Advances in semiconductor technology have made it possible to develop an experimental 1000 MIPS superscalar RISC processor. The high performance of this processor was obtained using architectural concepts such as multiple CPU configuration, superscalar microarchitecture, and high-speed device technology. This paper focuses on the novel features of this RISC processor, its device technology, architectural characteristics and one technology that has been devised to make its integer CPU cores fault-tolerant.

Although individual segments of a natural language such as words have different importance on human interpretation of the meaning, every segment has been uniformly protected by an error-correcting code. If the importance of individual segments is defined by considering their meaning in the sentence, we can adaptively control the level of error-protection for each segment according to its importance in order to reduce errors on human interpretation of the meaning. In this paper, we propose an error-control scheme based on the varying importance of each word. We first introduce a method which determines the importance of each word and then propose an error-control scheme in which several error-correcting codes are alternately used to protect each word according to its importance. Probablity of semantic errors, that is, errors on human interpretation of the meaning, is defined and used as a criterion in mapping error-correcting codes to words possessing different importance. We theoretically formalize the problem of obtaining an optimum mapping which minimizes the probability of semantic errors under some constraint. Given a certain probability distribution of the importance of words and set of error-correcting codes, we can derive the optimum mapping. The proposed error-controlling scheme is theoretically evaluated by comparing its probability of semantic errors with that of a conventional scheme in which every word is uniformly protected by a single error-correcting code. Results show that the proposed scheme can considerably raduce the probability of semantic errors while retaining the same average transmission rate or redundancy.

In power line SS communication system, since available frequency range is limited from 10 kHz to 450 kHz by the law, we can't transmit any components of lower and higher frequency regions. In this paper, we propose a method for improving bit error rate by using the PN sequence coded by the new channel code, FM-V5 code, instead of PE code to have correlation property in the coded PN sequence. Correlation property in the coded PN sequence makes us effectively use Viterbi decoding technique on the receiving side. To enhance correlation property more, we also examine to apply additionally partial response (PR) system, so called PRML system, on the receiving side. The results of computer simulation show the improvement of about 4.5 dB on SNR at bit error rate 10-5 by using FM-V5 code without PR system compared with PE code. In the case of FM-V5 code with PR(1, -1) system, we get the further improvement of about 11 dB on SNR at the same bit error rate 10-5 compared with PE code. As a result, our method can attain SNR improvement about 20 dB compared with conventional simple PN sequence, that is the conventional Direct Sequence/Spread Spectrum (DS/SS), method.

The purpose of our research is to get further improvement in the performance of order statistic filters. The basic idea found in our research is the use of a robust median estimator to obtain median differential order information which the classes of order statistic filter required in order to sort the input signal in the filter window. In order to give the motivation for using a median estimator in the classes of order statistic filters, we derive theorems characterizing the median filters and prove them theoretically using the characteristic that the order statistic filter has the performance for a monotonic signal equivalent with the FIR linear filter. As an application of median operation, we propose and investigate the Median Differential Order Statistic Filter to reduce impulsive noise as well as Gaussian noise and regard it as a subclass of the Order Statistic Filter. Moreover, we introduce the piecewise linear function in the Median Differential Order Statistic Filter to improve performance in terms of edge preservation. We call it the Piecewise Linear Median Differential Order Statistic Filter. The effectiveness of proposed filters is verified theoretically by computing the output Mean Square Error of the filters in parts of edge signals, impulsive noise, small amplitude noise and their combination. Computer simulations also show that the proposed filter can improve the performance in both noise (small-amplitude Gaussian noise and impulsive noise) reduction and edge preservation for one-dimensional signals.

The characteristics of an optical functional integrated circuit and its applications are discussed. This circuit is based upon a Mach-Zehnder interferometer type waveguide device employing thermo-optic effect. This circuit is compact, cost-effective and practical. One proposed application is an optical loopback circuit to test both OCU loop 1 and DSU loop C. This optical loopback circuit with an attenuator and space switches is formed on a common silicon substrate, and using this circuit both loopback and line tests are independently available at the same access point. The other is an optical selector. This optical selector with WDM-MUX/DMUX and space switches is formed on a common silicon substrate, and using this selector, wavelength selection from medium density WDM (MDWDM) signal can be performed. Each MDWDM signal carries both AM and FM-FDM video signals modulated by Subcarrier Multiplexing (SCM) techniques. This selector can be wired in point-to-multipoint configurations to home video appliances.

