In this paper, we propose two 2's-complement fixed-width Booth multipliers that can generate an n-bit product from an n-bit multiplicand and an n-bit multiplier. Compared with previous designs, our multipliers have smaller truncation error, less area, and smaller time delay in the critical paths. A four-step approach is adopted to search for the best error-compensation bias in designing a multiplier suitable for VLSI implementation. Last but not least, we show the superior capability of our designs by inscribing it in a speech signal processor. Simulation results indicate that this novel design surpasses the previous fixed-width Booth multiplier in the precision of the product. An average error reduction of 65-84% compared with a direct-truncation fixed-width multiplier is achieved by adding only a few logic gates.

In this research, the performance degradation of the digital electronic equipment under electromagnetic (EM) disturbance was studied in order to investigate the interference of intra-equipment. To develop the evaluation method of the performance degradation, some communication indexes were measured under EM disturbance. From some experimental results, it is known that the performance degradation of the electronic equipment was estimated by the degradation of "through-put," one of the communication performance indexes. For further investigation of the interference of intra-equipment, the near EM field from a PCB of the electronic equipment and its performance degradation under EM disturbance were measured and compared. From the measured results, the relationship between near field measurement and performance degradation could be obtained in some extent. These facts enable us that the weak area under the EM disturbance application on PCB can be foreseen by measuring the near field emission from the equipment and vise versa.

We propose a method of crosstalk analysis for two bent transmission lines with vias at both ends on a PCB using a circuit-concept approach in the quasi-static condition. In this condition, the electromagnetic fields can be approximately estimated by the quasi-static terms of the accurate Green's function in an inhomogeneous medium. Thus we obtain a circuit model in an ABCD matrix by taking account of the fields generated by a longitudinal line and a vertical via on a PCB. To verify the proposed approach, we conducted some experiments and compared our approach's results with measured results and a commercial electromagnetic solver's results.

An improved Max-Log-Map (MLM) turbo equalization algorithm called Scaled Max-Log-Map (SMLM) iterative equalization is presented. Simulations show that the scheme can dramatically outperform the MLM besides it is insensitive to SNR mismatch. Unfortunately, its performance is still much worse than that of Log-Map (LM) with exact SNR over high-loss channels. Accordingly, we also propose a new SNR estimation algorithm based on the reliability values of soft output extrinsic information of SMLM decoder. Using the new scheme, we obtain good performance close to that of LM with ideal knowledge of SNR.

In recent years, network analysis has revealed that some real networks have the properties of small-world and/or scale-free networks. In this study, a simple Genetic Algorithm (GA) is regarded as a network where each node and each edge respectively represent a population and the possibility of the transition between two nodes. The characteristic path length (CPL), which is one of the most popular criteria in small-world networks, is derived analytically and shows how much the crossover operation affects the path length between two populations. As a result, the crossover operation is not so useful for shortening the CPL.

Long-period gratings (LPGs) are written in the fibers un-preheated and preheated. The influence of residual stress on trimming resonance wavelengths by heating the LPGs is investigated comparing the post-heating changes of the transmission characteristics. It becomes evident that the residual stress relaxation shifts resonance wavelengths to shorter wavelengths quickly and the glass structure modification moves them to longer wavelengths slowly. The relaxation rate of the glass structure drops rapidly with the decrease in heating temperature, and the influence of the residual stress relaxation appears more strongly at the early stage of heating at a lower temperature. The trimming wavelength range can be broadened on the short wavelength side by decreasing the heating temperature. We could adjust resonance wavelengths without significant peak loss changes by the residual stress relaxation before writing LPGs, though the trimming range becomes narrow.

This paper proposes a design technique to reduce the power dissipation of CML driver for on-chip transmission-lines. CML drivers can operate at higher frequency than conventional static CMOS logic drivers. On the other hand, the power dissipation is larger than that of CMOS static logic drivers. The proposed method reduces the power dissipation by using an impedance-unmatched driver instead of the conventional impedance-matched driver. Measurement results show that the proposed method reduces the power dissipation by 32% compared with a conventional design at 12.5 Gbps.

