This paper starts by describing the advantages of cascaded modulation, i.e., using multiple concatenated external modulators to modulate CW (Continuous Wave) light. Next, the paper examines computer simulations of the resulting modulated light waveform shapes and intermodulation distortion values to elucidate the basic modulation characteristics of a cascaded modulation scheme. Examples of applying cascaded modulation to a multi-channel optical signal transmission system are shown, and the characteristics are clarified by optical transmission experiments. For example, the dependency of the signal quality on the modulation depth values of each external modulator is clarified. Moreover, experiments show that cascaded modulation permits the remote insertion of local broadcast programs into wide area broadcast programs. Last, the paper shows that cascaded modulation offers better modulation properties than the conventional single modulation approach.

Adaptive modulation is an efficient method to increase the spectral efficiency of OFDM based high-speed wireless data transmission systems in multipath channel. Blind modulation classification schemes play an important role in adaptive modulation systems, eliminating the need for transmitting modulation information, thereby increasing spectral efficiency. In this paper, a novel blind modulation classification algorithm is derived from the finite alphabet property of information symbols and the equivalent parallel model of OFDM systems. The performances of the proposed algorithm and M2M4P algorithm [1] are tested and compared using Monte-Carlo simulations. It is found that, the novel algorithm yields performance better than that of M2M4P algorithm and with much less complexity.

A highly accurate measurement method of parameters of MZ-type LN optical intensity modulators is presented. In this method, a CW optical signal is input to an optical terminal and small CW RF signal is applied to an electrode of the modulator. Then sideband levels of an output optical signal at different bias points are measured by using optical spectrum analyzer. By using 1st order sideband levels which are measured at two different bias conditions, and using a compensation method to measured levels, we can obtain accurate chirp parameter even when very small power of RF signal is applied to the modulator. In this method, the chirp parameter can be obtained in good accuracy when the input RF voltage is only 3% of the halfwave voltage.

Decoding performance of LDPC (Low-Density Parity-Check) codes is highly dependent on the degree distributions of the Tanner graphs which define the LDPC codes. We compare two LDPC code ensembles, one has a uniform degree distribution and the other a non-uniform one over a BEC (Binary Erasure Channel) and a BSC (Binary Symmetric Channel) thorough DE (Density Evolution). We then derive sufficient conditions on the erasure probability of a BEC and the error probability of a BSC, under which the LDPC code ensembles with uniform degree distributions outperform those with non-uniform degree distributions.

An effective way to boost power gain without noise figure degradation in a cascode low noise amplifier (LNA) is demonstrated at 4 GHz using 0.35 µm SiGe HBT technology. This approach maintains the same current consumption because a low-pass π-type LC matching network is inserted in the inter-stage of a conventional cascode LNA. 5 dB gain enhancement with no noise figure degradation at 4 GHz is observed in the SiGe HBT LNA with inter-stage matching.

Substrate-coupling equivalent circuits can be derived for arbitrary isolation structures by F-matrix computation. The derived netlist represents a unified impedance network among multiple sites on a chip surface as well as internal nodes of isolation structures and can be applied with SPICE simulation to evaluate isolation strengths. Geometry dependency of isolation attributes to layout parameters such as area, width, and location distance. On the other hand, structural dependency arises from vertical impurity concentration specific to p+/n+ diffusion and deep n-well. Simulation-based prototyping of isolation structures can include all these dependences and strongly helps establish an isolation strategy against high-frequency substrate coupling in a given technology. The analysis of isolation strength provided by p+/n+ guard ring, deep n-well guard ring as well as deep n-well pocket well explains S21 measurements performed on high-frequency test structures targeting 5 GHz bandwidth, that was formed in a 0.25-µm CMOS high frequency.

This paper deals with the singular behavior of the diffraction of transverse magnetic (TM) waves by a perfectly conductive triangular periodic surface at a low grazing limit of incidence. The wave field above the highest excursion of the surface is represented as a sum of Floquet modes with modified diffraction amplitudes, whereas the wave field inside a triangular groove is written as a sum of guided modes with unknown mode amplitudes. Then, two sets of equations are derived for such amplitudes. From the equation sets, all the amplitudes are analytically shown to vanish at a low grazing limit of incidence. From this fact, it is concluded analytically that no diffraction takes place and only reflection occurs at a low grazing limit of incidence for any period length and any triangle height. This theoretical result is verified by a numerical example.

This paper presents the Physical Optics field calculation in terms of only line integrations by using the Modified Edge Representation technique (MER), the alternative way of the surface integration. Not only the diffracted fields as in the conventional method of equivalent edge currents (EEC) but also the scattering geometrical optics fields are expressed in terms of the MER line integrals. The far field patterns of parabolic reflector antennas with the defocused dipole feed are discussed and the satisfactory agreement with those obtained by the Physical Optics surface integration is demonstrated.

This paper proposes a two-dimensional self-matching receiver for Free Space Optics (FSO) communication system using chaotic spatial synchronization. This system is able to obtain the information of two-dimensional code from received pattern. This paper considers that proposed system is applied to two applications. The first application is image transmission. This paper shows that applying proposed system to image transmission enables to restore the desired image, which doesn't require strict alignment of receiver, and evaluates transmission optical power. The second application is Code Division Multiplexing (CDM). This paper shows that applying proposed system to CDM system enables to demodulate desired digital signals regardless of the uncertainty of received position. Moreover, the required transmission optical power and bit error rate performance are obtained by computer simulation.

