This paper proposes a new channel allocation algorithm for satellite communication systems. The algorithm is based on a spectrum division transmission technique as well as a spectrum compression transmission technique that we have developed in separate pieces of work. Using these techniques, the algorithm optimizes the spectrum bandwidth and a MODCOD (modulation and FEC error coding rate) scheme to balance the usable amount of satellite transponder bandwidth and satellite transmission power. Moreover, it determines the center frequency and bandwidth of each divided subspectra depending on the unused bandwidth of the satellite transponder bandwidth. As a result, the proposed algorithm enables flexible and effective usage of satellite resources (bandwidth and power) in channel allocations and thus enhances satellite communication (SATCOM) system capacity.

On rocket-borne GPS receivers, the high dynamics make the use of PLL is impractical and a FLL is used. This in turn leads to a string of errors on the demodulated navigation message. The present paper proposes two decoding algorithms for GPS navigation messages suited for strings of errors. The first philosophy uses parity check syndromes to correct demodulation errors. The second philosophy uses Log Correlation Ratio (LCR) comparison along with parity check syndromes to correct for the most probable error pattern. GPS data availability can be significantly improved by using the latter.

A novel 400-Gb/s (100-Gb/s4) physical-layer architecture for the next-generation Ethernet – using 100-Gb/s serial (optical single-wavelength) transmission – is proposed. As for the next-generation 400-Gb/s Ethernet, additional requirements from the market, such as power reduction and further miniaturization in addition to attaining even higher transmission speed, must be satisfied. To satisfy these requirements, a 100-Gb/s4 Ethernet physical-layer architecture is proposed. This architecture uses a 100-Gb/s serial (optical single-wavelength) transmission Ethernet and low-power technologies for a multi-lane transmission Ethernet. These technologies are implemented on a 100-Gb/s serial (optical single wavelength) transmission Ethernet using field-programmable gate arrays (FPGAs). Experimental evaluation of this implementation demonstrates the feasibility of low-power 400-Gb/s Ethernet.

NICT has developed a test model of an optically controlled beam-forming network (OBF) for a future multiple-beam antenna. The OBF test model consists of an electro-optic converter unit, an OBF unit, and an optoelectronic converter unit. A Ka-band OBF test model was manufactured to demonstrate the OBF. Radiation patterns obtained from the measured OBF data confirmed agreement between the expected and calculated results. Communication tests of the bit error rate (BER) for the digital communication link were performed. The results confirmed the OBF had no serious degradation below 1 dB of Eb/N0 on BER performance at 110-8.

In this paper, impulse noise removal for digital images is handled. It is well-known that switching-type processing is effective for the impulse noise removal. In the process, noise-corrupted pixels are first detected, and then, filtering is applied to the detected pixels. This switching process prevents distorting original signals. A noise detector is of course important in the process, a filter for pixel value restoration is also important to obtain excellent results. The authors have proposed a local similarity-based filter (LSF). It utilizes local similarity in a digital image and its capability against restoration of orderly regions has shown in the previous paper. In this paper, first, further experiments are carried out and properties of the LSF are revealed. Although LSF is inferior to an existing filter when disorderly regions are processed and evaluated by the peak signal-to-noise ratio, its outputs are subjectively adequate even in the case. If noise positions are correctly detected, capability of the LSF is guaranteed. On the other hand, some errors may occur in actual noise detection. In that case, LSF sometimes fails to restoration. After properties are examined, we propose two effective extensions to the LSF. First one is for computational cost reduction and another is for color image processing. The original LSF is very time consuming, and in this paper, computational cost reduction is realized introducing a search area. Second proposal is the vector LSF (VLSF) for color images. Although color images can be processed using a filter, which is for monochrome images, to each color component, it sometimes causes color drift. Hence vector processing has been investigated so far. However, existing vector filters do not excel in preservation of orderly pattern although color drift is suppressed. Our proposed VLSF is superior both in orderly pattern preservation and color drift suppression. Effectiveness of the proposed extensions to LSF is verified through experiments.

Optical orthogonal codes (OOCs) were introduced by Salehi, as signature sequences to facilitate multiple access in optical fibre networks. The existence of optimal (υ,3,1)-OOCs had been solved completely. Although there are some partial results, the existence of optimal (υ, 4, 1)-OOCs is far from settled. In this letter, three general constructions for (υ, 4, 1)-OOCs via perfect difference families are presented, new infinite classes of (υ, 4, 1)-OOCs are then obtained.

