In this paper, we present the development of an advanced MMIC receiver for a 94-GHz band passive millimeter-wave (PMMW) imager. Our configuration is based on a Dicke receiver in order to reduce fluctuations in the detected voltage. By introducing an electronic switch in the MMIC, we achieved a high resolution millimeter-wave image in a shorter image collection time compared to that with a conventional mechanical chopper. We also developed an imaging array using MMIC receivers.

This Letter deals with the problem of non-line-of-sight (NLOS) in cellular systems devoted to location purposes. In conjugation with a variable loading technique, we present an efficient technique to make covariance shaping least squares estimator has robust capabilities against the NLOS effects. Compared with other methods, the proposed improved estimator has high accuracy under white Gaussian measurement noises and NLOS effects.

Recently, frequency-domain equalization (FDE) has been attracting much attention as a way to improve single-carrier (SC) signal transmission in a frequency-selective wireless channel. Since the SC signal spectrum is spread over the entire signal bandwidth, FDE can take advantage of channel frequency-selectivity and achieve the frequency diversity gain. SC with FDE is a promising wireless signal transmission technique. In this article, we review the pioneering research done on SC with FDE. The principles of simple one-tap FDE, channel estimation, and residual inter-symbol interference (ISI) cancellation are presented. Multi-input/multi-output (MIMO) is an important technique to improve the transmission performance. Some of the studies on MIMO/SC with FDE are introduced.

Code density is often a critical issue in embedded computers, since the memory size of embedded systems is strictly limited. Echo instructions have been proposed as a method for reducing code size. This paper presents a new type of echo instruction, split echo, and evaluates an implementation of both split echo and traditional echo instructions on a MIPS R3000 based processor. Evaluation results show that memory requirement is reduced by 12% on average with small additional hardware cost.

This paper proposes a hybrid multiband (MB) ultra wideband (UWB) system with direct sequence (DS) spreading. The theoretical error analysis for the DS-MB-UWB multiple access system with Rake receiver in the presence of multipath and narrowband interference is developed. The developed theoretical framework models the multiple access interference (MAI), multipath interference (MI) and narrowband interference for the designed UWB system. It is shown that the system error performance corresponding to the combining effects of these interference can be accurately modeled and calculated. Monte Carlo simulation results are provided to validate the accuracy of the model. Additionally, it is found that narrowband interference can be mitigated effectively in the multiband UWB system by suppressing the particular UWB sub-band co-existing with the interfering narrowband signal. A typical improvement of 5 dB can be achieved with 75% sub-band power suppression. On the other hand, suppression of UWB sub-band is also found to decrease frequency diversity, thus facilitating the increase of MAI. In this paper, the developed model is utilized to determine the parameters that optimize the UWB system performance by minimizing the effective interference.

A novel waveguide power divider based on a coaxial-to-waveguide transition using a H-plane probe is presented. The waveguide consists of split metal blocks and substrates which are alternately stacked. The power divider is realized by arranging identical transitions using coaxial probes short-circuited with metal patterns on the substrate. The parasitic reactance of probes can be canceled out with the metal patterns on the substrate, so it is ease to design the power divider. The advantages of this structure are small footprint, low insertion loss, simple fabrication, and ease of design. A design method of the proposed power divider is described. The fabricated eight-way power divider shows excellent performances at 10 GHz-band.

Frequency-domain equalization (FDE) based on the minimum mean square error (MMSE) criterion can provide a better bit error rate (BER) performance than rake combining. However, the residual inter-chip interference (ICI) is produced after MMSE-FDE and this degrades the BER performance. Recently, we showed that frequency-domain ICI cancellation can bring the BER performance close to the theoretical lower bound. To further improve the BER performance, transmit antenna diversity technique is effective. Cyclic delay transmit diversity (CDTD) can increase the number of equivalent paths and hence achieve a large frequency diversity gain. Space-time transmit diversity (STTD) can obtain antenna diversity gain due to the space-time coding and achieve a better BER performance than CDTD. Objective of this paper is to show that the BER performance degradation of CDTD is mainly due to the residual ICI and that the introduction of ICI cancellation gives almost the same BER performance as STTD. This study provides a very important result that CDTD has a great advantage of providing a higher throughput than STTD. This is confirmed by computer simulation. The computer simulation results show that CDTD can achieve higher throughput than STTD when ICI cancellation is introduced.

