The physical optics (PO) approximation is one of the widely-used techniques to calculate scattering fields with a reasonable accuracy in the high frequency region. The computational load of PO radiation integral dramatically increases at higher frequencies since it is proportional to the electrical size of scatterer. In order to suppress this load, a variety of techniques, such as the asymptotic evaluation by the stationary phase method (SP), the equivalent edge currents (EECs), the low-order polynomial expansion method and the fast physical optics (FPO), have been proposed and developed. The adaptive sampling method (ASM) proposed by Burkholder is also one of the techniques where the sampling points in radiation integral should be adaptively determined based upon the phase change of integrand. We proposed a quite different approach named “Localization of the radiation integrals.” This localization method suggests that only the small portions of the integration with a slow phase change contribute to the scattering field. In this paper, we newly introduce the ASM in the localization method and applied the proposed method into the radar cross section (RCS) analysis of 2-dimensional strip and cylinder. We have confirmed that the proposed method provides the frequency-independent number of division in the radiation integrals and computational time and accuracy. As the starting point for extension to 3-D case, the application of the proposed method for a reflection from an infinite PEC plane and a part of sphere was also examined.

The reliability of electromagnetic relay (EMR) which contains a permanent magnet (PM) can be improved by a robust design method. In this parameter design process, the calculation of electromagnetic system is very important. In analytical calculation, PM is often equivalent to a lumped parameter model of one magnetic resistance and one magnetic potential, but significant error is often caused; in order to increase the accuracy, a distributed parameter calculation model (DPM) of PM bar is established; solution procedure as well as verification condition of this model is given; by a case study of the single PM bar, magnetic field lines division method is adopted to build the DPM, the starting point and section magnetic flux of each segment are solved, a comparison is made with finite element method (FEM) and measured data; the accuracy of this magnetic field line based distributed parameter model (MFDPM) in PM bar is verified; this model is applied to the electromagnetic system of a certain type EMR, electromagnetic system calculation model is established based on MFDPM, and the static force is calculated under different rotation angles; compared with traditional lumped parameter model and FEM, it proves to be of acceptable calculation accuracy and high calculation speed which fit the requirement of robust design.

The effective permittivity of the two-dimensional multilayered periodic structures which consist of the rectangular dielectric cylinders is examined numerically. The original periodic structure is replaced with a simple structure such as the dielectric slab. By using the reflectance of the periodic structure obtained by the FDTD method, the effective permittivity of the dielectric slab, which has the same reflectance as that of the periodic structure, is obtained by using the transcendental equation. In order to reduce the procedure to obtain the reflectance from the multilayered periodic structures, the reflectance from one-layered structure is used. The range of the application and validity of this procedure is examined.

A 1-mm-diameter fiber-optic photoreceiver with a side-surface interface is proposed. By controlling the scattering part embedded in the fiber, the receiving sensitivity along the fiber's axis is successfully flattened over a 5-m-length. The simulation results suggest a potential for a large-area photo-detector of ∼ 3-m-spherical diameter.

In this paper, we propose a new design technique called asynchronous multi-frequency clocking for suppressing EMI at a chip design level by combining two independent EMI-suppressing approaches: multi-frequency clocking and asynchronous circuit design techniques. To show the effectiveness of our approach, a five-stage pipelined asynchronous MIPS with multi-frequency clocking has been implemented on a commercial Xilinx FPGA device. Our approach shows 11.05 dB and 5.88 dB reductions of peak EM radiation in the prototyped implementation when compared to conventional synchronous and bundled-data asynchronous circuit counterparts, respectively.