This letter is concerned with incorrigible sets of binary linear codes. For a given binary linear code C, we represent the numbers of incorrigible sets of size up to ⌈3/2d - 1⌉ using the weight enumerator of C, where d is the minimum distance of C. In addition, we determine the incorrigible set enumerators of binary Golay codes G23 and G24 through combinatorial methods.

In this study, a blind carrier frequency offset (CFO) estimation method is proposed using the time-frequency symmetry of the transmitted signals of a weighted Fourier transform (WFrFT) communication system. Blind CFO estimation is achieved by focusing on the property that results in matching the signal waveforms before and after the Fourier transform when the WFrFT parameter is set to a certain value. Numerical simulations confirm that the proposed method is more resistant to Rayleigh fading than the conventional estimation methods.

Short-range ambiguous clutter can seriously affect the performance of airborne radar target detection when detecting long-range targets. In this letter, a multiple-input-multiple-output (MIMO) array structure elevation filter (EF) is designed to suppress short-range clutter (SRC). The sidelobe level value in the short-range clutter region is taken as the objective function to construct the optimization problem and the optimal EF weight vector can be obtained by using the convex optimization tool. The simulation results show that the MIMO system can achieve better range ambiguous clutter suppression than the traditional phased array (PA) system.

This work presents the thermal noise analysis results of ring amplifiers in the MDAC of cyclic ADC. Ring amplifier is an alternative closed-loop structure for residual signal amplification with MDAC, and two types of ring amplifiers: pseudo-differential and fully-differential ring-amplifiers are considered for the implementation of MDAC in cyclic ADC. Theoretical analysis results show that power of thermal noise in MDAC with a pseudo-differential amplifier is much higher than that with a fully-differential ring-amplifier. SPICE simulation results with transient noise analyses also show the similar trend. Experimental prototype cyclic ADCs in 65nm CMOS technology are implemented with the same architecture and the same circuit components except for amplifiers. Comparison of the measured results of the two ADCs confirms the validity of the theoretical analysis results.

This paper proposes a deep neural network named BayesianPUFNet that can achieve high prediction accuracy even with few challenge-response pairs (CRPs) available for training. Generally, modeling attacks are a vulnerability that could compromise the authenticity of physically unclonable functions (PUFs); thus, various machine learning methods including deep neural networks have been proposed to assess the vulnerability of PUFs. However, conventional modeling attacks have not considered the cost of CRP collection and analyzed attacks based on the assumption that sufficient CRPs were available for training; therefore, previous studies may have underestimated the vulnerability of PUFs. Herein, we show that the application of Bayesian deep neural networks that incorporate Bayesian statistics can provide accurate response prediction even in situations where sufficient CRPs are not available for learning. Numerical experiments show that the proposed model uses only half the CRP to achieve the same response prediction as that of the conventional methods. Our code is openly available on https://github.com/bayesian-puf-net/bayesian-puf-net.git.

In this paper, some properties of Boolean functions via the unitary transform and c-correlation functions are presented. Based on the unitary transform, we present two classes of secondary constructions for c-bent4 functions. Also, by using the c-correlation functions, a direct link between c-autocorrelation function and the unitary transform of Boolean functions is provided, and the relationship among c-crosscorrelation functions of arbitrary four Boolean functions can be obtained.

Mutual coupling between antenna array elements will significantly degrade the performance of the array signal processing methods. Due to the Toeplitz structure of mutual coupling matrix (MCM), there exist some mutual coupling calibration algorithms for the uniform linear array (ULA) or uniform circular array (UCA). But few methods for other arrays. In this letter, we derive a new transformation formula for the MCM of the 7-elements hexagonal array (HA-7). Further, we extend two mutual coupling auto-calibration methods from UCA to HA by the transformation formula. Simulation results demonstrate the validity of the proposed two methods.

To obtain a full picture of potential applications for propagation-delay based X channels, it is important to obtain all feasible schemes of cyclic interference alignment including the encoder, channel instance, and decoder. However, when the dimension goes larger, theoretical analysis about this issue will become tedious and even impossible. In this letter, we propose a computer-aided solution by searching the channel space and the scheduling space, which can find all feasible schemes in details. Examples are given for some typical X channels. Computational complexity is further analyzed.

The problem caused by fake news continues to worsen in today's online social networks. Intuitively, it seems effective to issue corrections as a countermeasure. However, corrections can, ironically, strengthen attention to fake news, which worsens the situation. This paper proposes a model for describing the interaction between fake news and the corrections as a reaction-diffusion system; this yields the mechanism by which corrections increase attention to fake news. In this model, the emergence of groups of users who believe in fake news is understood as a Turing pattern that appears in the activator-inhibitor model. Numerical calculations show that even if the network structure has no spatial bias, the interaction between fake news and the corrections creates groups that are strongly interested in discussing fake news. Also, we propose and evaluate a basic strategy to counter fake news.

