It is well known that the problem to solve a set of randomly chosen multivariate quadratic equations over a finite field is NP-hard. However, when the number of variables is much larger than the number of equations, it is not necessarily difficult to solve equations. In fact, when n ≥ m(m+1) (n,m are the numbers of variables and equations respectively) and the field is of even characteristic, there is an algorithm to find one of solutions of equations in polynomial time (see [Kipnis et al., Eurocrypt '99] and also [Courtois et al., PKC '02]). In the present paper, we propose two new algorithms to find one of solutions of quadratic equations; one is for the case of n ≥ (about) m2-2m 3/2+2m and the other is for the case of n ≥ m(m+1)/2+1. The first one finds one of solutions of equations over any finite field in polynomial time, and the second does with O(2m) or O(3m) operations. As an application, we also propose an attack to UOV with the parameters given in 2003.

In this paper, Digital Low Dropout Regulator (LDO) is proposed to provide the low noise and tunable power supply voltage to the 0.5-V near-threshold logic circuits. Because the conventional LDO feedback-controlled by the operational amplifier fail to operate at 0.5 V, the digital LDO eliminates all analog circuits and is controlled by digital circuits, which enables the 0.5-V operation. The developed digital LDO in 65 nm CMOS achieved the 0.5-V input voltage and 0.45-V output voltage with 98.7% current efficiency and 2.7-µA quiescent current at 200-µA load current. Both the input voltage and the quiescent current are the lowest values in the published LDO's, which indicates the good energy efficiency of the digital LDO at 0.5-V operation.

We propose a new cone-type DRAM cell as a 1T DRAM cell. The superiority of cone shape is already reported, in that the electric field concentration effect encourages impact ionization phenomenon. So the device has improved DRAM characteristics compared with cylinder type 1T DRAM Cell (SGVC Cell). To confirm the memory operation of the cone-type DRAM cell, simulation works were carried out. Also, retention characteristic shows the device can be used practically.

Navigation systems providing route-guidance and traffic information are one of the most widely used driver-support systems these days. Most navigation systems are based on the map paradigm which plots the driving route in an abstracted version of a two-dimensional electronic map. Recently, a new navigation paradigm was introduced that is based on the augmented reality (AR) paradigm which displays the driving route by superimposing virtual objects on the real scene. These two paradigms have their own innate characteristics from the point of human cognition, and so complement each other rather than compete with each other. Regardless of the paradigm, the role of any navigation system is to support the driver in achieving his driving goals. The objective of this work is to investigate how these map and AR navigation paradigms impact the achievement of the driving goals: productivity and safety. We performed comparative experiments using a driving simulator and computers with 38 subjects. For the effects on productivity, driver's performance on three levels (control level, tactical level, and strategic level) of driving tasks was measured for each map and AR navigation condition. For the effects on safety, driver's situation awareness of safety-related events on the road was measured. To find how these navigation paradigms impose visual cognitive workload on driver, we tracked driver's eye movements. As a special factor of driving performance, route decision making at the complex decision points such as junction, overpass, and underpass was investigated additionally. Participant's subjective workload was assessed using the Driving Activity Load Index (DALI). Results indicated that there was little difference between the two navigation paradigms on driving performance. AR navigation attracted driver's visual attention more frequently than map navigation and then reduces awareness of and proper action for the safety-related events. AR navigation was faster and better to support route decision making at the complex decision points. According to the subjective workload assessment, AR navigation was visually and temporally more demanding.

Several kinds of capacitor-less DRAM cells based on planar SOI-MOSFET technology have been proposed and researched to overcome the integration limit of the conventional DRAM. In this paper, we propose the Floating Body type DRAM cell array architecture with the Vertical MOSFET and discuss its basic operation using a 3-D device simulator. In contrast to previous planar SOI-MOSFET technology, the Floating Body type DRAM with the Vertical MOSFET achieves a cell area of 4F2 and obtain its floating body cell by isolating the body from the substrate vertically by the bottom-electrode. Therefore, the necessity for a SOI substrate is eliminated. In this paper, the cell array architecture of Floating Body type 1T-DRAM is proposed, and furthermore, the basic memory operations of read, write, and erase for Vertical type 1 transistor (1T) DRAM in the 45 nm technology node are shown. In addition, the retention and disturb characteristics of the Vertical type 1T-DRAM are discussed.

In this paper, we propose a reduced complexity algorithm for blind frame synchronization based on code-constraints in a quasi-cyclic low density parity check (QC-LDPC) coded system. It can be used for both hard and soft synchronizers. For soft synchronizers, we present a modified algorithm that achieves better performance at high signal to noise ratio (SNR). Analysis indicates that the proposed algorithm has low complexity for hardware implementation.

