developed 250 W ADPD Doherty amplifier has achieved drain efficiency of 43.4% and intermodulation (IM) distortion of -48.3 dBc with output power of 44.1 dBm (10.1 dB output backed-off) at 563 MHz using an OFDM signal for integrated services digital broadcasting-terrestrial (ISDB-T).

In this paper, we propose a PON-based access network based on conventional TDM-PON architecture for the smooth, economical and effective transition to the future optical access network. We also propose a dynamic MAC protocol for wavelength channel and bandwidth allocation in the TDM-PON subscriber networks, which can provide enhanced network scalability and flexibility, and greater adaptability to the increasing number of subscribers in TDM-PON. In the proposed dynamic MAC protocol, several key functions are manifested, such as multiple wavelength channel utilization and dynamic allocation of multiple time-slots to a user depending on SLA between OLT and ONUs to meet QoS requirements. A dedicated control channel is used for delivering the request and status information between OLT and ONUs. We evaluate the performances of the proposed MAC protocol thru a statistical queuing analysis and numerical simulations. In addition, through simulations using various traffic models we verify the superior performance of the proposed approach by comparing it with conventional TDM-PONs.

In orthogonal frequency-division multiplex access (OFDMA) downlink systems, the carrier-frequency offset (CFO) between the multiple transceivers introduces inter-carrier interference (ICI). In this letter, we propose an iterative precoding scheme to suppress the ICI due to CFO. This scheme is applied at the transmitter, and can jointly cancel the ICI for all the receivers. Moreover, by the studies of the convergence behavior of the iterations, a sufficient condition for the convergence is presented. The theoretical analysis and simulation results both show that this iterative scheme is equivalent to the zero-forcing (ZF) scheme in function, but with much lower complexity.

Ethical and legal requirements have made accessibility a crucial feature in any information systems. This paper presents a content adaptation framework, based on the MPEG-21 standard, to help low-vision users have better accessibility to visual contents. We first present an overview of MPEG-21 Digital Item Adaptation (DIA) and the low-vision description tool which enables interoperable content adaptation. This description tool lists seven low-vision symptoms, namely loss of fine detail, lack of contrast, central vision loss, peripheral vision loss, hemianopia, light sensitivity, and need of light. Then we propose a systematic contrast-enhancement method to improve the content visibility for low-vision users, focusing on the first two symptoms. The effectiveness of the low-vision description tool and our adaptation framework is verified by some experiments with an adaptation test-bed. The major advantages of the proposed approach include 1) support of a wide range of low-vision conditions, and 2) customized content adaptation to specific characteristics of each user.

We propose an N-channel power-compensated reconfigurable optical add/drop multiplexer (ROADM) based on using fiber Bragg gratings (FBGs). Both tunable FBGs and wavelength-fixed FBGs are used in this ROADM. By using the dual-pass amplification scheme with two pieces of erbium doped fibers, an 8.0 dB optical net gain has been achieved with a gain variation less than 0.5 dB for each add/drop/pass-through channel. System performance was studied for a four-WDM-channel 10 Gb/s100-km lightwave transmission trial network and bit error rate of 10-9 is observed for the 50 km added signal, 100 km pass-through signal and 50 km dropped signal at -18.3, -19.4 and -18.9 dBm received power, respectively. Only 1.1 dB of power penalty was observed compared to the back-to-back transmission.

We propose an effective subcarrier allocation scheme for multiuser orthogonal frequency division multiple access (OFDMA) system in the downlink transmission with low computational complexity. In the proposed scheme, by taking multiple attributes of a user's channel, such as carrier gain decrease rate and variation from the mean channel gain of the system, to determine a rank for the user, subcarriers are then allocated depending on the individual user's rank. Different channel characteristics are used to better understand a user's need for subcarriers and hence determine a priority for the user. We also adopt an attribute weighing scheme to enhance the performance of the proposed scheme. The scheme is computationally efficient, since it avoids using iterations for the algorithm convergence and also common water-filling calculations that become more complex with increasing system parameters. Low complexity is achieved by allocating subcarriers to users depending on their determined rank. Our proposed scheme is simulated in comparison with other mathematically efficient subcarrier allocation schemes as well as with a conventional greedy allocation scheme. It is shown that the proposed method demonstrates competitive results with the simulated schemes.

The traffic with asymmetry between uplink and downlink has recently been getting remarkable on mobile communication systems providing multimedia communication services. In the future mobile communications, the accommodation of asymmetric traffic is essential to realize efficient multimedia mobile communication systems. This paper discusses asymmetric traffic accommodation in CDMA/FDD cellular packet communication systems and proposes its efficient scheme using an adaptive cell sizing technique. In the proposed scheme, each base station autonomously controls its coverage area so that almost the same communication quality can be achieved across the service area under the asymmetric traffic conditions. We present some numerical examples to demonstrate the effectiveness of the proposed scheme by using computer simulation. The simulation results show that, under asymmetric traffic conditions, the proposed scheme can provide fair communication quality across the service area in both links and can improve total transmission capacity in the uplink.