Reconfigurable intelligent surface (RIS) has the capability of boosting system performance by manipulating the wireless propagation environment. This paper investigates a downlink RIS-aided non-orthogonal multiple access (NOMA) system, where a RIS is deployed to enhance physical-layer security (PLS) in the presence of an eavesdropper. In order to improve the main link's security, the RIS is deployed between the source and the users, in which a reflecting element separation scheme is developed to aid data transmission of both the cell-center and the cell-edge users. Additionally, the closed-form expressions of secrecy outage probability (SOP) are derived for the proposed RIS-aided NOMA scheme. To obtain more deep insights on the derived results, the asymptotic performance of the derived SOP is analyzed. Moreover, the secrecy diversity order is derived according to the asymptotic approximation in the high signal-to-noise ratio (SNR) and main-to-eavesdropper ratio (MER) regime. Furthermore, based on the derived results, the power allocation coefficient and number of elements are optimized to minimize the system SOP. Simulations demonstrate that the theoretical results match well with the simulation results and the SOP of the proposed scheme is clearly less than that of the conventional orthogonal multiple access (OMA) scheme obviously.

With the network function virtualization technology, a middlebox can be deployed as software on commercial servers rather than on dedicated physical servers. A backup server is necessary to ensure the normal operation of the middlebox. The workload can affect the failure rate of backup server; the impact of workload-dependent failure rate on backup server allocation considering unavailability has not been extensively studied. This paper proposes a shared backup allocation model of middlebox with consideration of the workload-dependent failure rate of backup server. Backup resources on a backup server can be assigned to multiple functions. We observe that a function has four possible states and analyze the state transitions within the system. Through the queuing approach, we compute the probability of each function being available or unavailable for a certain assignment, and obtain the unavailability of each function. The proposed model is designed to find an assignment that minimizes the maximum unavailability among functions. We develop a simulated annealing algorithm to solve this problem. We evaluate and compare the performances of proposed and baseline models under different experimental conditions. Based on the results, we observe that, compared to the baseline model, the proposed model reduces the maximum unavailability by an average of 29% in our examined cases.

To understand the radiation mechanism of an electrically small spherical helix antenna, we develop a theory on the radiation characteristics of the antenna. An analytical model of the antenna presuming a current on the wire to be sinusoidally distributed is proposed and analyzed with the spherical wave expansion. The radiation efficiency, radiation resistance, and radiation patterns are obtained in closed-form expression. The radiation efficiency evidently varies with the surface area of the wire and the radiation resistance depends on the square of the length of the wire. The obtained result for the radiation pattern illustrates the tilt of the pattern caused by the modes asymmetric to the z-axis. The radiation efficiency formula indicates a good agreement between the simulation and measurement result. In addition, the radiation resistance of the theoretical and simulation results exhibits good agreement. Considering the effect of the feeding structure of the fabricated antenna, the radiation resistance of the analytical model can be treated as a reasonable result. The result of radiation pattern also shows good agreement between the simulation and measurement results excluding a small contribution from the feeding cable acting as a scatterer.

This paper proposes a scheme that reduces residual self-interference significantly in the analog-circuit domain on wireless full-duplex relay systems. Full-duplex relay systems utilize the same time and frequency resources for transmission and reception at the relay node to improve spectral efficiency. Our proposed scheme measures multiple responses of the feedback path by changing the direction of the main beam of the transmitter at the relay, and then selecting the optimal direction that minimizes the residual self-interference. Analytical residual self-interference is derived as the criterion to select the optimal direction. In addition, this paper considers the target of residual self-interference power before the analog-to-digital converter (ADC) dependent on the dynamic range in the analog-circuit domain. Analytical probability that the residual interference exceeds the target is derived to help in determining the number of measured responses of the feedback path. Computer simulations validate the analytical results, and show that in particular, the proposed scheme with ten candidates improves the residual self-interference by approximately 6dB at the probability of 0.01 that the residual self-interference exceeds target power compared with a conventional scheme with the feedback path modeled as Rayleigh fading.

In this paper, a metadata-based quality-estimation model is proposed for tile-based omnidirectional video streaming services, aiming to realize quality monitoring during service provision. In the tile-based omnidirectional video (ODV) streaming services, the ODV is divided into tiles, and the high-quality tiles and the low-quality tiles are distributed in accordance with the user's viewing direction. When the user changes the viewing direction, the user temporarily watches video with the low-quality tiles. In addition, the longer the time (delay time) until the high-quality tile for the new viewing direction is downloaded, the longer the viewing time of video with the low-quality tile, and thus the delay time affects quality. From the above, the video quality of the low-quality tiles and the delay time significantly impact quality, and these factors need to be considered in the quality-estimation model. We develop quality-estimation models by extending the conventional quality-estimation models for 2D adaptive streaming. We also show that the quality-estimation model using the bitrate, resolution, and frame rate of high- and low-quality tiles and that the delay time has sufficient estimation accuracy based on the results of subjective quality evaluation experiments.