Dicode partial response signaling system over inductively-coupled channel has been developed to achieve higher data rate than self-resonant frequencies of inductors. The developed system operates at five times higher data rates than conventional systems with the same inductor. A current-mode equalization in the transmitter designed in a 90-nm CMOS successfully reshapes waveforms to obtain dicode signals at the receiver. For a 5-Gb/s signaling through the coupled inductors with a 120-µm diameter and a 120-µm distance, 20-mV eye opening was observed. The power consumption value of the transmitter was 58 mW at the 5-Gb/s operation.

We propose a compact matrix-switch-based hierarchical optical cross-connect (HOXC) architecture that effectively handles the colorless waveband add/drop ratio restriction so as to realize switch scale reduction. In order to implement the colorless waveband add/drop function, we develop a wavelength MUX/DMUX that can be commonly used by different wavebands. We prove that the switch scale of the proposed HOXC is much smaller than that of conventional single-layer optical cross-connects (OXCs) and a typical HOXC. Furthermore, we introduce a prototype system based on the proposed architecture that utilizes integrated novel wavelength MUXs/DMUXs. Transmission experiments prove its technical feasibility.

This paper presents an improvement of the memory cell reliability by the memory cell VTH optimization of the ferroelectric (Fe)-NAND flash memory. The effects of the memory cell VTH on the reliability of the Fe-NAND flash memory are experimentally analyzed for the first time. The reliability is evaluated by the measured VTH shift due to the read disturb, program disturb and data retention. Three types of Fe-NAND flash memory cells, a positive, zero and negative VTH memory cell, are defined on the basis of the memory cell VTH. The middle of VTH of programmed and erased states is 1 V, 0 V and -0.3 V in a positive, zero and negative VTH memory cell, respectively. The VTH shift of the positive, zero and negative VTH memory cells show similar characteristics in the program/erase and the VPASS and VPGM disturbs because the external electric field is so high that the internal depolarization field does not affect the VTH shift. On the other hand, in the data retention, the VTH shift of the three types of VTH memory cells show different characteristics. The reliability of the Fe-NAND flash memory is best optimized in the zero VTH memory cell. In the proposed zero VTH Fe-NAND flash memory cell scheme, the measured VTH shift due to the read disturb, program disturb and data retention decreases by 32%, 24% and 10%, respectively, compared with conventional positive VTH Fe-NAND flash memory cell scheme. Contrarily, in the negative VTH memory cell, the VTH shift during the data retention is 0.49 V and unacceptably large because of the depolarization field. The conventional positive VTH memory cell suffers from a sever read and program disturb. The measured results are drastically different from those of the conventional floating-gate NAND flash memory cell where the negative VTH memory cell is most suitable in terms of the reliability.

In nearest neighbor distance ratio (NNDR) matching the fixed distance ratio threshold sometimes results in an insufficient number of inliers or a huge number of outliers, which is not good for robust tracking. In this letter, we propose adjusting the distance ratio threshold based on maximizing the number of inliers while maintaining the ratio of the number of outliers to that of inliers. By applying the proposed method to a model-based camera tracking system, its effectiveness is verified.

Power-aware X-filling is a preferable approach to avoiding IR-drop-induced yield loss in at-speed scan testing. However, the ability of previous X-filling methods to reduce launch switching activity may be unsatisfactory, due to low effect (insufficient and global-only reduction) and/or low scalability (long CPU time). This paper addresses this reduction quality problem with a novel GA (Genetic Algorithm) based X-filling method, called GA-fill. Its goals are (1) to achieve both effectiveness and scalability in a more balanced manner and (2) to make the reduction effect of launch switching activity more concentrated on critical areas that have higher impact on IR-drop-induced yield loss. Evaluation experiments are being conducted on both benchmark and industrial circuits, and the results have demonstrated the usefulness of GA-fill.

In this paper, we propose a full-duplex relay (FDR) based on a zero-forcing beamforming (ZFBF) for a multiuser MIMO system. The ZFBF is employed at the base station to suppress both the self-interference of the relay and the multiuser interference at the same time. Numerical results show that the proposed FDR can enhance the sum rate performance as compared to the half-duplex relay (HDR), if sufficient isolation between the transmit and receive antennas is ensured at the relay.