The essential functions of the passive double star (PDS) system are clarified by comparing them to the functions of the single star (SS) and the active double star (ADS) system. A layered structure describing the functional characteristics of the PDS system is proposed for flexible transport capability. The functions of the optical network unit (ONU) on the customer premises are systematically partitioned into four layers. The functions of the optical subscriber unit (OSU) in the central office are described using five layers. Call by call activation and deactivation techniques are described on the basis of a layered architecture. The reduction of ONU power consumption by adopting activation and deactivation control is also discussed.

Optical fiber cable systems are being developed in many countries for subscriber loops as the infrastructure to realize B-ISDN (Broadband Integrated Services Digital Network). The present systems are DLC (Digital Loop Carrier) systems which provide leased lines, POTS (Plain Old Telephone Services), and N-ISDN (Narrowband ISDN) services. Before FTTH (Fiber To The Home) networks can be implemented, their construction cost must be lowered to the level of the current metallic network. The FTTH network must also be easy to operate and maintain. In this paper, we describe optical fiber cables, splicing, and testing technologies used in the NTT cable networks, and introduce the technologies being developed to construct FTTH networks.

Subscriber network opticalization is the key issue for the next generation network. Fiber-optic systems have been limited to mainly big business applications, so far. Massive opticalization including home and small business customers remains the ultimate goal. Opticalization of the subscriber network needs an enormous investment and a long construction period. In order to achieve smooth evolution towards B-ISDN, the subscriber network must be effectively opticalized well in advance of full B-ISDN deployment. This paper presents the development concept of optical subscriber network. It also describes the design concept and configuration of fiber-optic subscriber systems. Deployment strategies and the developing technologies for the future subscriber network are also addressed.

In case of the system identification problem, such as an echo canceller, estimated impulse response obtained by the frequency-domain adaptive filter based on the circular convolution has estimation error because the unknown system is based on the linear convolution in the time domain. In this correspondence, we consider a sufficient condition to reduce the estimation error.

A Ge/Si structure grown by chemical vapor deposition (CVD) is angle-lapped and characterized by the micro-Raman spectroscopy. Near the interface, the phonon mode due to the Si-Ge bond is clearly observed, which indicates that a SiGe alloy is formed by the solid-phase interdiffusion at the interface. The thickness of the interfacial alloy layer is about 0.2 µm. Amount of residual strain is estimated by comparing the measured phonon frequencies with those predicted from the composition profie, but the shift due to the residual strain is not appreciable. Both the interdiffusion at the interface and the nearly complete relaxation of the lattice mismatch are attributed to the high growth temperature of the CVD sample.

In this paper, we analyze a photodetection process of new kind theoretically, which transforms a coherent state of light so as to lead to nonstandard property, namely, sub-Poissonian distribution of its output photoelectron during its photodetection process. The properties of the photoelectron distribution are studied used as preamplifiers of both direct-detection and homodyne detection cases.

Asynchronous Transfer Mode (ATM) switching system is expected to handle various kinds of media (such as motion video, computer data, and voice), and traffic control becomes essential to satisfy various quality requirements and to maintain efficient utilization of system resources. Priority control is one possible solution for realizing such a traffic control. In priority control, cells from various media are scheduled for transmission with different priority according to the quality class to which they belong. In this paper, we propose a new priority control method in which cells from various media are stored in their own buffer, we call it class buffer, and priority assignments are carried out based on the number of cells in each class buffer and the delay time. The number of cells in each class buffer is maintained using the counter circuit. The delay time of the cell is checked by the timer circuit for cell group, each of which consists of cells arriving during a periodical time interval. For simulation model, we consider three kinds of traffic; video, computer data, and voice, of which quality requirements are quite different. We show performance results in terms of the cell delay and the cell loss probability in our method through simulation.

Runlength-limited block codes are investigated. These codes are useful for storing data in storage devices. Since most devices are not noiselss, the codes are often required to have some error-control capability. We consider runlength-limited codes that can correct or detect unidirectional byte errors. Some constructions of such codes are presented.