Variable-weight optical orthogonal codes (OOCs) were introduced by Yang for multi-media optical CDMA systems with multiple quality of service (QoS) requirements. Some works had been done on the existence of optimal (υ,W,1,Q)-OOCs for W ∈ {{3,4}, {3,5}, {4,5}}. In this paper, by using quadratic residues, seven new infinite classes of optimal (υ,{k,6},1,Q)-OOCs for k ∈ {3,4} are constructed.

Shisen-Sho is a tile-based one-player game. The instance is a set of 136 tiles embedded on 817 rectangular grids. Two tiles can be removed if they are labeled by the same number and if they are adjacent or can be connected with at most three orthogonal line segments. Here, line segments must not cross tiles. The aim of the game is to remove all of the 136 tiles. In this paper, we consider the generalized version of Shisen-Sho, which uses an arbitrary number of tiles embedded on rectangular grids. It is shown that deciding whether the player can remove all of the tiles is NP-complete.

In this paper, we propose an automatic parameter adjustment method for audio equalizers using an interactive genetic algorithm (IGA). It is very difficult for ordinary users who are not familiar with audio devices to appropriately adjust the parameters of audio equalizers. We therefore propose a system that can automatically adjust the parameters of audio equalizers on the basis of user's evaluation of the reproduced sound. The proposed system utilizes an IGA to adjust the gains and Q values of the peaking filters included in audio equalizers. Listening test results demonstrate that the proposed system can appropriately adjust the parameters on the basis of the user's evaluation.

Timing asynchronism strongly degrades the performance of analog network coded (ANC) bi-directional transmission. This letter investigates receiver design for asynchronous broadband bi-directional transmission over frequency selective fading channels. Based on time domain oversampling, we propose fractionally spaced frequency domain minimum mean square error (MMSE) equalizers for bi-directional ANC based on orthogonal frequency division multiplexing (OFDM) and cyclic prefixed single carrier (CP-SC) radio access. Simulation results show that the proposed fractionally spaced equalizer (FSE) can eliminate the negative effect of timing misalignment in bi-directional transmissions.

In LDMOS devices for high-voltage applications, there appears a notable fingerprint of current-voltage characteristics known as soft breakdown. Its mechanism is analyzed and modeled on LDMOS devices where a high resistive drift region exists. This analysis has revealed that the softness of breakdown, known as the expansion effect, withholding a run-away of current, is contributed by the flux of holes underneath the gate-overlap region originated by impact-ionization. The mechanism of the expansion effect is modeled and implemented into the compact model HiSIM_HV for circuit simulation. A good agreement between simulated characteristics and 2D-device simulation results is verified.

This paper proposes a video-quality estimation method based on a no-reference model for realtime quality monitoring in video-streaming services. The proposed method analyzes both bitstream information and decoded pixel information to estimate video-quality degradation by transmission errors. Video quality in terms of a mean squared error (MSE) between degraded video frames and error-free video frames is estimated on the basis of the number of impairment macroblocks in which the quality degradation has not been possible to be concealed. Error-concealment effectiveness is evaluated using motion information and luminance discontinuity at the boundaries of impairment regions. Simulation results show a high correlation (correlation coefficients of 0.93) between the actual MSE and the number of macroblocks in which error concealment has not been effective. These results show that the proposed method works well in reatime quality monitoring for video-streaming services.

Grazing incidence X-ray diffraction experiment proved that the a- and c-axes of PMDA-ODA crystals preferentially aligned in normal and parallel directions to rubbing at surface of rubbed film, and that polymer chains of residual amorphous phase aligned in rubbing direction.

Variable-weight optical orthogonal codes (OOCs) have application in multimedia optical code division multiple access (OCDMA) systems supporting multiple quality of services (QoS). In this paper, several combinatorial constructions for optimal variable-weight OOCs are presented explicitly. A useful recursive construction for optimal variable-weight OOCs is proposed as well. Based on these results, two new infinite classes of optimal variable-weight OOCs with Hamming weights 3 and 4 are obtained.

Limited Random Sequence (LRS) is quite important for Analog-to-Information Converter (AIC) because it determines the random sampling scheme and the resultant performance. LRS is established with the elements of “0” and “1”. The “1” appears randomly in the segment of the sequence, so that the production of the original signal and LRS can be considered as the approximation of the random sampling of the original signal. The random sampling result can perfectly recover the signal with Compressive Sensing (CS) algorithm. In this paper, a high order LRS is proposed for the AIC design in Distributed Compressive Sensing (DCS), which has the following three typical features: 1) The high order LRS has the elements of integer which can indicate the index number of the sensor in DCS. 2) High order LRS can adapt to the sparsity variation of the original signal detected by each sensor. 3) Employing the AIC with high order LRS, the DCS algorithm can recover the signal with very low sampling rate, usually above 2 orders less than the traditional distributed sensors. In the paper, the scheme and the construction algorithm of high order LRS are proposed. The performance is evaluated with the application studies of the distributed sensor network and the camera picture correspondingly.