The separation and localization of sound source signals are important techniques for many applications, such as highly realistic communication and speech recognition systems. These systems are expected to work without such prior information as the number of sound sources and the environmental conditions. In this paper, we developed a dodecahedral microphone array and proposed a novel separation method with our developed device. This method refers to human sound localization cues and uses acoustical characteristics obtained by the shape of the dodecahedral microphone array. Moreover, this method includes an estimation method of the number of sound sources that can operate without prior information. The sound source separation performances were evaluated under simulated and actual reverberant conditions, and the results were compared with the conventional method. The experimental results showed that our separation performance outperformed the conventional method.

Based on the known quadriphase zero correlation zone (ZCZ) sequences ZCZ4(N,M,T), four families of 16-QAM sequences with ZCZ are presented, where the term "QAM sequences" means the sequences over the quadrature amplitude modulation (QAM) constellation. When the quadriphase ZCZ sequences employed by this letter arrive at the theoretical bound on the ZCZ sequences, and are of the even family size M or the odd width T of ZCZ, two of the resulting four 16-QAM sequence sets satisfy the bound referred to above. The proposed sequences can be potentially applied to communication systems using 16-QAM constellation as spreading sequences so that the multiple access interference (MAI) and multi-path interference (MPI) are removed synchronously.

In this paper, we propose a coding algorithm for High Dynamic Range Images (HDRI). Our encoder applies a tone mapping model based on scaled µ-Law encoding, followed by a conventional Low Dynamic Range Image (LDRI) encoder. The tone mapping model is designed to minimize the difference between the tone-mapped HDRI and its LDR version. By virtue of the nature of the µ-Law model, not only the quality of the HDRI but also the one of the LDRI is improved, compared with a state of the art in conventional HDRI coding methods. Furthermore the error limit caused by our encoding is theoretically analyzed.

This paper presents a framework of supporting system for a drug formulation. We designed ontology to represent the related knowledge for reusable and sharing purposes. The designed ontology is applied with operation rules to suggest an appropriate generic drug production based on information of original drug. The system also provides a validation module to preliminarily approve a pharmaceutical equivalence of the suggested result. Preliminary testing with four random samples shows potential to reformulate a generic product by returning a satisfactory and acceptable of the system suggestions for all samples.

Metadata registry (MDR) is based on the international standard ISO/IEC 11179. The committee of ISO/IEC JTC 1/SC 32, which had standardized the MDR, has started to improvise the MDR, and the improvised version is named extended MDR (XMDR). However, the XMDR does not fully support the ontology concept, and no method is available for mapping ontology registrations onto registries. To overcome the limitations of the outdated XMDR, this paper proposes an extended XMDR (XMDR+) framework. The XMDR+ framework provides a method for mapping of ontology registrations between the metadata registry and ontologies. To improve the functions of the XMDR, we have proposed herein a framework that is capable of defining a model that manages the relations not only among ontological concepts but also among instances, and guarantees the management and storage of their relationships for supporting valid relations of the ontologies.

AC-waveform synthesis with quantum-mechanical accuracy has been attracting many researchers, especially metrologists in national metrology institutes, not only for its scientific interest but its potential benefit to industries. We describe the current status at National Metrology Institute of Japan of development of a Josephson arbitrary waveform synthesizer based on programmable and pulse-driven Josephson junction arrays.

A broadband balanced frequency doubler has been demonstrated in 0.25-µm SOI SiGe BiCMOS technology to operate from 22 GHz to 30 GHz. The measured fundamental frequency suppression of greater than 30 dBc is achieved by an internal low pass LC filter. In addition, a pair of matching circuits in parallel with the LO inputs results in high suppression with low input drive power. Maximum measured conversion gain of -6 dB is obtained at the input drive power as low as -1 dBm. The results presented indicate that the proposed frequency doubler can operate in broadband and achieve high fundamental frequency suppression with low input drive power.

To meet the increasing demand to expand wavelength division multiplexing (WDM) transmission capacity, ultrahigh spectral density coherent optical transmission employing multi-level modulation formats has attracted a lot of attention. In particular, ultrahigh multi-level quadrature amplitude modulation (QAM) has an enormous advantage as regards expanding the spectral efficiency to 10 bit/s/Hz and even approaching the Shannon limit. We describe fundamental technologies for ultrahigh spectral density coherent QAM transmission and present experimental results on polarization-multiplexed 256 QAM coherent optical transmission using heterodyne and homodyne detection with a frequency-stabilized laser and an optical phase-locked loop technique. In this experiment, Raman amplifiers are newly adopted to decrease the signal power, which can reduce the fiber nonlinearity. As a result, the power penalty was reduced from 5.3 to 2.0 dB. A 64 Gbit/s data signal is successfully transmitted over 160 km with an optical bandwidth of 5.4 GHz.