We propose a stability-guaranteed horizon size (SgHS) for stabilizing receding horizon control (RHC). It is shown that the proposed SgHS can be represented explicitly in terms of the known parameters of the given system model and is independent of the terminal weighting matrix in the cost function. The proposed SgHS is validated via a numerical example.

Recently, Wu-Chieu proposed an improvement to their original scheme, in order to make the scheme withstand impersonation attacks. However, the improved scheme is susceptible to an off-line password guessing attack and is inefficiently designed. Accordingly, the current letter demonstrates the vulnerability of Wu-Chieu's modified scheme to an off-line password guessing attack and evaluates the efficiency of their schemes and related schemes.

Simultaneous all-optical frequency up/downconversion technique utilizing a single semiconductor optical amplifier Mach-Zehnder interferometer (SOA-MZI) for full-duplex WDM radio over fiber (RoF) applications is presented. Using this technique, error-free simultaneous upconversion and downconversion of RoF signals with a finite-length single mode fiber were experimentally demonstrated. The results show the potential of the proposed scheme for use in a cost-effective full-duplex WDM RoF link.

We study on the security proof of the improved efficient-Rabin (ERabin) scheme and the F-FDHS scheme. First, we show that the security theorem of the improved ERabin scheme is not correct, and then provide a correct theorem for it. Second, we show that the security theorem of the F-FDHS scheme lacks an assumption. Finally, we present a way to modify the improved ERabin scheme and the F-FDHS scheme.

A 5.2 GHz 1 dB conversion gain, IP1 dB = -19 dBm and IIP3= -9 dBm double quadrature Gilbert downconversion mixer with polyphase filters is demonstrated by using 0.35 µm SiGe HBT technology. The image rejection ratio is better than 47 dB when LO=5.17 GHz and IF is in the range of 15 MHz to 45 MHz. The Gilbert downconverter has four-stage RC-CR IF polyphase filters for the image rejection. Polyphase filters are also used to generate LO and RF quadrature signals around 5 GHz in the double quadrature downconverter.

Novel functionality and material were developed for Si-photonics in this study. Ultra-fast silicon all optical switches using two-photon absorption (TPA) were developed in silicon nanowire optical waveguide on silicon-on-insulator substrate. This waveguide can produce high optical intensities that yield optical nonlinearity such as TPA even at input optical powers typically used in fiber optic communication systems. In addition, we fabricated a GaSb based quantum well (QW) on a Si substrate. The emission wavelength of QW was 1.55 µm at room temperature, so that the new function can be developed on Si-photonics using this QW.

The uni-traveling-carrier photodiode (UTC-PD) is an innovative PD that has a unique operation mode in which only electrons act as the active carriers, resulting in ultrafast response and high electrical output power at the same time. This paper describes the features of the UTC-PD and its excellent performance. In addition, UTC-PD-based optoelectronic devices integrated with various elements, such as passive and active devices, are presented. These devices are promising for various applications, such as millimeter- and submillimeter-wave generation up to the terahertz range and ultrafast optical signal processing at data rates of up to 320 Gbit/s.

Band connections employed in active cancellation circuits for effective reduction of digital substrate noise are proposed. An almost-odd-symmetrical noise characteristic is utilized for canceling out noises. Advancing this idea, interlaced connections of four bands are also proposed. Excess cancellation by those bands is more effective for noise reduction in a guard ring than a cancellation by two bands. Use of L-shaped bands on the basis of the interlaced connection suppresses the noise more. Simulation and experimental results show that the proposed band connections reduce the noise.

A feature for classification of shallowly buried landmine-like objects using a ground penetrating radar (GPR) measurement system is proposed and its performance is evaluated. The feature for classification employed here is a time interval between two pulses reflected from top and bottom sides of landmine-like objects. First, we estimate a time resolution required to detect object thickness from GPR data, and check the actual time resolution through laboratory experiment. Next, we evaluate the classification performance using Monte Carlo simulations from dataset generated by a two-dimensional finite difference time domain (FDTD) method. The results show that good classification performance is achieved even for landmine-like objects buried at shallow depths under rough ground surfaces. Furthermore, we also estimate the effects of ground surface roughness, soil inhomogeneity, and target inclination on the classification performance.

This paper is intended to provide an alternative approach for the design of FIR filters by using a Hopfield Neural Network (HNN). The proposed approach establishes the error function between the amplitude response of the desired FIR filter and the designed one as a Lyapunov energy function to find the HNN parameters. Using the framework of HNN, the optimal filter coefficients can be obtained from the output state of the network. With the advantages of local connectivity, regularity and modularity, the architecture of the proposed approach can be applied to the design of differentiators and Hilbert transformer with significantly reduction of computational complexity and hardware cost. As the simulation results illustrate, the proposed neural-based method is capable of achieving an excellent performance for filter design.

An improved methodology, based on the genetic algorithm, is developed to design thermal-via structures and circuit parameters of advanced InGaP and InGaAs collector-up heterojunction bipolar transistors (C-up HBTs), which are promising miniature high-power amplifiers (HPAs) in cellular communication systems. Excellent simulated and measured results demonstrate the usefulness of this technique.