An instrument that can efficiently measure individual competency of IT applications (ICITA) is presented. It allows an organization to develop and manage the IT application capability of individuals working in an enterprise IT environment. The measurement items are generated from the definition and major components of individual competency of IT applications. The reliability and validity of the instrument construct are verified by factor and correlation analysis. A 15-item instrument is proposed to efficiently measure individual competency of IT applications and the instrument will contribute to the improved ICITA of human resources working in an enterprise IT environment.

We observe that the state-of-the-art power-saving mechanisms (PSM) for IEEE 802.16e is neither optimal in terms of delay nor in terms of energy consumption. We propose a new PSM which achieves the optimality in terms of the average buffering delay without increasing energy consumption. In order to do so, we derive a formula which relates the average buffering delay to sleep intervals. Simulation results show that our scheme surpasses the BTE algorithm (used by the current IEEE 802.16e Mobile Stations) by 56.75–76% and the PSID algorithm by 8.52–24.39% in terms of the delay-energy consumption product.

Blind source separation (BSS) techniques are required for various signal decomposing issues. Independent component analysis (ICA), assuming only a statistical independence among stochastic source signals, is one of the most useful BSS tools because it does not need a priori information on each source. However, there are many requirements for decomposing multiple deterministic signals such as complex sinusoidal signals with different frequencies. These requirements may include pulse compression or clutter rejection. It has been theoretically shown that an ICA algorithm based on maximizing non-Gaussianity successfully decomposes such deterministic signals. However, this ICA algorithm does not maintain a sufficient separation performance when the frequency difference of the sinusoidal waves becomes less than a nominal frequency resolution. To solve this problem, this paper proposes a super-resolution algorithm for complex sinusoidal signals by extending the maximum likelihood ICA, where the probability density function (PDF) of a complex sinusoidal signal is exploited as a priori knowledge, in which the PDF of the signal amplitude is approximated as a Gaussian distribution with an extremely small standard deviation. Furthermore, we introduce an optimization process for this standard deviation to avoid divergence in updating the reconstruction matrix. Numerical simulations verify that our proposed algorithm remarkably enhances the separation performance compared to the conventional one, and accomplishes a super-resolution separation even in noisy situations.

This paper proposes a downlink multi-user transmission scheme for the amplify-and-forward(AF)-based multi-relay cellular network, in which Tomlinson-Harashima precoding(TH precoding) and interference alignment(IA) are jointly applied. The whole process of transmission is divided into two phases: TH precoding is first performed at base-station(BS) to support the multiplexing of data streams transmitted to both mobile-stations(MS) and relay-stations(RS), and then IA is performed at both BS and RSs to achieve the interference-free communication. During the whole process, neither data exchange nor strict synchronization is required among BS and RSs thus reducing the cooperative complexity as well as improving the system performance. Theoretical analysis is provided with respect to the channel capacity of different types of users, resulting the upper-bounds of channel capacity. Our analysis and simulation results show that the joint applications of TH precoding and IA outperforms other schemes in the presented multi-relay cellular network.

In this study, we propose a cooperative sensing with distributed pre-detection for gathering sensing information on shared primary system. We have proposed a system that gathers multiple sensing information by using the orthogonal narrowband signal; the system is called the orthogonal frequency-based sensing information gathering (OF-SIG) method. By using this method, sensing information from multiple secondary nodes can be gathered from the surrounding secondary nodes simultaneously by using the orthogonal narrowband signals. The advantage of this method is that the interference from each node is small because a narrowband tone signal is transmitted from each node. Therefore, if appropriate power and transmission control are applied at the surrounding nodes, the sensing information can be gathered in the same spectrum as the primary system. To avoid interference with the primary receiver, we propose a cooperative sensing with distributed pre-detection for gathering sensing information in each node by limiting sensing node power. In the proposed method, the number of sensing information transmitting nodes depends on the pre-detection ability of the individual sensing at each node. Then the secondary node can increase the transmit power by improving the sensing detection ability, and the secondary node can gather the sensing information from the surrounding secondary nodes which are located more far by redesign the transmit power of the secondary nodes. Here, we design the secondary transmit power based on OF-SIG while considering the aggregated interference from multiple sensing nodes and individual sensing ability. Finally we confirm the performance of the cooperative sensing of the proposed method through computer simulation.