In this paper, we propose periodic and aperiodic security limits for compromising emanations in the VHF and UHF bands. First, we perform the electromagnetic emanation security (EMSEC)-channel measurements in the 200-1000MHz frequency bands. Second, we analyse the pathloss characteristics of the indoor EMSEC-channel based on these measurements. Through this EMSEC-channel analysis, we affirm that the total radio attenuation, which is one of the key parameters for determining the security limits for compromising emanations, follows the Rician distribution. With these results, we propose that periodic and aperiodic emission security limits can be classified into two levels depending on the total radio attenuation and the extent of required confidentiality. The proposed security limits are compared with other security limits and existing civil and military EMC standards.

Phase-nonreciprocal ε-negative and CRLH metamaterials are analyzed using a new approach in which field analysis and transmission line model are combined. The examined one-dimensional nonreciprocal metamaterials are composed of a ferrite-embedded microstrip line periodically loaded with shunt stubs. In the present approach, the phase constant nonreciprocity is analytically estimated and formulated under the assumption of operating frequency far above the ferromagnetic resonant frequency. The present approach gives a good explanation to the phenomenon in terms of ferromagnetic properties of the ferrite and asymmetric geometry of the metamaterial structure, showing a good agreement with numerical simulations and experiment.

Metamaterials are generally defined as a class of artificial effective media which macroscopically exhibit extraordinary electromagnetic properties that may not be found in nature, and are composed of periodically structured dielectric, or magnetic, or metallic materials. This paper reviews recently developed electromagnetic modeling methods of metamatericals and their inherent basic ideas, with a focus on full wave numerical techniques. Methods described in this paper are the Method of Moments (MoM) and the Finite Difference Time Domain (FDTD) Method for scattering problems excited by an incident plane wave and a single nonperiodic source, and the Finite Element Method (FEM), the Finite Difference Frequency Domain (FDFD) method and the FDTD method for band diagram calculations.

NROM is one of the emerging non-volatile-memory technologies, which is promising for replacing current floating-gate-based non-volatile memory such as flash memory. In order to raise the fabrication yield and enhance its reliability, a novel test and repair flow is proposed in this paper. Instead of the conventional fault replacement techniques, a novel fault masking technique is also exploited by considering the logical effects of physical defects when the customer's code is to be programmed. In order to maximize the possibilities of fault masking, a novel data inversion technique is proposed. The corresponding BIST architectures are also presented. According to experimental results, the repair rate and fabrication yield can be improved significantly. Moreover, the incurred hardware overhead is almost negligible.

Regular on-site testing is an elementary means to obtain real-time data and state of Electromagnetic Compatibility (EMC) of electronics systems. Nowadays, there is a lot of measured EMC data while the application of the data is insufficient. So we put forward the concept of EMC model synthesis. To carry out EMC data mining with measured electromagnetic data, we can build or modify models and synthesize variation rules of electromagnetic parameters of equipment and EMC performance of systems and platforms, then realize the information synthesis and state prediction. The concept of EMC reliability is brought forward together with the definition and description of parameters such as invalidation rate and EMC lifetime. We studied the application of statistical algorithms and Artificial Neural Network (ANN) in model synthesis. Operating flows and simulation results as well as measured data are presented. Relative research can support special measurement, active management and predictive maintenance and replenishment in the area of EMC.

This paper proposes T-CROM (Time-delayed Collaborative ROuting and MAC) protocol, that allows collaboration between network and MAC layers in order to extend the lifetime of MANETs in a resources-limited environment. T-CROM increases the probability of preventing energy-poor nodes from joining routes by using a time delay function that is inversely proportional to the residual battery capacity of intermediate nodes, making a delay in the route request (RREQ) packets transmission. The route along which the first-arrived RREQ packet traveled has the smallest time delay, and thus the destination node identifies the route with the maximum residual battery capacity. This protocol leads to a high probability of avoiding energy-poor nodes and promotes energy-rich nodes to join routes in the route establishment phase. In addition, T-CROM controls the congestion between neighbors and reduces the energy dissipation by providing an energy-efficient backoff time by considering both the residual battery capacity of the host itself and the total number of neighbor nodes. The energy-rich node with few neighbors has a short backoff time, and the energy-poor node with many neighbors gets assigned a large backoff time. Thus, T-CROM controls the channel access priority of each node in order to prohibit the energy-poor nodes from contending with the energy-rich nodes. T-CROM fairly distributes the energy consumption of each node, and thus extends the network lifetime collaboratively. Simulation results show that T-CROM reduces the number of total collisions, extends the network lifetime, decreases the energy consumption, and increases the packet delivery ratio, compared with AOMDV with IEEE 802.11 DCF and BLAM, a battery-aware energy efficient MAC protocol.

