In 1985, Kues et al. (Bioelectromagnetics, 6, pp.177-188, 1985) reported that corneal endothelial abnormalities were observed after a 4-hour exposure of anesthetized monkey eyes to 2.45GHz CW. We have traced their experimental study without anesthetization. Although we irradiated with power density exceeding the threshold of 30mW/cm2 obtained by them, we could not observe the same abnormalities as they did.

The biological effects of power frequency electric and magnetic fields have been a source of concern for the past many years, especially since 1979 when an epidemiological study report suggested a positive relationship between childhood cancer and exposure to power frequency electromagnetic fields from residential overhead power lines. The extensive studies of dosimetry and biological effects have since been carried out. It is believed that power frequency electromagnetic fields does induce biological effects (no serious threat to human health). The clear explanations for the possible interaction mechanisms remain to be identified. The problem with the study on dosimetry has been lack of theory that applies to the physical interaction of power frequency electric and magnetic fields with humans. At present, it seems to be widely accepted that the density of induced currents in the human body can be used as the decisive parameter in evaluating human exposure to these fields. In order to predict the distribution of induced current density inside a human body exposed to electric fields, magnetic fields, or electric and magnetic fields that coexist, the precise measurements of electromagnetic environments are necessary. According to necessity, the fields have to be characterized in terms of strength, orientation and phase angle. This paper presents: (1) Measurements of power frequency electromagnetic environments in 187kV substation yard and in the vicinity of the ground under 187 kV line using laboratory-made instruments; (2) Development of magnetic field exposure monitor; and (3) Review of state of the art of theoretical dosimetry for electric fields, magnetic fields and combined electric and magnetic fields, and evaluation method of human exposure for the future research.

We developed an automatic data processing algorithm for a ground-probing radar which is essential in analyzing a large amount of data by a non-expert. Its aim is to obtain an optimum result that the conventional technique can give, without the assistance of an experienced operator. The algorithm is general except that it postulates the existence of at least one isolated target in the radar image. The raw images of underground objects are compressed in the vertical and the horizontal directions by using a pulse-compression filter and the aperture synthesis technique, respectively. The test function needed to configure the compression filter is automatically selected from the given image. The sensitivity of the compression filter is adjusted to minimize the magnitude of spurious responses. The propagation velocity needed to perform the aperture synthesis is determined by fitting a hyperbola to the selected echo trace. We verified the algorithm by applying it to the data obtained at two test sites with different magnitude of clutter echoes.

This paper theoretically and experimentally investigates the mutual coupling between two ports of dual slot-coupled circular microstrip antennas. Presented are the effects of feed configuration, slot length, slot offset from the circular disk center, circular disk radius and the dielectric constant of the feed substrate on the mutual coupling. Based on these results, the antenna with low mutual coupling was designed. The mutual coupling of under -35dB at the resonant frequency was obtained.

The effect of intersymbol interference resulting from non-matched receiver filtering on the bit error rate (BER) performance of π/4-DQPSK systems recently adopted in the North American and Japanese digital cellular standards, is analyzed in Rayleigh fading. With a Gaussian or a Butterworth (of order N, 2N10) receiver filter, the BER performance is found to degrade by only a small fraction of a decibel from the performance with ideally matched receiver filters. A 4th-order Butterworth receiver filter leads to BER curves which almost coincide with those of the ideally matched filtering condition.

Transmission characteristics of CPW bends having various curvatures and a fixed bend angle were measured. It was found that the transmission level shows dips at some particular frequencies, and that the dips are less pronounced as the radius of curvature becomes larger.

We describe a new water sensing system for optical fiber cable networks. This system consists of optical fibers, water sensors and an OTDR (Optical Time Domain Reflectometer). The water sensor contains material which swells on contact with water and bends the optical fiber. The OTDR monitors the optical loss increase caused by this fiber bending and determines its location. In this system it is very important to determine the loss increase caused by the water sensor in terms of the OTDR performance. Therefore, we clarified the relationship between the water sensor structure and the increase in loss. Based on this study, we fabricated a sensor which causes a 5dB loss increase. The measured value is very close to the calculated value.