Parallel line feeder (PLF) consisting of a two-wire transmission line operating in the MHz band has been proposed as a wide-coverage short-distance wireless charging. In the MHz band, a PLF of several meters suffers from standing wave effect, resulting in fluctuation in power transfer efficiency accordingly to the receiver's position. This paper studies a modified version of the system, where the PLF is divided into individually compensated segments to mitigate the standing wave effect. Modelling the PLF as a lossy transmission line, this paper theoretically shows that if the segments' lengths are properly determined, it is able to improve and stabilize the efficiency for all positions. Experimental results at 27.12 MHz confirm the theoretical analysis and show that a fairly high efficiency of 70% can be achieved.

We achieved detailed characterization of resonant tunneling chaos generator circuits in microwave frequency range. The circuit is analogous to Duffing oscillator, where the third-order nonlinear potential term is emulated by the nonlinear current-voltage curve of the resonant tunneling diode. The circuit includes a periodic reset mechanism to output identical chaos signal, which is essential to observe chaos signal on a sampling oscilloscope. Though this was shown to be effective in our previous papers, the length of the waveforms to observe is limited to rather short period, and it was unclear if this technique can be used for detailed characterization of such high-frequency chaos. In this paper, we improved the circuit design to observe longer waveforms, and demonstrated that the detailed characterization is possible using this periodic resetting technique with a sampling oscilloscope. The hybrid integration scheme is also used in this paper, which allows the easiest and shortest way to mimic a circuit as per circuit design, and precise estimation of circuit parameters aiming to eliminate circuit-related abnormalities. We provide deep insight into the dynamics associated with our circuit, starting from the single period, double period, chaos, and triple period regimes, by extracting power spectra, return maps, phase portraits, and bifurcation diagrams from acquired time series using sampling oscilloscope. Our method to study microwave chaotic signals can be applied to much higher frequency ranges, such as THz frequency range.

In this paper, the planar subarray structure to be optimized by using random search method for large active array antenna is presented. Although MPSL of the optimized subarray structure is 1.09dB higher, G/T of the optimized subarray structure is 2.07dB higher than the reference subarray structure.

In this paper, a design method for an over octave hybrid continuous mode power amplifier (PA) based on modified real frequency technique (MRFT) is proposed. The extended continuous class-F/F-1 modes greatly expand the design space, which provides the possibility of over octave design, the optimal impedances at internal current-generator (I-Gen) plane and package plane are investigated. Then a novel broadband matching network based on MRFT is presented for impedance match. To verify the proposed methodology, an over octave PA with radial stub is fabricated and measured. The PA achieves a bandwidth of 133% from 0.8GHz to 4GHz, over this frequency range, the drain efficiency is 58.3-68.7% and large-signal gain is greater than 9.6dB.

The selection of mutation strategy greatly affects the performance of differential evolution algorithm (DE). For different types of optimization problems, different mutation strategies should be selected. How to choose a suitable mutation strategy for different problems is a challenging task. To deal with this challenge, this paper proposes a novel DE algorithm based on local fitness landscape, called FLIDE. In the proposed method, fitness landscape information is obtained to guide the selection of mutation operators. In this way, different problems can be solved with proper evolutionary mechanisms. Moreover, a population adjustment method is used to balance the search ability and population diversity. On one hand, the diversity of the population in the early stage is enhanced with a relative large population. One the other hand, the computational cost is reduced in the later stage with a relative small population. The evolutionary information is utilized as much as possible to guide the search direction. The proposed method is compared with five popular algorithms on 30 test functions with different characteristics. Experimental results show that the proposed FLIDE is more effective on problems with high dimensions.

Car navigation systems provide traffic jam information. In this study, we attempt to provide more detailed traffic jam information that considers the lane in which a traffic jam is in. This makes it possible for users to avoid long waits in queued traffic going toward an unintended destination. Lane-specific traffic jam detection utilizes image processing, which incurs long processing time and high cost. To reduce these, we propose a “suddenness index (SI)” to categorize candidate areas as sudden or periodic. Sudden traffic jams are prioritized as they may lead to accidents. This technology aggregates the number of connected cars for each mesh on a map and quantifies the degree of deviation from the ordinary state. In this paper, we evaluate the proposed method using actual global positioning system (GPS) data and found that the proposed index can cover 100% of sudden lane-specific traffic jams while excluding 82.2% of traffic jam candidates. We also demonstrate the effectiveness of time savings by integrating the proposed method into a demonstration framework. In addition, we improved the proposed method's ability to automatically determine the SI threshold to select the appropriate traffic jam candidates to avoid manual parameter settings.