The Weil descent attack, suggested by Frey, has been implemented by Gaudry, Hess and Smart (the so-called GHS attack) on elliptic curves over finite fields of characteristic two and with composite extension degrees. Recently, Diem presented a general treatment of the GHS attack to hyperelliptic curves over finite fields of arbitrary odd characteristics. This paper shows that Diem's approach can be extended to curves of which the function fields are cyclic Galois extensions. In particular, we show the existence of GHS Weil restriction, triviality of the kernel of GHS conorm-norm homomorphism, and lower/upper bounds of genera of the resulting curves.

Newly designed cyclometalated iridium phosphors bearing 2,3-diphenylquinoxalines were characterized to provide highly efficient and vivid-red emitting materials for electrophosphorescent organic light-emitting devices. Excellent quantum efficiencies for photoluminescence (PL) within a range 50-79% were observed in dichloromethane solutions at room temperature. A greatly improved PL decay lifetime of 1.1 µsec was also observed in CBP coevaporated film. Luminescence peak wavelengths of the phosphors lay within a preferable range 653-675 nm in evaporated films. The most vivid-red electroluminescence with 1931 CIE chromaticity coordinates of (x=0.70, y=0.28) was successfully attained.

This paper proposes a simple control method to improve the ignition behavior of cold cathode fluorescent lamp (CCFL) in digital-dimming control. Due to restriking manipulation in digital-dimming mode, the lamp life of CCFL is reduced substantially. To extend the lamp life, we realize a digital-dimming controller with soft-starting technique (DDC-SST) to reduce the high ignition voltage and to eliminate the ignition current spike. The half-bridge resonant inverter is employed in the presented backlight system. Complete analysis and design considerations are discussed in detail in this paper. Simulation and experimental results are close to the theoretical prediction. The overall efficiency of the system achieved at the rated power is over 91%. The ignition voltage is reduced about 30% without any lamp current spike occurred under digital-dimming operation.

Theoretical calculation has been done on the decay time of photoluminescence of Ir(ppy)3 dissolved in tetrahydrofuran and its temperature dependence at 1.2-300 K. Taking into account that the emitting triplet state consists of three zero-field splitting substates and taking into account one-phonon non-radiative transitions among these substates, the rate equations for the populations of these substates have been obtained. Three decay components are derived by solving not only the secular equation but also the rate equations, where the slow decay time shows decrease from 145 to 2 µs with increasing temperature from 1.2 to 300 K. A good agreement has been obtained for the temperature dependence between the calculated slow decay time and the observed one.

Time resolved photoluminescence measurements of lanthanide and group III metal chelates of 8-hydroxyquinoline (Q) have been performed as a function of temperature and excitation wavelength. For the lanthanide complexes it has been shown that either singlet or triplet luminescence can be observed depending on the excitation wavelength. Lifetime measurements of these emissions show that competing non-radiative paths are very important in the performance of these molecules. For ErQ we have shown that it is the singlet state that couples most efficiently to the ion. Radiative lifetime measurements of the ion emission show relatively short lifetimes that are indicative of quenching mechanisms. For the group III metal chelates at room temperature the luminescence is dominated by the singlet emission but at 80 K there is evidence that triplet emission can occur when the molecule is excited at long wavelengths. Luminescence lifetime measurements of the emission from the lanthanide ions: erbium, neodymium and ytterbium all show effective lifetimes of the order of microseconds which is very fast compared to the lifetimes of the free ions. Using excitation directly into the lanthanide ion (e.g.980 nm excitation for erbium) and via the organic ligands (400 nm excitation) we have seen that there are no changes in the emission lifetimes and hence the exciton transfer from the ligand to the lanthanide ion is not a rate limiting step.

Charge carrier generation, transport, and exciton diffusion in f ac tris(2-phenylpyridine)iridium(III) Ir(ppy)3 doped in 4,4'-N,N'-dicarbazole-biphenel (CBP) thin films, an emissive layer of green electrophosphorescent devices, have been studied in terms of time-of-flight (TOF) transient photocurrent, steady-state photocurrent and time-resolved photoluminescence (PL) spectroscopies. It is found that the excitation energy rapidly transfer from CBP to Ir(ppy)3, and that the charge carriers are generated on Ir(ppy)3 sites. With increasing Ir(ppy)3 concentration, the electron drift mobility is slightly decreased, while the hole transit signals become unobservable. The electron and hole transport properties of Ir(ppy)3 doped CBP thin films result from the energy levels of the lowest unoccupied molecular orbital and the highest occupied molecular orbital of Ir(ppy)3 with respect to those of CBP. From steady-state photocurrent measurement, the diffusion lengths of 3.5% and 7.0% Ir(ppy)3 doped CBP thin films are determined to be 21 nm and 50 nm, respectively.