This paper surveys the researches on biological and electeromagnetic environments in RF (radio frequency) and microwave regions in Japan. Publicized research reports on biological objectives, evaluation of exposure rate, electromagnetic environments and guideline for the protection from radio wave nuisances are briefly introduced. Some researches on the evaluation of the exposure rate caused by the near field effect of portable radio transceiver are reviewed. Radio frequency exposer protection guidelines in Japan are also described.

This paper presents an experimental study on the penetration characteristics of submillimeter waves in biological tissues and material. The measured values of the penetration depth in excised natural muscle, fat, and aqueous solution of protein, bovine serum albumin (BSA), over the wavelengths of 281 through 496µm are presented. Penetration depths at these wavelengths are 0.11-0.17mm in the natural pork muscle, and 0.69-0.98mm in the natural pork fat, and are the larger at the longer wavelengths. The values vary considerably from sample to sample. Since the measurement of the penetration depth in this study is shown sufficiently reproducible, the variation of the measured penetration depth is attributed to the variation of natural tissues such as that in water content. It is found that the penetration depth of submillimeter waves in aqueous solution of BSA depends almost linearly on the amount of protein content in the solution, and that the typical values of the penetration depth in the natural muscle roughly agree with that in the 35% aqueous solution of BSA in the submillimeter-wave region.

It is important to obtain a low coefficient sensitivity digital filter. This paper presents a new low coefficient sensitivity network structure that consists of a second order digital filter and a feedback path. This network structure is based on the effectiveness of the feedback path in an analog system. The coefficient sensitivity of the proposed digital filter can be control with the coefficient of the feedback path. Using this property, the digital filter with the low coefficient sensitivity is obtained. To add the feedback path makes the frequency response deviate from the characteristic of the original second order digital filter, but the deviation can be compensated with the other coefficients. A nonlinear optimization technique is employed to determine the coefficients of the digital filter. The proposed method is not effective only to narrow-band low-pass but wide-band low-pass filters.

A noninvasive method for measuring complex permittivity of biological tissues is proposed. The noninvasive method is based on an inverse scattering technique which employs an iterative procedure. The iterative procedure consists of solving an electric field integral equation using the method of moments and minimizing the square difference between calculated and measured scattered fields. Implementation of the noninvasive method requires the knowledge of the target shape, the incident and measured scattered fields. Based on the noninvasive method, a measuring system of complex permittivity is developed and its reliability is verified.

From the standpoint of studying the biological effects of microwaves on human eyes, this paper numerically examines the specific absorption rate (SAR) inside the eyeball, using the finite-difference time-domain (FD-TD) method, which does not require very much computer storage. Two kinds of highly heterogeneous models constructed by us and Taflove's group are used to compute the SARs inside the eyeball for 1.5-GHz microwave exposure under the 1991 ANSI protection guideline. The SAR contour lines and the spatial distribution are shown inside the eyeball. Comparison is also made between the SARs for the two computation models.

The radiation patterns of a circularly polarized GPS microstrip disk antenna mounted on the roof of a car are analyzed using UTD. Based upon the excellent agreements between the calculated and the measured results in all the observation directions, the effects of the antenna location upon radiation patterns are discussed in detail. As the distance between the antenna and the edge decreases, the gain in the low elevation angle on the same side as the edge considerably decreases. The effects of the earth are also extracted. They cause the fine ripples in the low elevation angle, though they are negligible in macroscopical view. Furthermore, the validity of the simple design neglecting the earth and the plates other than roof is investigated. The errors are localized at low elevation angle. The results obtained in this paper are useful in the design of the general antennas for mobile communication.

The plane wave diffraction by a two-dimensional parallel-plate waveguide cavity with partial material loading is rigorously analyzed for both the E and the H polarization using the Wiener-Hopf technique. Introducing the Fourier transform for the scattered field and applying boundary conditions in the transform domain, the problem is formulated in terms of the simultaneous Wiener-Hopf equations satisfied by the unknown spectral functions. The Wiener-Hopf equations are solved exactly via the factorization and decomposition procedure leading to the formal solution, which involves branch-cut integrals with unknown integrands as well as infinite series with unknown coefficients. Applying rigorous asymptotics with the aid of the edge condition, the approximate solution to the Wiener-Hopf equations is derived in the form suitable for numerical computations. The scattered field inside and outside the cavity is evaluated by taking the inverse Fourier transform together with the use of the saddle point method. Numerical examples of the radar cross section are presented for various physical parameters, and the far field backscattering characteristics of the cavity are discussed in detail. Some comparisons with a high-frequency technique are also given to validate the present method.