To achieve an automated implementation for the application-specific heterogeneous multiprocessor systems-on-chip (MPSoC), partitioning and mapping the sequential programs onto multiple parallel processors is one of the most difficult challenges. However, the existing traditional parallelizing techniques cannot solve the MPSoC-related problems effectively, so designers are still required to manually extract the concurrency potentials in the program. To solve this bottleneck, an automated application partition technique is needed. However, completely automatic parallelism is ineffective, so it is promising to explore concurrency for certain practical special structures. To settle those issues, this paper proposes a template-based algorithm to automatically partition a special load-compute-store (LCS) loop structure. Since specific-instruction customization for the application specific instruction-set processors (ASIPs) has interactions with task partitioning, the proposed algorithm integrates the dynamic pipelining and ASIP techniques using an iterative improvement strategy: first, an initial pipelining scheme is generated to obtain the maximum parallelism; second, under the primary partition results specific instructions are customized respectively for each subprogram; third, the program is repartitioned via pipelining under the specific instruction configurations. The proposed method has been implemented in the context of a commercial extensible multiprocessor design flow, using the Xtensa-based XTMP platform from Tensilica Inc. Based on a case study of Fast Fourier Transform (FFT), the experimental results indicate that the partitioned programs by the proposed method demonstrate an average speedup of 10 compared to the original sequential programs which have not been partitioned and run on the uniprocessor system.

An L-band 4-bit RL/RC-switched active phase shifter using differential switches is developed. It employs RL/RC circuits in the design of series feedback loops of the quadrature differential amplifier and achieves 90, 45, and 22.5of phase shift by switching on and off the RL/RC circuits alternatively. On the other hand, a 180phase shift is achieved with the use of a phase difference between the differential outputs. By cascading all four bits, an insertion gain of 16 to 23 dB, a phase error of less than 8.5, and an RMS phase error of 4.6have been achieved at 1 GHz.

This paper presents a new signaling architecture for radio-access control in wireless communications systems. Called THREP (for THREe-phase link set-up Process), it enables systems with low-cost configurations to provide tetherless access and wide-ranging mobility by using autonomous radio-link controls for fast cell searching and distributed call management. A signaling architecture generally consists of a radio-access part and a service-entity-access part. In THREP, the latter part is divided into two steps: preparing a communication channel, and sustaining it. Access control in THREP is thus composed of three separated parts, or protocol phases. The specifications of each phase are determined independently according to system requirements. In the proposed architecture, the first phase uses autonomous radio-link control because we want to construct low-power indoor wireless communications systems. Evaluation of channel usage efficiency and hand-over loss probability in the personal handy-phone system (PHS) shows that THREP makes the radio-access sub-system operations in a practical application model highly efficient, and the results of a field experiment show that THREP provides sufficient protection against severe fast CNR degradation in practical indoor propagation environments.

The importance of redundant technologies for improving dependability and delay fault testability are growing. This paper presents properties of a class of redundant technologies, namely two-rail logic, and analyzes testability of path delay faults occurring on two-rail logic circuits. The paper reveals the following characteristics of two-rail logic circuits: While the number of paths in two-rail logic circuits is twice that in ordinary single-rail logic circuits, the number of robust testable path delay faults in two-rail logic circuits is twice or more that in the single-rail logic circuits. This suggests two-rail logic circuits are more testable than ordinary single-rail logic circuits. On two-rail logic circuits, there may be some robust testable path delay faults that are functional un-sensitizable for any input vectors consisting of codewords of two-rail codes, i.e. for any input vectors that can occur during fault-free operation. Even if such faults occur, the circuits are still strongly fault secure for unidirectional stuck-at faults as well as they work correctly.

In this Letter, a robust system identification method is proposed for the generalized sidelobe canceller using dual microphones. The conventional transfer-function generalized sidelobe canceller employs the non-stationarity characteristics of the speech signal to estimate the relative transfer function and thus is difficult to apply when the noise is also non-stationary. Under the assumption of W-disjoint orthogonality between the speech and the non-stationary noise, the proposed algorithm finds the speech-dominant time-frequency bins of the input signal by inspecting the system output and the inter-microphone time delay. Only these bins are used to estimate the relative transfer function, so reliable estimates can be obtained under non-stationary noise conditions. The experimental results show that the proposed algorithm significantly improves the performance of the transfer-function generalized sidelobe canceller, while only sustaining a modest estimation error in adverse non-stationary noise environments.

This paper proposes an Integer Linear Programming (ILP)-based power minimization method by partitioning into regions, first, with three different VDD's(PM3V), and, secondly, with two different VDD's(PM2V). To reduce the solving time of triple-VDD case (PM3V), we also proposed a partitioned ILP method(p-PM3V). The proposed method provides 29% power saving on the average in the case of triple-VDD compared to the case of single VDD. Power reduction of PM3V compared to Clustered Voltage Scaling (CVS) was about 18%. Compared to the unpartitioned ILP formulation(PM3V), the partitioned ILP method(p-PM3V) reduced the total solution time by 46% at the cost of additional power consumption within 1.3%.