We have demonstrated improvement in the efficiency of TDAPB-based OLEDs. The external quantum efficiency of 8.2% and a power efficiency of 17.3 lm/W were achieved. The results suggest that using the starburst small-molecule TDAPB allows for easy fabrication and is effective for achieving high efficiencies in simple device structures.

The driving frequency dependence of EL characteristics were investigated in thick ceramic insulating type thin-film electroluminescent (TFEL) devices with various Mn-activated Y2O3-based phosphor thin-film emitting layers driven by a sinusoidal wave voltage. High luminous efficiencies of approximately 10 and 1 lm/W were obtained in the TFEL devices driven at 60 Hz and 1 kHz, respectively. The difference in luminous efficiency was mainly caused by the increase of input power in 1 kHz-driven-devices resulting from a dielectric loss of a thick BaTiO3 ceramic sheet used as the insulating layer. The correlation between the sound emission from the devices and the effective power consumed in the devices was found with variations in both the applied voltage and the frequency. The higher input power of the 1 kHz-driven-device may be attributable to sound emissions resulting from the piezo-electricity of BaTiO3 ceramics.

A large-swing, high-driving, low-power, class-AB buffer amplifier, which consists of a high-gain input stage and a unity-gain class-AB output stage, with low variation of quiescent current is proposed. The low power consumption and low variation of the quiescent output current are achieved by using a weak-driving and a strong-driving pseudo-source followers. The high-driving capability is mainly provided by the strong-driving pseudo-source follower whose output transistors are turned off in the vicinity of the stable state to reduce the power consumption and the variation of output current, while the quiescent state is maintained by the weak-driving pseudo-source follower. The error amplifiers with source-coupled pairs of the same type transistors are merged into a single error amplifier to reduce the area of the buffer and the current consumption. An experimental prototype buffer amplifier implemented in a 0.35-µm CMOS technology demonstrates that the circuit dissipates an average static power consumption of only 388.7 µW with the standard deviation of only 3.4 µW, which is only 0.874% at a power supply of 3.3 V, and exhibits the slew rates of 2.18 V/µs and 2.50 V/µs for the rising and falling edges, respectively, under a 300 Ω /150 pF load. Both of the second and third harmonic distortions (HD2 and HD3) are -69 dB at 20 kHz under the same load.

This paper describes the design of a programmable QAM transceiver for VDSL applications. A 12-b DAC with 64-dB spurious-free dynamic range (SFDR) at 75-MS/s and an 11-b ADC with 72.3-dB SFDR at 70-MS/s are integrated in this complete physical layer IC. A digital IIR notch filter is included in order to not interrupt existing amateur radio bands. The proposed dual loop AGC adjusts the gain of a variable gain amplifier (VGA) to obtain maximum SNR while avoiding saturation. Using several low power techniques, the total power consumption is reduced to 300-mW at 1.8-V core and 3.3-V I/O supplies. The transceiver is fabricated in a 0.18-µm CMOS process and the chip size is 5-mm 5-mm. This VDSL transceiver supports 13-Mbps data rate over a 9000-ft channel with a BER < 10-7.

All-CMOS radio transceivers and systems-on-a-chip are rapidly making inroads on a wireless market that for years was dominated by bipolar and BiCMOS solutions. It is not a matter of replacing bipolar transistors in known circuit topologies with FETs; the wave of RF-CMOS brings with it new architectures and unprecedented levels of integration. What are its origins? What is the commercial impact? How will RF-CMOS evolve in the future? This paper offers a retrospective and a perspective.

Applying the formerly proposed classification framework for first order line search optimization techniques we introduce novel superlinear first order line search methods. Novelty of the methods lies in the line search subproblem. The presented line search subproblem features automatic step length and momentum adjustments at every iteration of the algorithms realizable in a single step calculation. This keeps the computational complexity of the algorithms linear and does not harm the stability and convergence of the methods. The algorithms have none or linear memory requirements and are shown to be convergent and capable of reaching the superlinear convergence rates. They were practically applied to artificial neural network training and compared to the relevant training methods within the same class. The simulation results show satisfactory performance of the introduced algorithms over the standard and previously proposed methods.

We have proposed a new low-IF transceiver architecture to simultaneously achieve both a small chip area and good minimum input sensitivity. The distinctive point of the receiver architecture is that we replace the complicated high-order analog filter for channel selection with the combination of a simple low-order analog filter and a sharp digital band-pass filter. We also proposed a high-speed convergence AGC (automatic gain controller) and a demodulation block to realize the proposed digital architecture. For the transceiver, we further reduce the chip area by applying a new form of direct modulation for the VCO. Since conventional VCO direct modulation tends to suffer from variation of the modulation index with frequency, we have developed a new compensation technique that minimizes this variation, and designed the low-phase noise VCO with a new biasing method to achieve large PSRR (power-supply rejection ratio) for oscillation frequency. The test chip was fabricated in 0.35-µm BiCMOS. The chip size was 3 3 mm2; this very small area was realized by the advantages of the proposed transceiver architecture. The transceiver also achieved good minimum input sensitivity of -85 dBm and showed interference performance that satisfied the requirements of the Bluetooth standard.