This paper proposes a frequency diversity scheme using only even-numbered samples for single-carrier transmission with frequency-domain equalization (SC-FDE). In the proposed scheme, a periodical frequency spectrum generated by using only even-numbered samples in the time domain provides the frequency redundancy, which is utilized for frequency diversity. Moreover, in order to avoid the data rate reduction due to the decrease in the samples within one block, the high-level modulation is applied to each sample and the transmitting power of each sample can be doubled for the equivalent power transmission instead. Computer simulation results show that the proposed scheme provides a steeper BER curve than the typical SC-FDE over frequency selective fading channels, while the typical SC-FDE is more favorable than the proposed scheme over flat fading channels. Moreover, the proposed scheme still retains its characteristic even when channel estimation and channel coding are additionally taken into account.

This paper presents a new Fuzzy Logic Controller (FLC) having the ability to support rational-powered membership functions. These functions are extended forms of triangular/trapezoidal membership functions, and also those functions which are generated by applying linguistic hedges. A two-input, single-output, nine-rule Takagi-Sugeno-Kang (TSK) type FLC is designed in 0.35 µm standard CMOS technology. This controller can also be used as a standard (Mamdani) type FLC having singleton output membership functions, as well as a Linguistic Hedge FLC (LHFLC). Mixed analog/digital realization of the circuit makes the design programmable and extendable, while having relatively low power consumption. Current mode realization of the circuits leads to simple and intuitive configurations. For a particular set of programming parameters, simulation results of the controller using HSPICE simulator and level 49 parameters (BSIM3v3), show an average power consumption of 5 mW, and an RMS error of 1.32% compared to ideal results obtained from MATLAB software.

This paper presents a method for blind identification of a system whose transfer matrix is non-invertible at infinity, based on independent component analysis. In the proposed scheme, the transfer matrix to be identified is pre-multiplied by an appropriate polynomial matrix, named interactor, in order to compensate the row relative degrees and obtain a biproper system. It is then pre-multiplied by a demixing matrix via an existing approximate method. Both of these matrices are estimated blindly, i.e. with the input signals being unknown. The identified system is thus obtained as the inverse of the multiplication of these matrices.

It is an innovative idea for modern PLL generation to control the bandwidth proportionally to the reference frequency. Recently, a frequency of the operating clock in microprocessors has been required to be changed frequently and widely in order to manage power consumption and throughput. A new compact switched capacitor (SC) filter which has fully flat response has been developed for adaptive biased PLLs. We have also developed a new digital control method for achieving the wider frequency range. The measured performances of the test chip were good enough for the use in the microprocessors.

A new digital calibration scheme for a 14 bit binary weighted current-steering digital-to-analog converter (DAC) is presented. This scheme uses a simple current comparator for the current measurement instead of a high-resolution ADC. Therefore, a faster calibration cycle and smaller additional circuits are possible compared to the scheme with the high-resolution ADC. In the proposed calibration scheme, the lowest 8 bit part of the DAC is used for both error correction and normal operation. Therefore, the extra DACs required for calibration are only a 3 bit DAC and a 6 bit DAC. Nevertheless, a large calibration range is achieved. Full 14 bit resolution is achieved with a small chip-area. The simulation results show that DNL and INL after calibration are 0.26 LSB and 0.46 LSB, respectively. They also show that the spurious free dynamic range is 83 dB (57 dB) for signals of 24 kHz (98 MHz) at 200 Msps update rate.

A carrier frequency synchronization scheme is proposed for orthogonal frequency-division multiplexing (OFDM) systems in the presence of phase noise (PHN). In the proposed scheme, carrier frequency synchronization is performed based on the maximum-likelihood (ML) algorithm using an OFDM preamble symbol. The proposed scheme is compared with conventional methods. Simulation results are presented to illustrate the effectiveness of the proposed scheme in the presence of PHN.