Binary decision diagrams (BDD's) are graph representations of Boolean functions, and at the same time they can be regarded as a computational model. In this paper, we discuss relations between BDD's and other computational models and clarify the computational power of BDD's. BDD's have the property that each variable is examined only once according to a total order of the variables. We characterize families of BDD's by on-line deterministic Turing machines and families of permutations. To clarify the computational power of BDD's, we discuss the difference of the computational power with respect to the way of reading inputs. We also show that the language TADGAP (Topologically Arranged Deterministic Graph Accessibility Problem) is simultaneously complete for both of the class U-PolyBDD of languages accepted by uniform families of polynomial-size BDD's and the clas DL of languages accepted by log-space bounded deterministic Turing machines. From the results, we can see that the problem whether U-PolyBDD U-NC1 is equivalent to a famous open problem whether DL U-NC1, where U-NC1 is the class of languages accepted by uniform families of log-depth constant fan-in logic circuits.

A new built-in drive circuit for superconducting Josephson LSI circuits has been designed and fabricated in a ceramic multichip module. The drive circuit consists of an impedance matching circuit and a DC bias current feeding circuit to supply a two-phase power current to Josephson chips at a microwave frequency. The impedance matching circuit was designed based on a quarter wavelength stripline. A balanced stripline configuration was introduced to reduce the fluctuation of ground potential. Tungsten layers were used to make the drive circuit in a multilayer ceramic substrate of the multichip module. Whole circuit was successfully packed in a volume of 76 mm38 mm1.7 mm. The gain of microwave current were 20 dB around 1.2 GHz and 23 dB around 3.6 GHz, which were in good agreement with the simulated current gain.

This paper presents an optimal filtering algorithm using the covariance information in linear continuous distributed parameter systems. It is assumed that the signal is observed with additive white Gaussian noise. The autocovariance function of the signal, the variance of white Gaussian noise, the observed value and the observation matrix are used in the filtering algorithm. Then, the current filter has an advantage that it can be applied to the case where a partial differential equation, which generates the signal process, is unknown.

The performance of parallel combinatory spread spectrum (PC/SS) communication systems in the frequency-nonselective, slowly Rayleigh fading channel is studied. Performance is evaluated by symbol error rate using numerical computation. To overcome the performance degradation caused by fading, we also studied the effects of selection diversity and Reed-Solomon coding applied to the PC/SS system. As a result, a remarkable improvement in error rate performance is achieved with Reed-Solomon coding and diversity technique. The coding rate for the maximum coding gain is almost a half of that in the additive white gaussian noise channel.

This paper studies the effect of frequency re-using patterns on the channel capacity in the forward link of orthogonal code division multiple access (CDMA) cellular systems. The received carrier-to-interference ratio (CIR) determined by computer simulation shows that re-using the same frequency channel on every third sector (3-sector layout) provides superior channel capacity than does every-sector re-use (1-sector layout).

A new design methodology is proposed and analyzed for the design of ternary logic systems. In the new ternary logic systems, no conversions among radices are required and only the two-state ternary literals associated with the ternary signals are transmitted in the whole system. With the new design methodology, the ternary systems can be realized by the dynamic CMOS logic circuits which are simple and fully compatible with those of the conventional binary logic circuits in process, power supply, and logic levels. A new dynamic differential logic called the CMOS Redundant Differential Logic (CRDL) is also developed to increase the logic flexibility and the circuit performance. Using the new design methodology and the CRDL circuits, the multiplier with redundant binary addition tree is designed in both non-pipelined and pipelined systems. The experimental chip has been fabricated and measured, which successfully verifies the correctness of the logic functions and the speed performance of the designed circuits.