This paper describes a VLSI-oriented motion estimation algorithm using a steepest descent method (SDM) applied to MPEG-4 visual communication with a mobile terminal. The SDM algorithm is optimized for QCIF or CIF resolution video and VLSI implementation. The SDM combined with a subblock search method is developed to enhance picture quality. Simulation results show that a mean PSNR drop of the SDM algorithm processing QCIF 15 fps resolution video in comparison with a full search algorithm is -0.17 dB. Power consumption of a VLSI based on the SDM algorithm assuming 0.18 µm CMOS technology is estimated at 2 mW. The VLSI attains higher picture quality than that based on the other fast motion estimation algorithm, and is applicable to mobile video applications.

This paper describes a full-CMOS single-chip Bluetooth LSI fabricated using a 0.18 µm CMOS, triple-well, quad-metal technology. The chip integrates radio and baseband, which is compliant with Bluetooth Core Specification version 1.1. A direct modulation transmitter and a low-IF receiver architecture are employed for the low-power and low-cost implementation. To reduce the power consumption of the digital blocks, it uses a clock gating technique during the active modes and a power manager during the low power modes. The maximum power consumption is 75 mW for the transmission, 120 mW for the reception and 30 µW for the low power mode operation. These values are low enough for mobile applications. Sensitivity of -80 dBm has been achieved and the transmitter can deliver up to 4 dBm.

In this paper, a novel Wold decomposition algorithm is proposed to address the issue of deterministic component extraction for texture images. This algorithm exploits the wavelet-based singularity detection theory to process both harmonic a nd evanescent features from frequency domain. This exploitation is based on the 2D Lebesgue decomposition theory. When applying multiresolution analysis techniq ue to the power spectrum density (PSD) of a regular homogeneous random field, its indeterministic component will be effectively smoothed, and its deterministic component will remain dominant at coarse scale. By means of propagating these positions to the finest scale, the deterministic component can be properly extracted. From experiment, the proposed algorithm can obtain results that satisfactorily ensure its robustness and efficiency.

In this letter, we propose a groupwise successive interference cancellation (GSIC) receiver with gradient descent search for multi-rate DS-CDMA system. Proposed receiver incorporates iterative gradient descent search algorithm into conventional GSIC receiver for multi-rate DS-CDMA system. It is shown that the receiver achieves significant performance improvement over the matched filter (MF) receiver, GSIC receiver, multi-stage parallel interference cacnellation (PIC) receiver, multi-stage partial PIC receiver, and GSIC receiver with PIC in a Rayleigh fading channel.

Scenarios that describe concrete situations of software operation play an important role in software development and especially in requirements engineering. Scenario details should vary in content when described from different viewpoints, but this presents a difficulty, because an informal scenario from one viewpoint can not easily be transformed into a scenario from another viewpoint with consistency and assurance. This paper describes (1) a language for describing scenarios in which simple action traces are embellished to include typed frames based on a simple case grammar of actions, and (2) a method to accomplish the transformation between scenarios from different viewpoints based on the scenario description language.

Goal-oriented analysis and use case analysis are well known requirements analysis methods and are putting into practice. Roughly speaking, goal-oriented methods are suitable for eliciting constraints to a system and use case analysis methods elicit concrete system behavior. Thus these methods are complementary and their integration into a new method allows us to get a more powerful requirements elicitation method. This paper proposes a new method where both of the methods are amalgamated. In our method, constraints to the system are refined by goal-oriented style, while system behavior are described with hierarchical use cases. Since a use case is made relate to goals during our elicitation processes, the decomposition of goals and use cases are complementally supported. Furthermore we applied our method to a couple of development projects and assessed its effectiveness.

Simple genetic algorithm (SGA) is a population-based optimization method based on the Darwinian natural selection. The theoretical foundations of SGA are the Schema Theorem and the Building Block Hypothesis. Although SGA does well in many applications as an optimization method, it still does not guarantee the convergence of a global optimum in GA-hard problems and deceptive problems. As an alternative schema, therefore, there is a growing interest in a co-evolutionary system where two populations constantly interact and cooperate each other. In this paper we propose a schema co-evolutionary algorithm (SCEA) and show why the SCEA works better than SGA in terms of an extended schema theorem. The experimental analyses using the Walsh-Schema Transform show that the SCEA works well in GA-hard problems including deceptive problems.