A method for flexibly allocating and reallocating optical access network (OAN) resources, including fibers and equipment, using the constraint satisfaction problem (CSP) is described. OAN resource allocation during service delivery provisioning involves various input conditions and allocation sequences, so an OAN resource allocation method has to support various workflow patterns. Furthermore, exception processing, such as reallocating OAN resources once they are allocated, is inevitable, especially during the spread of service using optical fiber and during the deployment of an optical access network. However, it is almost impossible to describe all workflow patterns including exception processes. Improving the efficiency of these exception processes, as well as that of the typical processes, is important for reducing the service delivery time. Describing all these patterns and process flows increases development cost. The CSP can be used to search for solutions without having to fix the process sequence and input conditions beforehand. We have formulated the conditions for OAN resource allocation and reallocation as a CSP. Use of this method makes it possible to handle various allocation workflow patterns including exception processes. Evaluation of the solution search time demonstrated its feasibility.

The conventional successive adaptive loading algorithm, represented by Hughes-Hartogs algorithm, can be used to reduce the transmit power of orthogonal frequency division multiplexing (OFDM) system. However, two major disadvantages exist for this kind of algorithm: One is the long loading time delay caused by the bit-to-bit loading, i.e., only one bit is loaded in every iteration; the other is that there is no flexibility in freely pre-defining the candidate modulation set before the loading is finished. In order to solve these problems, we propose the low-loading-delay parallel adaptive loading algorithms aiming at reducing the transmit power under the condition that the data throughput and error rate are maintained to target values. Two improvements are achieved by the new algorithm. One is that it divides the successive adaptive loading into several independent small-scale loading (SS-Loading) procedures. "SS-Loading" can be performed in parallel mode. To support this, we propose two subband division methods (successive and sorted subband divisions). The simulation results show that for a large range of subband number (1-128), the loading time delay can be remarkably decreased (especially for the parallel adaptive loading based on sorted subband division, i.e., SRT parallel adaptive loading algorithm) with neglectable power efficiency loss, compared with Hughes-Hartogs algorithm. The second improvement is that the new algorithm allows us to pre-define the candidate modulation set, which provide flexibility for the system design, e.g. we can exclude those rarely used modulation modes. We also reveal that Hughes-Hartogs algorithm is actually a special case of the newly proposed algorithm.

In orthogonal frequency-division multiplex access (OFDMA) uplink, the carrier-frequency offsets (CFOs) between the multiple transmitters and the receiver introduce inter-carrier interference (ICI) and severely degrade the performance. In this paper, based on the perfect estimation of each user's CFO, we propose two low-complexity iterative algorithms to cancel ICI due to CFOs, which are denoted as the basic algorithm and the improved algorithm with decision-feedback equalization (DFE), respectively. For the basic one, two theorems are proposed that yield a sufficient condition for the convergence of iterations. Moreover, the interference-power-evolution (IPE) charts are proposed to evaluate the convergence behavior of this interference cancellation algorithm. Motivated by the IPE chart, the procedure of DFE is introduced into the iterations, which is the basic idea of the improved algorithm. For this improved algorithm, the error-propagation effect are analyzed and suppressed by an efficient stopping criterion. From IPE charts and simulation results, it can be easily observed that the basic algorithm has the same capability of ICI cancellation as the linear optimal minimum mean square error (MMSE) method, but offers lower complexity, while the improved algorithm with DFE outperforms the MMSE method in terms of the bit-error rate (BER) performance.

MIMO systems using a space division multiplexing (SDM) technique in which each transmit antenna sends an independent signal substream have been studied as one of the successful applications to increase data rates in wireless communications. The throughput of a MIMO channel can be maximized by using an eigenbeam-SDM (E-SDM) technique, and this paper investigates the practical performance of 22 and 44 MIMO E-SDM based on indoor measurements. The channel capacity and bit error rate obtained in various uniform linear array configurations are evaluated and are compared with the corresponding values for conventional SDM. Analysis results show that the bit error rate performance of E-SDM is better than that of SDM and that E-SDM gives better performance in line-of-sight (LOS) conditions than in non-LOS ones. They also show that the performance of E-SDM in LOS conditions depends very much on the array configuration.

A simple, yet effective geometric method is presented to construct the signature sequences for multicarrier code-division multiple access (MC-CDMA) systems. By minimizing the correlation of the effective signature vectors, the signature sequences are recursively determined via projection onto a properly constructed subspace. Conducted simulations verify the effectiveness of the method.