This paper proposes 1-bit feedforward distortion compensation for digital radio frequency conversion (DRFC) with 1-bit bandpass delta-sigma modulation (BP-DSM). The 1-bit BP-DSM allows direct RF signal transmission from a digitally modulated signal. However, it has been previously reported that 1-bit digital pulse trains with non-ideal rectangle waveform cause spectrum regrowth. The proposed architecture adds a feedforward path with another 1-bit BP-DSM and so can cancel out the distortion components at any target carrier frequency. Both the main signal and the distortion compensation signal are 1-bit digital pulse trains and so no additional analog RF circuit is required for distortion compensation. Simulation results show that the proposed method holds the adjacent channel leakage ratio to 60dB for LTE signal transmission. A prototype of the proposed 1-bit DRFC with an additional 1-bit BP-DSM in the feedforward path shows an ACLR of 50dB, 4dB higher than that of the conventional 1-bit DRFC.

Pulse Pairs (PPs) generated by Distance Measure Equipment (DME) cause severe interference on L-band Digital Aeronautical Communication System type 1 (L-DACS1) which is based on Orthogonal Frequency Division Multiplexing (OFDM). In this paper, a novel and practical PP mitigation approach is proposed. Different from previous work, it adopts only time domain methods to mitigate interference, so it will not affect the subsequent signal processing in frequency domain. At the receiver side, the proposed approach can precisely reconstruct the deformed PPs (DPPs) which are often overlapped and have various parameters. Firstly, a filter bank and a correlation scheme are jointly used to detect non-overlapped DPPs, also a weighted average scheme is used to automatically measure the waveform of DPP. Secondly, based on the measured waveform, sparse estimation is used to estimate the precise positions of DPPs. Finally, the parameters of each DPP are estimated by a non-linear estimator. The key point of this step is, a piecewise linear model is used to approximate the non-linear carrier frequency of each DPP. Numerical simulations show that comparing with existing work, the proposed approach is more robust, closer to interference free environment and its Bit Error Rate is reduced by about 10dB.

System expandability becomes a major concern for highly parallel computers and data centers, because their number of nodes gradually increases year by year. In this context we propose a low-degree topology and its floor layout in which a cabinet or node set can be newly inserted by connecting short cables to a single existing cabinet. Our graph analysis shows that the proposed topology has low diameter, low average shortest path length and short average cable length comparable to existing topologies with the same degree. When incrementally adding nodes and cabinets to the proposed topology, its diameter and average shortest path length increase modestly. Our discrete-event simulation results show that the proposed topology provides a comparable performance to 2-D Torus for some parallel applications. The network cost and power consumption of DSN-F modestly increase when compared to the counterpart non-random topologies.

In this work, the bias polarity dependent resistive switching behaviors in Cu/Si3N4/p+ Si RRAM memory cell have been closely studied. Different switching characteristics in both unipolar and bipolar modes after the positive forming are investigated. The bipolar switching did not need a forming process and showed better characteristics including endurance cycling, uniformity of switching parameters, and on/off resistance ratio. Also, the resistive switching characteristics by both positive and negative forming switching are compared. It has been confirmed that both unipolar and bipolar modes after the negative forming exhibits inferior resistive switching performances due to high forming voltage and current.

This paper claims to use a new question expansion method for question classification in cQA services. The input questions consist of only a question whereas training data do a pair of question and answer. Thus they cannot provide enough information for good classification in many cases. Since the answer is strongly associated with the input questions, we try to create a pseudo answer to expand each input question. Translation probabilities between questions and answers and a pseudo relevant feedback technique are used to generate the pseudo answer. As a result, we obtain the significant improved performances when two approaches are effectively combined.

Proof of Retrievability (POR) is a protocol by which a client can distribute his/her data to cloud servers and can check if the data stored in the servers is available and intact. After that, network coding-based POR has been applied to improve network throughput. Although many network coding-based PORs have been proposed, most of them have not achieved the following practical features: direct repair and dynamic operations. In this paper, we propose the D2-POR scheme (Direct repair and Dynamic operations in network coding-based POR) to address these shortcomings. When a server is corrupted, the D2-POR can support the direct repair in which the data stored in the corrupted server can be repaired using the data directly provided by healthy servers. The client is thus free from the burden of data repair. Furthermore, the D2-POR allows the client to efficiently perform dynamic operations, i.e., modification, insertion and deletion.

Electroencephalography (EEG) and magnetoencephalography (MEG) measure the brain signal from spatially-distributed electrodes. In order to detect event-related synchronization and desynchronization (ERS/ERD), which are utilized for brain-computer/machine interfaces (BCI/BMI), spatial filtering techniques are often used. Common spatial potential (CSP) filtering and its extensions which are the spatial filtering methods have been widely used for BCIs. CSP transforms brain signals that have a spatial and temporal index into vectors via a covariance representation. However, the variance-covariance structure is essentially different from the vector space, and not all the information can be transformed into an element of the vector structure. Grassmannian embedding methods, therefore, have been proposed to utilize the variance-covariance structure of variational patterns. In this paper, we propose a metric learning method to classify the brain signal utilizing the covariance structure. We embed the brain signal in the extended Grassmann manifold, and classify it on the manifold using the proposed metric. Due to this embedding, the pattern structure is fully utilized for the classification. We conducted an experiment using an open benchmark dataset and found that the proposed method exhibited a better performance than CSP and its extensions.