In this paper, a new M-estimation technique for the linear prediction analysis of speech is proposed. Since in the conventional linear prediction (CLP) method the obtained estimates are very much affected by the large amplitude residual parts, in the proposed method we use a loss function which assigns large weighting factor for small amplitude residuals and small weighting factor for large amplitude residuals which is for instance caused by the pitch excitations. The loss function is based on the assumption that the residual signal has an independent and identical t-distribution t(α) with α degrees of freedom. The efficiency of this new estimator depends on α. When α=, we get the CLP method. When the proposed method with small α is applied to the problems of estimating the formant frequencies and bandwidths of the synthetic speech by finding the roots of the prediction polynomial, we can achieve a more accurate and a smaller standard deviation (SD) estimate than that with large α. When the signal is very spiky, the proposed method can ahieve more efficient and accurate estimates than that with robust linear prediction (RBLP) method. The loss function is modified in the similar manner as the autocorrelation method. The solution is calculated by the Newton-Raphson iteration technique. The simulation results show that only few iterations are needed to reach a stationary point, the stationary point is always a local minimum and the obtained prediction filter is always minimum phase. Preliminary experiments on the human speech data indicate that the obtained results are insensitive to the placement of the analysis window and a higher spectral resolution than the CLP and RBLP method can be achieved.

Thin Si films grown on anodized porous silicon have been characterized using a high-energy ion scattering technique with related simulations of MeV ions in solids. It turned out that the simulations are necessary and very usuful for quantitative and nondestractive analysis of thin films with thicknesses less than 100 nm. In the case of the epitaxial Si films examined, it is often insufficient for the characterization of crystalline quality to measure only the channeling minimum yield, and therefore, it is emphasized that angular scans over the critical angle in the vicinity of a channeling direction must be performed for the analysis of possible imperfections in thin films. The possible imperfections observed in the epitaxial specimen are treated quantitatively.

The problem of presentation view generation over external/conceptual view is discussed for database systems. The presentation view is expressed by a format of a report which is generated as the result of a database query. A new presentation format generation scheme for composite reports is proposed for object-oriented databae systems. The reports can have nested (extended non-first-normal-form) formats. The presentation format should vary at run time, depending on repeating groups and data arrangement. The proposed scheme is based on the idea of dynamic co-referring objects, which uses an object-oriented data model extended to the presentation layer. As important features, various composite reports can be easily derived from databases, and dynamic format modification is possible interactively, even after retrieving the data. The scheme is useful for database applications which require a wide variety of formats for casual queries, where the report generation programming cost will be greatly reduced.

This paper describes a new metric for evaluating the cost effectiveness of software reviews. The proposed metric is based on the degree to which costs needed for detecting all faults from software are reduced by software reviews in a project. The metric can be interpreted as combining two conventional metrics proposed by Fagan (1976) and Collofello and Woodfield (1989). As the proposed metric is normalized by virtual testing cost, we can compare the values of it among any different kind of projects. Using an experimental evaluation of the conventional metrics and the proposed metric for data collected in an industrial environment, we show the validity and usefulness of the proposed metric. In addition, we present a method to estimate a value of the proposed metric by using only the values which can be computed during the software reviews.

An accurate numerical solution is presented for the electromagnetic scattering from infinite strip gratings attached to both sides of a dielectric slab. This structure is a model of polarization discriminating devices. The period of the strips is common to both planes, but the widths and the axes may be different. The direction of propagation and the polarization of an incident plane wave are arbitray. We derive a set of singular integral equations and solve it by the moment method, where the Chebyshev polynomials are successfully used as the basis and the testing functions. This method is accurate and effective owing to the incorporation of the edge condition and the decomposition of the kernel functions into the singular and the regular parts. Numerical calculations are carried out for the purpose of designing polarization discriminators, and it is shown that the band width is widened by decreasing the permittivity of the slab. The cross-polarization characteristics at skew incidence are also discussed.

Recently most of the singularities of the equivalent edge currents for flat plates were eliminated by the authors using the paths of most rapid phase variation. A unique direction on the plate was determined for given incidence and observer. This paper extends this method for arbitrary angle wedges and presents the new expressions of the equivalent edge currents. The resultant expressions are valid for any incidence and observation aspects and have no false singularities. Diffraction patterns and radar cross sections of 3-D objects composed of wedges are calculated by using these currents. They show good agreements with experimental data or the results by the other methods.

A process of mixing viscous fluids, such as oil-based paints is applied to generate marble patterns. It is difficult to get the exact flow function of the viscous fluid, then we express the flow in terms of velocity vectors derived from simplified flow phenomena, in which the viscous liquid is supposed to be a collection of finite liquid elements. The position change of each element is calculated as the function of time and several examples of the obtained marble patterns are illustrated.