This paper introduces the basics of energy harvesters and demonstrates two specific vibratory-type energy harvesters developed at the University of Hyogo. The fabrication and evaluation results of the vibratory-type energy harvesters, which employ electrostatic and electromagnetic mechanisms, are described. The aim of developing these devices is to realize a power source for an autonomous human monitoring system. The results of harvesting from actual human activities obtained using a data logger are also described. Moreover, challenges in the power management of electronic circuitry used for energy harvesting are briefly discussed.

A method for the specification of weighting functions for a spaceborne/airborne interferometric synthetic aperture radar (SAR) sensor for Earth observation and environment monitoring is introduced. This method is based on designing an optimum mismatched filter which minimizes the total power in sidelobes located out of a specified range region around the peak value point of the system point-target response, i.e. impulse response function under the constraint imposed on the peak value. It is shown that this method allows achieving appreciable improvement in accuracy performance without degradation in the range resolution.

We examine the relationship between 116 VHF sensor events recorded by the VHF sensor on the Maido-1 satellite and lightning strokes detected by the World Wide Lightning Location Network (WWLLN) to show that most of the VHF sensor events were caused by lightning discharges. For each VHF sensor event, the WWLLN events within 1400 km from the subsatellite point and within 1 sec, 30 sec, and 300 sec of the VHF sensor trigger time are analyzed. We find that the coincidence rates in the North and South American continents, and in Southeast/East Asia and the Australian continent are greater than 0.90. Those in the African and European continents, and in the Pacific and Atlantic Oceans are less than 0.61. These high enough coincidence rates indicate that the VHF sensor events were emitted from lightning, although the coincidence rates in the other regions are quite low because of the low detection efficiency of the WWLLN in the regions. We also focus on 6 coincident events measured by both the VHF sensor and the WWLLN. The incidence angles of the EM waves for the VHF sensor are estimated from the group delay characteristics of the recorded EM waveforms. Compared with the WWLLN lightning locations, the two incidence angles are temporally and spatially coincident. These results indicate that a large fraction of the VHF sensor events are emitted by lightning discharges.

In situ UV-vis. absorption spectra of cytochrome c adsorbed on ITO electrode was observed with slab optical waveguide spectroscopy combining pulse potential step (PPS) between 0.3 and -0.45 V vs. Ag/AgCl. The amount of cytochrome c adsorbed on ITO electrode was estimated from the amount of coulomb of the peaks in cyclic voltammogram to be about a monolayer coverage in this experimental condition. Spectral change between oxidized and reduced cytochrome c by PPS was finished in about 20 msec with phosphate buffer solution. The results strongly proved that SOWG spectroscopy should be effective for in situ observation of ET reaction kinetics of surface adsorbed molecules.

In this paper, a novel interference suppression technique from added RoF (Radio-on-Fiber) system is proposed. In general RoF system, received RF (radio frequency) signal intensity is periodically varied depending on chromatic dispersion that is known as fading phenomenon. In proposed technique null points of this fading phenomenon are intentionally applied to minimize signal interferences. This technique can realize two types of multiplexing RoF signal. In the first configuration, a single optical carrier is modulated twice using two optical modulators connected in series. In second configuration, new RoF signal is added to the existing network using individual light source. Multiplexing RoF signals of 10 GHz-band with data of 30 Mbps 64QAM is experimentally demonstrated.

The imaging of humans using radar is promising for surveillance systems. Although conventional radar systems detect the presence or position of intruders, it is difficult to acquire shape and motion details because the resolution is insufficient. This paper presents a high-resolution human imaging algorithm for an ultra-wideband (UWB) Doppler radar. The proposed algorithm estimates three-dimensional human images using interferometry and, using velocity information, rejects false images created by the interference of body parts. Experiments verify that our proposed algorithm achieves adequate pedestrian imaging. In addition, accurate shape and motion parameters are extracted from the estimated images.

Current distributions induced on a circular disk of conductor are analyzed rigorously for an electric dipole incidence, when the source dipole is polarized parallel to the disk and located at an arbitrary position, and they are evaluated numerically. As the height of the dipole increases, the current distribution of the dipole approaches that of the plane wave incidence. Using a multiple precision arithmetic, numerical data for the current distribution are obtained for larger radii of a disk than the former approach.