This letter proposes a simple combined coding and modulation based on super-orthogonal convolutional codes (SOCs) in order to support both coherent and non-coherent ultra-wideband (UWB) receivers. In the proposed scheme, the coherent receivers obtain a coding gain as large as the SOC while simultaneously supporting non-coherent receivers. In addition, their performance can be freely adapted by changing the encoder constraint length and the number of PPM slots according to its application. Thus, the proposal enables a more flexible system design for low data-rate UWB systems.

This paper proposes effective energy feature normalization methods for robust speech recognition in noisy environments. We first develop an energy subtraction method and a modified method for the Log-energy Dynamic Range Normalization (ERN) using inverse function. We then present the hybrid method combining the energy subtraction and the modified ERN. Using Aurora2.0 database for representative evaluations, a significant performance improvement over the ERN method is demonstrated.

This letter yields a security evaluation of certain broadcast encryption (BE) schemes regarding the generic vulnerability of the textbook BE schemes. The considered vulnerability can be effectively explored assuming known plaintext attacks which in a realistic scenario, corresponding to a legitimate user being the attacker, appears as a ciphertext only attack. Employing the birthday paradox, a dedicated time-data trade-off based algorithm for cryptanalysis is proposed. The developed algorithm is applied to cryptanalysis of particular recently reported class of BE schemes, implying additional insights regarding motivations for their security improvements.

We measured the complex permittivities of whole blood and blood plasma in quasi millimeter and millimeter wave bands using a coaxial probe method. The validity of these measurements was confirmed by comparing with those of a different measurement method, i.e., a dielectric tube method. It is shown that the complex permittivities of the blood samples are similar to those of water in quasi millimeter and millimeter wave bands. Furthermore, the temperature dependences of the complex permittivities of the samples were measured.

In this paper, we propose tight performance upper bounds for convolutional codes terminated with an input sequence of finite length. To obtain the upper bounds, a generalized weight enumerator of single error event is defined to represent the relation between the Hamming distance of the coded output and the Hamming distance of the selected input bits of a terminated convolutional code. In the generalized weight enumerator of single error event, codewords composed of multiple error events are not counted to provide tighter performance upper bounds. The upper bounds on frame error rate (FER) and average bit error rate (BER) of selected bits are computed from the generalized weight enumerators of single error event. A simple method is presented to compute the weight enumerator of a terminated convolutional code based on a modified trellis diagram.

To improve the channel estimation accuracy of multiple-input multiple-output (MIMO) multiplexing, we previously proposed iterative QR-decomposition with M-algorithm (QRD-M) with decision directed channel estimation. In this paper, to keep the computational complexity low while further improving the transmission performance, we will modify previously proposed iterative QRD-M by incorporating cyclic redundancy check (CRC) coding. In the proposed method, transmitted signals are ranked according to their results of CRC decoding and the received signal-to-interference plus noise power ratio (SINR). In the modified M-algorithm, since the results of Turbo decoding and CRC decoding are used to generate the surviving symbol replica, the accuracy of signal detection in the following steps can be improved. Furthermore, based on the results of CRC decoding, iterative process can be terminated before reaching the maximum allowable number of iterations. Computer simulation results show that the loss in the required average received signal energy per bit-to-noise power spectrum density ratio Eb/N0 for average packet error rate (PER) = 10-2 is only about 0.4 dB from maximum likelihood detection (Full MLD) with ideal channel estimation.

MIMO systems using a space division multiplexing (SDM) technique in which each transmit antenna sends an independent signal substream have been studied as one of the successful applications to increase data rates in wireless communications. The throughput of a MIMO channel can be maximized by using an eigenbeam-SDM (E-SDM) technique, and this paper investigates the practical performance of 22 and 44 MIMO E-SDM based on indoor measurements. The channel capacity and bit error rate obtained in various uniform linear array configurations are evaluated and are compared with the corresponding values for conventional SDM. Analysis results show that the bit error rate performance of E-SDM is better than that of SDM and that E-SDM gives better performance in line-of-sight (LOS) conditions than in non-LOS ones. They also show that the performance of E-SDM in LOS conditions depends very much on the array configuration.