This paper proposes an ultra-wideband double-directional spatio-temporal channel sounding technique using transformation between frequency- and time-domain (FD and TD) signals. Virtual antenna arrays, composed of omnidirectional antennas and scanners, are used for transmission and reception in the FD. After Fourier transforming the received FD signals to TD ones, time of arrival (TOA) is estimated using a peak search over the TD signals, and then angle of arrivals (AOA) and angle of departure (AOD) are estimated using a weighted angle histogram with a multiple signal classification (MUSIC) algorithm applied to the FD signals, inverse-Fourier transformed from the TD signals divided into subregions. Indoor channel sounding results validated that an appropriate weighting reduced a spurious level in the angle histogram by a factor of 0.1 to 0.2 in comparison with that of non-weighting. The proposed technique successfully resolved dominant multipath components, including a direct path, a single reflection, and a single diffraction, in line-of-sight (LOS) and non-LOS environments. Joint TOA and AOA/AOD spectra were also derived from the sounding signals. The spectra illustrated the dominant multipath components (agreed with the prediction by ray tracing) as clusters.

This paper proposes adaptive transmit window control based on both location of mobile stations and traffic load for channel state based packet transmissions in CDMA cellular downlink communications. The proposed scheme constrains downlink packet transmissions by employing a transmit window individually given to each mobile station. The transmit window size is adjusted by using the optimum threshold value, which is selected with regard to both the mobile locations and the traffic load. The simulation results show that the proposed scheme improved the transmission delay and fairness of service compared with the conventional scheme.

This paper presents a content-based retrieval algorithm for motion capture data, which is required to re-use a large-scale database that has many variations in the same category of motions. The most challenging problem is that logically similar motions may not be numerically similar due to the motion variations in a category. Our algorithm can effectively retrieve logically similar motions to a query, where a distance metric between our novel short-term features is defined properly as a fundamental component in our system. We extract the features based on short-term analysis of joint velocities after dividing an entire motion capture sequence into many small overlapped clips. In each clip, we select not only the magnitude but also the dynamic pattern of the joint velocities as our features, which can discard the motion variations while keeping the significant motion information in a category. Simultaneously, the amount of data is reduced, alleviating the computational cost. Using the extracted features, we define a novel distance metric between two motion clips. By dynamic time warping, a motion dissimilarity measure is calculated between two motion capture sequences. Then, given a query, we rank all the motions in our dataset according to their motion dissimilarity measures. Our experiments, which are performed on a test dataset consisting of more than 190 motions, demonstrate that our algorithm greatly improves the performance compared to two conventional methods according to a popular evaluation measure P(NR).

In this paper, the research advances in SIW-like (Substrate Integrated Waveguide-like) guided wave structures and their applications in the State Key Laboratory of Millimeter Waves of China is reviewed. Our work is concerned with the investigations on the propagation characteristics of SIW, half-mode SIW (HMSIW) and the folded HMSIW (FHMSIW) as well as their applications in microwave and millimeter wave filters, diplexers, directional couplers, power dividers, antennas, power combiners, phase shifters and mixers etc. Selected results are presented to show the interesting features and advantages of those new techniques.

We investigate numerically the applicability of photonic crystal fiber (PCF) with a uniform air hole structure as a wide-band transmission medium. We show that accumulated dispersion over the PCF can be reduced effectively by optimizing the index profile of dispersion compensating fiber (DCF). We also show that a bandwidth of more than 300 nm will be available for 40 Gbit/s NRZ transmission by using the PCF as a transmission medium instead of conventional 1.3 µm zero-dispersion single-mode fiber (SMF).

We have developed a novel downlink packet scheduling scheme for a multiuser OFDMA system in which a subchannel can be time-multiplexed among multiple users. This scheme which is called Matrixed-based Proportional Fairness can provide a high system throughput while ensuring fairness. The scheme is based on a Proportional Fairness (PF) utility function and can be applied to any of the PF-based schedulers. Our scheduler explores multichannel multiuser diversity by using a two-dimensional matrix combining user selection, subchannel assignment, and time slot allocation. Furthermore, unlike other PF-based schemes, our scheme considers finitely backlogged queues during the time slot allocation. By doing so, it can exploit multichannel multiuser diversity to utilize bandwidth efficiently and with throughput fairness. Additionally, fairness in the time domain is enhanced by limiting the number of allocated time slots. Intensive simulations considering finitely backlogged queues and user mobility prove the scheme's effectiveness.

This paper describes a novel algorithm for approximate nearest neighbor searching. For solving this problem especially in high dimensional spaces, one of the best-known algorithm is Locality-Sensitive Hashing (LSH). This paper presents a variant of the LSH algorithm that outperforms previously proposed methods when the dataset consists of vectors normalized to unit length, which is often the case in pattern recognition. The LSH scheme is based on a family of hash functions that preserves the locality of points. This paper points out that for our special case problem we can design efficient hash functions that map a point on the hypersphere into the closest vertex of the randomly rotated regular polytope. The computational analysis confirmed that the proposed method could improve the exponent ρ, the main indicator of the performance of the LSH algorithm. The practical experiments also supported the efficiency of our algorithm both in time and in space.