To improve Last-Level Cache (LLC) management, numerous approaches have been proposed requiring additional hardware budget and increased overhead. A number of these approaches even change the organization of the existing cache design. In this letter, we propose Adaptive Insertion and Promotion (AIP) policies based on Least Recently Used (LRU) replacement. AIP dynamically inserts a missed line in the middle of the cache list and promotes a reused line several steps left, realizing the combination of LRU and LFU policies deliberately under a single unified scheme. As a result, it benefits workloads with high locality as well as with many frequently reused lines. Most importantly, AIP requires no additional hardware other than a typical LRU list, thus it can be easily integrated into the existing hardware with minimal changes. Other issues around LLC such as scans, thrashing and dead lines are all explored in our study. Experimental results on the gem5 simulator with SPEC CUP2006 benchmarks indicate that AIP outperforms LRU replacement policy by an average of 5.8% on the misses per thousand instructions metric.

Electromagnetic emissions leak confidential data of cryptographic devices. Electromagnetic Analysis (EMA) exploits such emission for cryptanalysis. The performance of EMA dramatically decreases when correlated noise, which is caused by the interference of clock network and exhibits strong correlation with encryption signal, is present in the acquired EM signal. In this paper, three techniques are proposed to reduce the correlated noise. Based on the observation that the clock signal has a high variance at the signal edges, the first technique: single-sample Singular Value Decomposition (SVD), extracts the clock signal with only one EM sample. The second technique: multi-sample SVD is capable of suppressing the clock signal with short sampling length. The third one: averaged subtraction is suitable for estimation of correlated noise when background samplings are included. Experiments on the EM signal during AES encryption on the FPGA and ASIC implementation demonstrate that the proposed techniques increase SNR as much as 22.94 dB, and the success rates of EMA show that the data-independent information is retained and the performance of EMA is improved.

Capacitor charging modeling efficiently and accurately represents power consumption current of CMOS digital circuits and actualizes co-simulation of AC power noise including the interaction with on-chip and on-board integrated power delivery network (PDN). It is clearly demonstrated that the AC power noise is dominantly characterized by the frequency-dependent impedance of PDN and also by the operating frequency of circuits as well. A 65 nm CMOS chip exhibits the AC power noise components in substantial relation with the parallel resonance of the PDN seen from on-chip digital circuits. An on-chip noise monitor measures in-circuit power supply voltage, while a near-field magnetic probing derives on-board power supply current. The proposed co-simulation well matches the power noise measurements. The proposed AC noise co-simulation will be essentially applicable in the design of PDNs toward on-chip power supply integrity (PSI) and off-chip electromagnetic compatibility (EMC).

This paper proposes a method for reconstructing accurate 3D surface points. To this end, robust and dense reconstruction with Shape-from-Silhouettes (SfS) and accurate multiview stereo are integrated. Unlike gradual shape shrinking and/or bruteforce large space search by existing space carving approaches, our method obtains 3D points by SfS and stereo independently, and then selects correct ones from them. The point selection is achieved in accordance with spatial consistency and smoothness of 3D point coordinates and normals. The globally optimized points are selected by graph-cuts. Experimental results with several subjects containing complex shapes demonstrate that our method outperforms existing approaches and our previous method.

A method obtaining a monochrome image which can rebuild colors is proposed. In this method, colors in an input image are quantized under a lightness constraint and a palette, which represents relationship between quantized colors and gray-levels, is generated. Using the palette, an output monochrome image is obtained. Experiments show that the proposed method obtains good monochrome and rebuilt color images.

High-performance FFT processor is indispensable for real-time OFDM communication systems. This paper presents a CORDIC based design of variable-length FFT processor which can perform various FFT lengths of 64/128/256/512/1024/2048/4096/8192-point. The proposed FFT processor employs memory based architecture in which mixed radix 4/2 algorithm, pipelined CORDIC, and conflict-free parallel memory access scheme are exploited. Besides, the CORDIC rotation angles are generated internally based on the transform of butterfly counter, which eliminates the need of ROM making it memory-efficient. The proposed architecture has a lower hardware complexity because it is ROM-free and with no dedicated complex multiplier. We implemented the proposed FFT processor and verified it on FPGA development platform. Additionally, the processor is also synthesized in 0.18 µm technology, the core area of the processor is 3.47 mm2 and the maximum operating frequency can be up to 500 MHz. The proposed FFT processor is better trade off performance and hardware overhead, and it can meet the speed requirement of most modern OFDM system, such as IEEE 802.11n, WiMax, 3GPP-LTE and DVB-T/H.

The mode-matching applications to scattering from circular and annular apertures in a thick perfectly conducting plane are reviewed. The Hankel and Weber transforms are utilized to solve the boundary-value problems of circular and annular apertures. Simple electrostatic problems are presented to illustrate the mode-matching method in terms of the Hankel and Weber transforms. Various types of Weber transform are discussed with boundary-value problems. Electromagnetic radiation and scattering from circular and annular aperture geometries are summarized. The utility of the mode-matching method in circular and annular aperture scattering is emphasized.