Pairing-based cryptography has realized a lot of innovative cryptographic applications such as attribute-based cryptography and semi homomorphic encryption. Pairing is a bilinear map constructed on a torsion group structure that is defined on a special class of elliptic curves, namely pairing-friendly curve. Pairing-friendly curves are roughly classified into supersingular and non supersingular curves. In these years, non supersingular pairing-friendly curves have been focused on from a security reason. Although non supersingular pairing-friendly curves have an ability to bridge various security levels with various parameter settings, most of software and hardware implementations tightly restrict them to achieve calculation efficiencies and avoid implementation difficulties. This paper shows an FPGA implementation that supports various parameter settings of pairings on non supersingular pairing-friendly curves for which Montgomery reduction, cyclic vector multiplication algorithm, projective coordinates, and Tate pairing have been combinatorially applied. Then, some experimental results with resource usages are shown.

This paper presents a parallelization method utilizing dead time to implement higher precision feedback control systems in multicore processors. The feedback control system is known to be difficult to parallelize, and it is difficult to deal with the dead time in control systems. In our method, the dead time is explicitly represented as delay elements. Then, these delay elements are distributed to the overall systems with equivalent transformation so that the system can be simulated or executed in parallel pipeline operation. In addition, we introduce a method of delay-element addition for parallelization. For a spring-mass-damper model with a dead time, parallel execution of the model using our technique achieves 3.4 times performance acceleration compared with its sequential execution on an ideal four-core simulation and 1.8 times on a cycle-accurate simulator of a four-core embedded processor as a threaded application on a real-time operating system.

Changing attitudes toward energy security and energy conservation have led to the introduction of distributed power systems such as photovoltaic, gas-cogeneration, biomass, water, and wind power generators. The mass installation of distributed energy generators often causes instability in the voltage and frequency of the power grid. Moreover, the power quality of distributed power grids can become degraded when system faults or the activation of highly loaded machines cause rapid changes in power load. To avoid such problems and maintain an acceptable power quality, it is important to detect the source of these rapid changes. To address these issues, next-generation power grids that can detect the fault location have been proposed. Fault location demands accurate time synchronization. Conventional techniques use the Global Positioning System (GPS) and/or IEEE 1588v2 for time synchronization. However, both methods have drawbacks — GPS cannot be used in indoor situations, and the installation cost of IEEE 1588v2 devices is high. In this paper, a time synchronization technique using the broadcast function of an Ethernet Passive Optical Network (EPON) system is proposed. Experiments show that the proposed technique is low-cost and useful for smart grid applications that use time synchronization in EPON-based next-generation power grids.

We propose an impact and high-pitch noise-suppression method based on spectral entropy. Spectral entropy takes a large value for flat spectral amplitude and a small value for spectra with several lines. We model the impact noise as a flat spectral signal and its damped oscillation as a high-pitch periodic signal consisting of spectra with several lines. We discriminate between the current noise situations by using spectral entropy and adaptively change the noise-suppression parameters used in a zero phase-based impact-noise-suppression method. Simulation results show that the proposed method can improve the perceptual evaluation of the speech quality and speech-recognition rate compared to conventional methods.

This work presents an object tracking framework which is based on integration of Deformable Part based Models (DPMs) and Dynamic Conditional Random Fields (DCRF). In this framework, we propose a DCRF based novel way to track an object and its details on multiple resolutions simultaneously. Meanwhile, we tackle drastic variations in target appearance such as pose, view, scale and illumination changes with DPMs. To embed DPMs into DCRF, we design specific temporal potential functions between vertices by explicitly formulating deformation and partial occlusion respectively. Furthermore, temporal transition functions between mixture models bring higher robustness to perspective and pose changes. To evaluate the efficacy of our proposed method, quantitative tests on six challenging video sequences are conducted and the results are analyzed. Experimental results indicate that the method effectively addresses serious problems in object tracking and performs favorably against state-of-the-art trackers.

In this paper, we construct ideal and probabilistic secret sharing schemes for some multipartite access structures, including the General Hierarchical Access Structure and Compartmented Access Structures. We devise an ideal scheme which implements the general hierarchical access structure. For the compartmented access structures, we consider three special access structures. We propose ideal and probabilistic schemes for these three compartmented access structures by bivariate interpolation.

Local spatio-temporal features are popular in the human action recognition task. In practice, they are usually coupled with a feature encoding approach, which helps to obtain the video-level vector representations that can be used in learning and recognition. In this paper, we present an efficient local feature encoding approach, which is called Approximate Sparse Coding (ASC). ASC computes the sparse codes for a large collection of prototype local feature descriptors in the off-line learning phase using Sparse Coding (SC) and look up the nearest prototype's precomputed sparse code for each to-be-encoded local feature in the encoding phase using Approximate Nearest Neighbour (ANN) search. It shares the low dimensionality of SC and the high speed of ANN, which are both desired properties for a local feature encoding approach. ASC has been excessively evaluated on the KTH dataset and the HMDB51 dataset. We confirmed that it is able to encode large quantity of local video features into discriminative low dimensional representations efficiently.

In this paper, we consider solving the all-pairs regular path problem on large graphs efficiently. Let G be a graph and r be a regular path query, and consider finding the answers of r on G. If G is so small that it fits in main memory, it suffices to load entire G into main memory and traverse G to find paths matching r. However, if G is too large and cannot fit in main memory, we need another approach. In this paper, we propose a novel approach based on external memory algorithm. Our algorithm finds the answers matching r by scanning the node list of G sequentially. We made a small experiment, which suggests that our algorithm can solve the problem efficiently.

Recently, a high dimensional classification framework has been proposed to introduce spatial and anatomical priors in classical single kernel support vector machine optimization scheme, wherein the sequential minimal optimization (SMO) training algorithm is adopted, for brain image analysis. However, to satisfy the optimization conditions required in the single kernel case, it is unreasonably assumed that the spatial regularization parameter is equal to the anatomical one. In this letter, this approach is improved by combining SMO algorithm with multiple kernel learning to avoid that assumption and optimally estimate two parameters. The improvement is comparably demonstrated by experimental results on classification of Alzheimer patients and elderly controls.

Modern web users may encounter a browser security threat called drive-by-download attacks when surfing on the Internet. Drive-by-download attacks make use of exploit codes to take control of user's web browser. Many web users do not take such underlying threats into account while clicking URLs. URL Blacklist is one of the practical approaches to thwarting browser-targeted attacks. However, URL Blacklist cannot cope with previously unseen malicious URLs. Therefore, to make a URL blacklist effective, it is crucial to keep the URLs updated. Given these observations, we propose a framework called automatic blacklist generator (AutoBLG) that automates the collection of new malicious URLs by starting from a given existing URL blacklist. The primary mechanism of AutoBLG is expanding the search space of web pages while reducing the amount of URLs to be analyzed by applying several pre-filters such as similarity search to accelerate the process of generating blacklists. AutoBLG consists of three primary components: URL expansion, URL filtration, and URL verification. Through extensive analysis using a high-performance web client honeypot, we demonstrate that AutoBLG can successfully discover new and previously unknown drive-by-download URLs from the vast web space.

Distributed antenna systems (DASs) combined with multi-user multiple-input multiple-output (MU-MIMO) transmission techniques have recently attracted significant attention. To establish MU-MIMO DASs that have wide service areas, the use of a dynamic clustering scheme (CS) is necessary to reduce computation in precoding. In the present study, we propose a simple method for dynamic clustering to establish a single cell large-scale MU-MIMO DAS and investigate its performance. We also compare the characteristics of the proposal to those of other schemes such as exhaustive search, traditional location-based adaptive CS, and improved norm-based CS in terms of sum rate improvement. Additionally, to make our results more universal, we further introduce spatial correlation to the considered system. Computer simulation results indicate that the proposed CS for the considered system provides better performance than the existing schemes and can achieve a sum rate close to that of exhaustive search but at a lower computational cost.

A novel activation method for a B dopant implanted in a Si substrate using a soft X-ray undulator was examined. As the photon energy of the irradiated soft X-ray approached the energy of the core level of Si 2p, the activation ratio increased. The effect of soft X-ray irradiation on B activation was remarkable at temperatures lower than 400°C. The activation energy of B activation by soft X-ray irradiation (0.06 eV) was lower than that of B activation by furnace annealing (0.18 eV). The activation of the B dopant by soft X-ray irradiation occurs at low temperature, although the activation ratio shows small values of 6.2×10-3 at 110°C. The activation by soft X-ray is caused not only by thermal effects, but also electron excitation and atomic movement.

The availability is an important issue of software-defined networking (SDN). In this paper, the experiments based on a SDN testbed showed that the resource utilization of the data plane and control plane changed drastically when DDoS attacks happened. This is mainly because the DDoS attacks send a large number of fake flows to network in a short time. Based on the observation and analysis, a DDoS defense mechanism based on legitimate source and destination IP address database is proposed in this paper. Firstly, each flow is abstracted as a source-destination IP address pair and a legitimate source-destination IP address pair database (LSDIAD) is established by historical normal traffic trace. Then the proportion of new source-destination IP address pair in the traffic per unit time is cumulated by non-parametric cumulative sum (CUSUM) algorithm to detect the DDoS attacks quickly and accurately. Based on the alarm from the non-parametric CUSUM, the attack flows will be filtered and redirected to a middle box network for deep analysis via south-bound API of SDN. An on-line updating policy is adopted to keep the LSDIAD timely and accurate. This mechanism is mainly implemented in the controller and the simulation results show that this mechanism can achieve a good performance in protecting SDN from DDoS attacks.